phone SKODA FABIA 2007 1.G / 6Y SymphonyCD Car Radio Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2007, Model line: FABIA, Model: SKODA FABIA 2007 1.G / 6YPages: 22, PDF Size: 3.5 MB
Page 6 of 22
GB
General functions
Turning on and off
By pressing the button you switch the
radio on and off. When switched on, the
appliance assumes the parameters last
heard for treble, bass, balance etc. Only the
radio volume may be reduced to the
maximum volume in the set-up menu when
the radio is turned on.
V olume control
When on, the on / off button sticks out of
the front, which makes it possible to set the
volume.
T urn the button to the right or left to set
the required volume.
Setting the sound
Y ou can set the sound tone of the radio to
suit your requirements. Please note that
the radio receiver, CD player, CD changer,
TIM playback and telephone allow sepa-
rate settings and storing.
Proceed as follows:
Bass setting:
• Press the AUDbutton
. The indication
BASS appears in the display with the
current scale value.
• Use the control
to set the required
bass setting from -9 to +9.
T reble setting:
• Press the AUDbutton
(if you wish to
select treble regulation from normal op-
eration, press button
twice to go to the
treble setting. The indication TRE
appears in the display with the current
scale value.
• Use the control
to set the required
treble setting from -9to +9.
5 seconds after the last setting or when
the button
is pressed again, the car
radio switches back to normal operation
and stores the set values.
Geometry (balance and fader)
Y ou can set the geometry of the sound tone
to suit your requirements.
Proceed as follows:
Balance:
• Press the GEObutton .
The indication BAL appears in the display
with the current scale value.
• Use the control to set the required
balance setting from LEFT 9 via CENTER
to RIGHT 9.
Fader:
• By pressing the GEO button again (if
you wish to select fader control from nor-
mal operation, you must press button
twice), you go to fader control. The indica-
tion FA D appears in the display with the
current scale value.
• Use the control to set the required fader
setting from REAR 9 via CENTER to
FRONT 9.
5 seconds after the last setting or when
the button
is pressed again, the car
radio switches over automatically to normal
operation and stores the set values.
5
T urning on and off Sound setting Geometry
V olume control
132
3. Bed. Anl. Skoda Radio Engl. 13.12.2004 14:20 Uhr Seite 5
Page 13 of 22
Set-up menu
By depressing the TPbutton for a few
moments, you can enter the set-up
menu. This is for special settings, as for
example operating the car radio in
connection with a telephone.
The individual menu points are selected
by pressing the TP button or the con-
trol button , . Changes in the
menu points are registered
acoustically by a signal tone unless you
have turned this function off in the set-up
menu.
Alterations in the menu point are made
with the aid of the turning knob and
stored when changing to the next menu
point. By depressing the TP
button for a few
moments, you can leave the set-up menu
without saving the alteration in the last
menu point.
Caution:
Changes in the set-up menu affect
the general mode of operation of
your car radio and for safety rea-
sons should only be made when
the vehicle is stationary!!!
The following functions can be set in the
set-up menu:
• GALA speed-dependent volume adjustment
• ON VOL maximum volume when on
• LED Warning LED on / off
• BEEP Beep tone on / off
• AUTO REG Regional stations on / off
• M/S Music / Speech
changeover • PHONE IN utilisation of the tele-
phone entry
• PH VOL volume of telephone call
• TA VOL minimum volume of traffic announce-
ments
• CD SFL random playback for CD changer
• KEY ignition key logic
• LOUD loudness off / on
• MONO compulsory mono
• LOCAL local / remote recep- tion for search
12
5
6
FM1 4
TP
1
3. Bed. Anl. Skoda Radio Engl. 13.12.2004 14:20 Uhr Seite 12
Page 15 of 22
Set-up menu
AUTO-REG / REG OFF
In this menu point you can set the switch-
over to alternative frequencies of regional
stations. The setting causes the following
function:
If during the drive the quality of the recep-
tion of the set program gets worse, your
radio first sets alternative frequencies only
of the program you are currently listening
to.
If there is a risk of "station loss”, your
appliance will resort to frequencies of a
related program.
For example the 1st station of NDR
Schleswig Holstein (NDR 1 SH), Hamburg
(NDR 1 HH) and Lower Saxony (NDR 1,
NDS) with regional programmes of differ-
ent content.
As these programs sometimes transmit
different regional programs, a change of
frequency may change the radio program.
With the "AUTO-REG” function, (autono-
mous regional programs) there is only a
switchover to regional programs in an
emergency.
The "REG OFF" setting allows unlimited
switching between "related” regional pro-
grams. • Select
AUTO-REG / REG OFF in the
menu. The current value "AUTO-REG /
REG OFF" is shown in the display.
• Use the turning knob to set AUTO-
REG or REG OFF.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TPbutton for a few
moments, you can leave the set-up
menu without storing this change.
