display SKODA OCTAVIA 2005 1.G / (1U) Nexus Navigation System Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2005, Model line: OCTAVIA, Model: SKODA OCTAVIA 2005 1.G / (1U)Pages: 52, PDF Size: 1.83 MB
Page 39 of 52

Navigation37
Position display
The current information on the position of the vehicle is
shown here.
GPS status (number of satellite receptions, positioning mode)
including the direction and distance to destination (with active route
guidance).
Direction of travel
Altitude (GPS altitude). If too few satellites are received to calculate
the altitude, the display is green.
v
GPS position (longitude)
GPS position (latitude)
The direction of travel is shown in degrees and also in the form of a
compass.
The GPS status shows the number of satellites as dots and also shows
the positioning mode (NO FIX, 2D FIX, 3D FIX).
x
NO FIX – The GPS reception is not sufficient to fix the position of the
vehicle.
x
If the position definition for NO FIX is only possible using the wheel
sensors (underground garage etc), the GPS coordinates will be displayed
in green. The GPS coordinates will no longer be shown following a long
distance with NO FIX in the display or if it is not possible to determine the
position.
x
2D FIX – The horizontal position of the vehicle can be determined, but
not the altitude (altitude display is green).
x
3D FIX – Position and altitude can be determined.
The altitude given is accurate to r15 m at altitudes between 0 m and
+5000m. The system will be less accurate if the GPS reception is bad or
weather conditions are poor.
The direction to the destination is shown in the form of a marking outside
the compass. If the destination is not in the area displayed by the compass
(i.e. to the side or behind the vehicle), the marking is shown as an arrow
to the side in question.
Position displ. back with ESC
Compass
A
B
C
Bra-0105
Fig. 45 Position
display
AAABAC
sao.book Seite 37 Montag, 22. M‰
rz 2004 9:32 09
Page 40 of 52

Navigation
38Route guidanceStarting/stopping route guidance– Press . You will hear an announcement that the
route is being calculated. The radio navigation system will
automatically switch to the map display.
– Press the button to return to the Navigation main menu.
– Press if you wish to stop the route guidance
function before you have reached your destination.The route guidance function can only be started if you have already
entered a destination.
Note
x
You should drive on a bit further if the system makes the announce-
ment that you are not on a digitalised street before starting route guidance.
The unit might have to orientate itself using the next main road.
x
The active route guidance function will be interrupted if a stopover
destination is entered.
Route opt.Destination
Stopover
Set-up
Stop route gd.
Exhibition centre Destination
Bra-0106
Fig. 46 Ending route
guidance
Start route gd.
NAVI
Stop route gd.
sao.book Seite 38 Montag, 22. M‰
rz 2004 9:32 09