turn signal SKODA OCTAVIA TOUR 2011 2.G / (1Z) Blues Car Radio Manual

You can select between the following parameters:
●
TRE - Treble setting;
● BASS - bass setting;
● BAL - setting of the volume ratio between the left and the right side;
● FAD - setting of the volume ratio between the front and the rear; Ð
Setting the special functions –
Press the rocker switch MENU , in order to activate the menu Set-up.
– Individual functions of the menu are selected by pressing the rocker switch
MENU or by pressing the rocker switches

 ,

 .
– Set the desired value by turning the button 1 .
REG AUTO / REG OFF
Certain programs of the broadcasting companies are divided into regional pro-
grams at specific times. That is why in individual regions the regional programs of
a station can broadcast different contents.
First of all the unit attempts to set only alternative frequencies of the selected
station.
If the quality is however so low, that there is a risk of a

“program loss”, the unit
also accepts “related” frequencies.
When opting for REG AUTO the change to a regional “related” station can only be
performed if there is a risk of losing the station. When selecting REG OFF, the re-
ceiver can access the regional “related” stations unlimited.
GALA
Your radio increases automatically its volume with the increasing vehicle speed. A
higher setting value results in a stronger volume increase.
LOUD
In case of low volume level, the function reinforces the range of bass and treble
frequencies.
BEEP
Switching on or off the tone signal when storing the radio stations. ON VOL
Your radio stores the last volume set before switching off. If the value is higher,
the volume is reduced to the value of the parameter ON VOL after switching on
the radio again.
PHONE
If your vehicle is equipped with a handsfree system, the monophone play function
of the mobile phone calls is carried out via the loudspeakers of the vehicle.
PDC AT
If your vehicle is equipped with

“parking aid”, the volume is automatically de-
creased to a pre-defined value, when the “parking aid” is active.
● PDC AT0 - no volume restriction;
● PDC AT1 - restricts the volume to a middle level;
● PDC AT2 - restricts the volume to a low level;
● PDC AT3 - Mute.
AUX
Setting of the input sensitivity AUX LEV:
● AUX LEV 1 - high level, used in particular for notebooks;
● AUX LEV 2 - middle level, used for cassettes or CD player;
● AUX LEV 3 - low level, used for MP3 player; Note
Each setting change is stored by changing to another menu point. Ð
Radio mode Waveband switch-over Your radio is fitted with the wavebands FM and AM, in order to change, press the
rocker switch
A/F for some considerable time.
In the ranges FM1/AM1 and FM2/AM2 there are each 6 memory spaces available, in
order to change, press the rocker switch A/F briefly.
Ð4
General information

The process of searching for and storing the radio stations
Manual search
–
Set the frequency of the desired radio station by pressing the rocker switch or
 .
Automatic station finding SEEK
– The radio searches for the next radio station in the selected waveband by
pressing the rocker switch  or
 .
Function SCAN
– The radio station of the current waveband is briefly played (10 seconds) by
pressing the rocker switch SCAN .
– This function is ended by pressing the rocker switch SCAN once again and the
current station is replayed.
Store station
– After selecting the radio station, hold the station key 13 , on which it should be
stored until it briefly switches to mute and a brief signal sounds.
Automatic station finding with storing the radio stations
– Press the rocker switch AS . An automatic station finding is started during
which the 6 stations with the strongest signal in the memory level FM2 and/or
AM2 are stored. STORE
is displayed on the display. This applies only to the
wavebands FM2 and AM2.
When storing the radio stations on the station keys 13 is finished, you can call up
the desired radio station by pressing a station key 13 .
Note
The stored radio stations of the current waveband are updated and stored once
again by repetitively pressing the rocker switch AS .
Ð
Radio text Certain radio stations transmit additional text information - designated as radio
text. Note
● The text information must not be available to all radio stations.
● Depending upon the quality of the received signal, the radio needs a specific
time, in order to correctly read all the illustrated characters. Ð
Traffic reports Activating and deactivating the traffic reports
Press the rocker switch
TP ,
TP appears in the display. If a set radio station does
not transmit a traffic report, the radio searches for a station which transmits the
traffic report. TP SEEK

is displayed on the display.
If no radio station which transmits the traffic reports is found, NO TP is shown on
the display.
An incoming traffic report automatically interrupts the CD play function or listen-
ing to a radio station, which at that moment is not transmitting a traffic report.
INFO and Station name is shown on the display. At the end of the traffic report,
the radio automatically returns to the original play function.
If you wish to deactivate the traffic information, press once again the rocker
switch TP ,
TP goes out on the display. Ð 5
General information