M/S
With the aid of this function, you can set
whether or not there should be an auto-
matic switchover between optimum repro-
duction for music and speech with the aid
of the RDS Signal.
• Select M/Sin the menu. The display
shows "M/S” with the current value.
• Set ONor OFF with the aid of the turn-
ing knob¨.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or • by depressing the
TPbutton for a few
moments, you can leave the set-up
menu without storing this change.
PHONE
Enter this menu point if your vehicle is
equipped with a telephone and modify the
radio functions under this menu point to
suit your telephone as in the following.
no: No telephone fitted into the vehicle.
ON: There is a telephone fitted into the
vehicle. With this setting, the radio is
muted when the telephone is activa-
ted by a telephone call or when dial-
led.
in: The built-in telephone is connected to
the radio by means of a corresponding
hands-free speaking unit, so that the
person calling/called can be heard
through the car speakers.
• Select PHONE in the menu. The display
shows "PHONE” with the current value.
• Use the turning knob to set the
appropriate function.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point.
14
3. Bed. Anl. Skoda Radio Engl. 13.12.2004 14:20 Uhr Seite 14
Page 16 of 22
Set-up menu
or
• by depressing the TPbutton for a few
moments, you can leave the set-up
menu without storing this change.
PH VOL
If the telephone call is transmitted through
the speakers in your vehicles, you can set
the playback volume under this menu
point.
• Select PH VOL in the menu. The display
shows "PH VOL” with the current value.
• Use the turning knob to set the de-
sired value from 1 to 45.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TPbutton for a few
moments, you can leave the set-up
menu without storing this change. TA
VOL
This menu point is for setting the minimum
volume for radio traffic service announce-
ments. In TP operation, the volume can be
raised to the set value if necessary. This
means you can drive with the radio set
low and still be informed about the current
traffic situation.
• Select TAVOL in the menu. The display
shows "TA VOL” with the current value.
• Use the turning knob to set the de-
sired value from 1 to 9.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TPbutton for a few
moments, you can leave the set-up
menu without storing this change.
CD SFL
Decide in this menu point whether the ti-
tles should be selected with random play-
back (shuffle) from a connected CD
changer only within one CD (CD SFL D )
or the whole magazine ( CD SFL M).
• Select CD SFL in the menu. The display
shows "CD SFL” with the current value. • Use the turning knob
to set the de-
sired value of D or M.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or
• by depressing the TPbutton for a few
moments, you can leave the set-up
menu without storing this change.
KEY
This menu point is for setting whether the
radio should be turned off too when the
ignition key is taken out (KEY ON) or
whether the radio should be turned on and
off exclusively with the pushbutton
(KEY OFF).
• Select KEYin the menu. The display
shows "KEY” with the current value.
• Use the turning knob to set ON or
OFF.
• By briefly pressing the TPbutton or
the control button , you can store
the indicated value and go to the next
menu point
or
15
GB
3. Bed. Anl. Skoda Radio Engl. 13.12.2004 14:20 Uhr Seite 15
Page 20 of 22
Brief technical description
Brief technical description
General
Connections
Active antenna, mobile telephone, CD
changer, external final stage
Displays
Wavelength range, station name, fre-
quency, station button, Traffic Program
(TP), CD title number display
Illumination
Operating elements and display are illu-
minated without glare when the vehicle
illumination is switched on (night design).
The degree of brightness is adjustable
with the instrument illumination.
Theft protection
Electronic barrier in the appliance. If the
appliance is fitted into another vehicle, it
can only operate if the right code number
is entered.
Interference suppression
Specifically co-ordinated interference
suppression removes to a large extent all
interfering pulses from the engine and
from other parts in the electrical system,
e.g. heating fans, windscreen wipers,
cooling ventilators etc
Radio
Reception ranges
FM (UKW/VHF), AM, (MW and LW)
Program selection
Automatic broadcast of the program set
before turning off (Last Station Memory)
in radio operation.
Six station buttons in each case for
AM 1, AM 2, FM 1, FM 2 and TP. Manual
adjustment up and down, PLL Tuning
(PLL = Phase-Locked Loop).
After switching on the radio, the last
received program is set again (Last
Station Memory).
Radio traffic service unit
Automatic station scan
Automatic announcements
TIM (recording of traffic announcements),
TIM standby mode for 2 or 24 hours.
CD drive and CD changer control
T itle selection, random playback, auto-
matic stop and radio switchover with traf-
fic announcements, CD selection in the
changer operation.
Audio
maximum output power
4 x 20 Watts
Playback
Stereo (radio and CD), active sound
regulation, loudness, fader integrated in
the radio.
Alterations and misprints excepted.
May not be reprinted, copied or transla-
ted without ·koda Auto a.s. prior authori-
sation.
19
GB
3. Bed. Anl. Skoda Radio Engl. 13.12.2004 14:20 Uhr Seite 19