ignition Seat Leon 2020 User Guide
[x] Cancel search | Manufacturer: SEAT, Model Year: 2020, Model line: Leon, Model: Seat Leon 2020Pages: 399, PDF Size: 6.24 MB
Page 238 of 399

Driving
Steering Inf ormation r
elating to different ve-
hicle processes. Electro-mechanical power steering adapts
el
ectr
onically to the speed of the car, torque
and steering angle.
Even if the power steering fails or the engine
is stopped, it is possible to continue to rotate
the steering wheel as long as the key remains
in the ignition, but more force must be ap-
plied.
Progressive steering
Depending on the vehicle’s features, it may or
may not incorporate a progressive steering
system.
In city traffic you do not need to turn so much
on parking, manoeuvring or in very tight turns.
On the road or on the motorway, progressive
steering transmits, for example, in bends, a
sportier, more direct and noticeably more dy-
namic driving sensation. Control lamp v
It lights up red
Faulty steering.
Do not continue driving, stop the v
ehicle as soon as
possible and in a safe manner.
Take the vehicle to a specialised workshop and have
the fault repaired as soon as possible. v
It lights up yellow
Limited steering operation.
Driv e car
efully to a specialised workshop to have the
steering checked.
If the warning light does not come on again after re-
starting the engine and driving a short distance, it is
not necessary to check the steering.
OR: The 12-v olt batt
ery was disconnected and re-
connected.
Drive a short distance at 15-20 km / h (9-12 mph). v
It flashes yellow
The steering column is jammed.
When st opped, t
urn the steering wheel in both direc-
tions.
OR: The st eering column does not unlock or lock.
T
urn off the ignition and turn it on again. Consider the
messages shown on the instrument panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance. The control lamp should light up for a few
seconds when the ignition is s
wit
ched on. It
should go out once the engine is started. WARNING
Never ignore the warning lamps or messag-
es.
Page 255 of 399

Driver assistance systems
Activate or deactivate the dodge and turn
assist ant
The dodge and t
urn assistance systems can
be activated or deactivated in the infotain-
ment system using the function button > Driver assistance > Front Assist
››› page 96.
The system will store the setting for the next
time the ignition is switched on.
SEAT recommends having the dodge and
turn assistance systems activated except in
the exceptions described in section
››› page 253.
Deactivating Front Assist temporarily in
the following situations
In the following situations the Front Assist
should be deactivated due to the system's
limitations:
Page 274 of 399

Driving
system itself, the rear and side environment of
the v ehicl
e using the rear sensors
››› page 242. It detects moving objects that
approach from behind, such as cars
››› Fig. 193.
If a critical situation is detected when the
door is opened, it will be alerted by an acous-
tic signal on the door speaker of the corre-
sponding side ››› Fig. 194
. Additionally, the
control lamp of the lane departure warning of
the corresponding door will flash. If the door
has already been opened and another road
user has been detected in a critical situation,
the control lamp of the lane departure warn-
ing on the corresponding side will light up
permanently.
The brightness of the door opening warning
indication cannot be adjusted.
When you want to access the vehicle for the
first time, with the doors closed and locked,
the function will be available 3 minutes after
the first opening of any of the doors. The
function will continue to be available as long
as the vehicle has the ignition connected and
is not moving.
After switching off the ignition, the function
will remain available for approximately 3 mi-
nutes. After that time, the control lamps will
light up indicating the deactivation of the
function. WARNING
Page 280 of 399

Driving
ignition, the function will remain on the next
time the ignition is s wit
ched on.
If the Auto Hold function was not switched on,
it will automatically remain off next time the
ignition is engaged.
The Auto Hold function connects automat-
ically if the following conditions are met
(all points must be met at the same time
››› ):
The v ehicl
e is kept stationary with the
brake pedal on a flat surface or on a
slope.
The engine rotates “correctly”.
The Auto Hold function is automatically
turned off if the following conditions are
met: If any of the conditions mentioned on
››› page 277, Conditions for keeping
the vehicle stationary with the Au-
to Hold function are no longer met.
If the engine is running irregularly or an
anomaly is detected.
If the engine stalls.
Manual gearbox: The clutch and the ac-
celerator are pressed at the same time.
Automatic gearbox: If the accelerator is
pressed
Automatic gearbox: If any of the tyres
has only minimal contact with the
1.
2.
1.
2.
3.
4.
5. ground, e.g. in the case of axle articula-
tion. WARNING
The smart technology incorporated into
the Aut o Hol
d function cannot defy the
laws of physics; it only works within the lim-
its of the system. The greater convenience
provided by the Auto Hold function should
never tempt you to take any risk that may
compromise safety.
Page 295 of 399

Help with parking and manoeuvring
Visual indication segments Fig. 203
Parking aid view on the Infotainment
syst em displ
ay. The optical indication of the segments works
as f
oll
ows:
Grey segments: the obstacle is more
than approx. 30 cm away from the path
or in the direction opposite to travel.
They are also displayed when the elec-
tronic parking brake is activated.
Yellow segments: the obstacles lie on
the vehicle’s path and are at a distance
of less than approx. 30 cm away.
Red segments: obstacles are less than
approx. 30 cm away.
A wake will indicate the anticipated forward
or backward trajectory, depending on the en-
gaged gear. –
–
– If an obstacle is located in the vehicle’s way,
the corresponding audibl
e warning will
sound.
When the penultimate segment is displayed,
the vehicle has reached the collision zone. In
the collision zone, the obstacles are repre-
sented in red (including those out of the
path). Stop the vehicle! ››› in Introduction
on page 290, ››
› in Introduction on
page 290 !
Setting the indications and audio
signal s The indications and acoustic signals are set
in the Inf
ot
ainment system: function button
> Driver assistance> Parking aid: Setup
Automatic activa-
tion On/off
Front volume* Volume in the front and rear
area.
R
ear volume* Volume in the rear area.
Adjust volume When the parking aid is
s
wit
ched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option. Error messages
If a an error or fault message appears on the
instrument clust
er in P
ark Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
the areas A and
B are displayed
› ›
› Fig. 202. If a front sensor is faulty, only the
obstacles in the areas C and
D will be dis-
pl ayed. Symbol