radio SKODA OCTAVIA 1997 1.G / (1U) 1.8 92kw Engine Workshop Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 1997, Model line: OCTAVIA, Model: SKODA OCTAVIA 1997 1.G / (1U)Pages: 136, PDF Size: 8.27 MB
Page 121 of 136
Downloaded from www.Manualslib.com manuals search engine Fuel Supply System20
Edition 08.96
Removing and installing fuel delivery unit
Pay attention to safety precautions ⇒
page 20-4.
Pay attention to rules for cleanliness ⇒ page
20-4. Special tools, testers and aids required♦ Wrench for union nut MP 1-227
Removing
- If car is fitted with a coded radio set, deter- mine coding, if necessary.
- Switch off ignition (if not already off) and dis- connect earth strap at the battery.
- Unbolt cover (below the rear seat).
- Disconnect feed and return flow pipes from the flange of the fuel delivery unit (press release buttons).
- Release 4-pin connector from the flange at the fuel tank and unplug.
- Use wrench MP 1-227 to unscrew union nut.
- Pull fuel delivery unit and seal out of the
opening of the fuel tank.
Note:
If the delivery unit is still filled with fuel, emptybefore replacing.
Installing Installation is performed in the reverse order; pay attention to the following points:
Notes:
♦When inserting the fuel delivery unit, ensure
that the fuel gauge sender is not bent.
♦Moisten seal of the flange with fuel beforeinstalling.
♦Ensure the fuel hoses are tightly connected.
Page 123 of 136
Downloaded from www.Manualslib.com manuals search engine Fuel Supply System20
Edition 08.96
Removing
- If car is fitted with a coded radio set, pay attention to coding; determine if necessary.
- Switch off ignition (if not already off), and disconnect earth strap at the battery.
- Empty fuel tank with fuel extraction unit (e.g. V.A.G 1433 A).
- Remove rear suspension: ⇒ Running Gear; Repair Group 42; Servicing rear suspension; Removing and installing rear suspension.
- Unbolt cover (below the rear seat).
- Release 4-pin connector from the flange at fuel tank and unplug.
- Open fuel filler flap and lever out tensioning ring in rubber bowl (around filler neck).
- Push rubber bowl through to the inside.
- Remove rear right wheelhouse liner.
- Unscrew fuel filler neck below the wheel- house liner.
- Remove cover below the fuel tank -arrows-
(if fitted).
- Disconnect return flow pipe -2- (blue), feed
pipe -1- (black) and breather pipe -3- (white) at the front right of the fuel tank (press release buttons).
- Place engine/gearbox jack (e.g. V.A.G 1383 A) below the fuel tank to support it.