heater Seat Tarraco 2020 Owner's manual

Self-help
Jump start: description Fig. 43
Diagram of connections for vehicles
without St art
-Stop system. Fig. 44
Diagram of connections for vehicles
with St art

-Stop system. Jump lead terminal connections
Swit

ch off the ignition of both vehicles
››› .
1. Connect one end of the r
ed

jump lead to
the positive + terminal of the vehicle
with the fl at batt
ery A
› ›
› Fig. 43
.
Connect the other end of the red jump
lead to the positive terminal + in the ve-
hicl e pr

oviding assistance B .
In v ehicl
es without a Start-Stop system:
connect one end of the black jump lead
to the negative terminal – of the vehicle
pr o

viding the current B
› ›
› Fig. 43
.
In vehicles with a Start-stop system:
connect one end of the black jump lead X to a suitable ground terminal, to a sol-
id piece of met al in the engine bl

ock, or
to the engine block itself ››› Fig. 44
.
Connect the other end of the black jump
lead X to a solid metal component bol-
t ed t

o the engine block or to the engine
block itself of the vehicle with the flat
battery. Do not connect it to a point near
the battery A .
P osition the l

eads in such a way that
they cannot come into contact with any
moving parts in the engine compart-
ment.
Starting Start the engine of the vehicle with the
boosting battery and let it run at idling
speed.
2.
3.
4a.
4b.
5.
6.
7.
Start the engine of the vehicle with the
flat batt

ery and wait for 2 or 3 minutes
until the engine is running.
Removing the jump leads Before you remove the jump leads,
switch off the dipped beam headlights if
they are switched on.
Turn on the heater blower and heated
rear window in the vehicle with the flat
battery. This helps minimise voltage
peaks which are generated when the
leads are disconnected.
When the engine is running, disconnect
the leads in reverse order to the details
given above.
Make sure the battery clamps have sufficient
metal-to-metal contact with the battery ter-
minals.
If the engine fails to start after about 10 sec-
onds, switch off the starter and try again after
about 1 minute. WARNING

Air conditioning
must not be blocked by snow, mud or any-
thing el se
. WARNING
The auxiliary heater exhaust fumes contain
carbon mono xide

, an odourless and colour-
less toxic gas. Carbon monoxide can cause
people to lose consciousness. It can also
cause death.

Air conditioning
and colourless toxic gas. Carbon monoxide
can cause peopl
e t
o lose consciousness. It
can also cause death. Radio-operated remote control
Fig. 152
Auxiliary heating: radio-operated re-
mot e contr

ol. Switch on: Pr
ess the butt

on for about
one second
Switch off: Press the button for about
one second
If the buttons of the remote control are press-
ed unnecessarily, it could switch on the auxili-
ary heater involuntarily, even when it is out of
range or when the control lamp is flashing. 
 Remote control LED
When the buttons ar

e pressed, the LED of re-
mote control ››› Fig. 152
2 gives the user a
r ange of inf

ormation:
It lights up for approx. 2 seconds