manual radio set SKODA OCTAVIA TOUR 2012 2.G / (1Z) Swing Car Radio Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2012, Model line: OCTAVIA TOUR, Model: SKODA OCTAVIA TOUR 2012 2.G / (1Z)Pages: 15, PDF Size: 2.43 MB
Page 3 of 15
Table of Contents
General information
Owner's Manual
2
Symbols in the text of the operatinginstructions
2
Equipment overview
2
Important information
2
Anti-theft protection
3
Basic setting
3
Radio mode
4
CD player
Using the system
61Table of Contents
Page 4 of 15
General information
Owner's Manual
This Owner's manual describes all possible equipment variants without identify-ing them as special equipment, model variants or market-dependent equipment.
Consequently, this vehicle does not need to contain all of the equipment compo-nents described in this Owner's manual.
The scope of equipment for your vehicle is described in the sales documentationyou were given when purchasing the car. For more information, contact your localŠKODA retailer.
Ð
Symbols in the text of the operating instructions
Explanation of symbolsÐ End of a section.
The section is continued on the next page.
Ð
Equipment overview
Control button›Switching radio on and off›Volume control (rotate)Menu control button›Call up the menu settings of the parameter for radio or CD player›Activating the function ScanButton MEDIA to activate the play function of audio sourcesButton RADIO to activate the radio mode ›fast station finding in radio mode›Select the track in the CD mode, fast forward/backward search in the CDmodeINFO›Display of radio text information›Display of additional information of MP3-CDs
123456Button for adjusting the soundButton AS automatically stores the stationButton TP to activate the reception of traffic reportsCD caseCD - eject buttonStation keys›store and select the RDS station›CD selection›Enter code
Ð
Important information
Warranty
The equipment warranty terms and conditions also apply for new vehicles.
After the expiration of the warranty, a piece of equipment in need of repair will bereplaced with a reconditioned, original item with spare part warranty. It is, howev-er, a precondition that the housing has not been damaged and no unauthorisedattempts have been made to carry out repairs.
Note
Damage within the meaning of the warranty must not be the result of improperhandling of the system or from unprofessional repair attempts. It is also essentialthat there is no external damage.
Ð
Device operation
The unit should only be used, if the traffic situation permits it.
The volume settings must be selected in such a way that audible signals from theoutside, e.g. a Martins horn from utility vehicles (police cars, ambulances and firebrigade), can be heard at all times.
WARNINGPlease concentrate fully at all times on your driving! As the driver you are fullyresponsible for road safety. Only use the functions of the radio in such a waythat you are always in full control of your vehicle in all traffic situations!
Ð
7891011122General information
Page 5 of 15
Windscreen cleaning
CAUTION
■Do not use solvent such as turpentine or petrol as they will corrode the displaysurface.■
Carefully handle the display because dents and scratches can occur throughpressure of the finger or contact with sharp objects.
Note
The display can be cleaned with a soft cloth and finger marks can be wiped awaywith pure alcohol.
Ð
Anti-theft protection
Anti-theft coding
Your radio is equipped with a convenience coding. If the radio is being operatedfor the first time, the safety code is not only stored in the radio but also in thevehicle.
After disconnecting and reconnecting the battery, first of all switch on the igni-tion and then the radio.
If you wish to install the radio in another vehicle, the safety code must be en-tered. In this case, please do not hesitate to contact a ŠKODA Service Partner or aŠKODA importer.
As the unit only functions after entering the safety code, this practically excludesits use after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cluster. This ensures that it is automaticallydecoded (convenience coding). Manual input of the code is normally not necessa-ry.
Ð
Enter code
›
Switch on the radio if the ignition is on.
›Enter the safety code using the station keys 1 - 4.›Confirm the safety code by pressing the station key 6.
If you have confirmed a wrongly entered code, you can repeat once again the en-tire process.
If the code number is entered incorrectly for the second time, the unit will beblocked for approx. one hour. It is possible to enter again the safety code afterone hour has expired, when the unit and the ignition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply.
Ð
Basic setting
Switching the unit on and off
›
The system is switched on or off by briefly pressing the control button
1
.
If the key is pulled out of the ignition lock while the unit is switched on, the unitwill switch off automatically. You can switch on the unit again by pressing thecontrol button
1
. If the ignition is switched off, the unit (discharge protection ofthe vehicle battery) switches off automatically after approx. one hour.
If you have switched off the radio by withdrawing the ignition key, the radioswitches on again once the ignition is on.
Ð
Audio settings
›
Press the button and then the station key
12
and select the desired parame-ter.
›
Set the desired value by turning the menu control button
2
.
You can select between the following parameters:
›BASS - bass setting;›MIDDLE - midtone setting;›TREBLE - treble setting;›BALANCE - setting of the volume ratio between the left and right side;›FADER - setting of the volume ratio between the front and the rear;›ON VOL - Your radio stores the last volume set before switching off. If the valueis higher, the volume is reduced to the value of the parameter ON VOL afterswitching on the radio again.
3General information
Page 6 of 15
›PDC VOL - If your vehicle has been fitted with the “Parking aid (PDC)” driver'sassistant system, the volume is automatically reduced to a pre-defined valuewhen the “parking aid (PDC)” is active;›GALA - the car radio will increase the volume in response to an increase inspeed (higher figures result in a steeper increase in volume);›LOUD - in case of low volume level, this function reinforces the range of bassand treble frequencies.
Ð
Setting the special functions
›
Press the menu control button
2
for a long period of time.
›
Select the individual functions of the menu with the help of the station keys.
›
Set the desired value using the menu control button
2
or with the help of thestation keys.
AUXSwitching on or off the functions of the external audio source.
Setting of the input sensitivity AUX LEV:
›LEV 1 - high level, used in particular for notebooks;›LEV 2 - middle level, used for cassettes or CD player;›LEV 3 - low level, used for MP3 player.
PHONEIf your vehicle is equipped with a handsfree system, you can switch on or off themonophone play function of the mobile phone calls via the loudspeakers of thevehicle.
BEEPSwitching on or off the tone signal when storing the radio stations.
ILLUMSwitch on (value 2) or switch off (value 1) the rear lighting of the control buttons.
AFThe function alternative frequency (AF) ensures that the best receivable frequen-cy of the selected station is automatically and precisely set. The replay of thebroadcast can be muted briefly during the search process according to the bestreceivable frequency. If no alternative frequency of the set station can be foundand the station no longer offers a satisfactory quality, then please select anotherstation.
REGCertain programs of the broadcasting companies are divided into regional pro-grams at specific times. That is why in individual regions the regional programs ofa station can broadcast different contents.
First of all the unit attempts to set only alternative frequencies of the selectedstation.
If the quality is however so low, that there is a risk of a “program loss”, the unitalso accepts “related” frequencies.
›FIX - the receiver switches to a regional “related” station, if the reception of thecurrent station could be interrupted;›AUTO - the receiver can access the regional “related” station unlimited.
BT-AUDIOEnables a wireless transfer of MP3 data from the telephone preinstallation.
Ð
Radio mode
Changing the frequency band
›
Press the button RADIO.
Your radio is equipped with FM and AM wavebands. They are divided in 6 memorylevels, i.e. 3 levels for FM and 3 levels for AM.
Activation of the FM bandActivate the FM band by pressing the RADIO button for a long time followed bythe FM
12
button. By briefly pressing the button RADIO, you can select betweenthe memory levels FM1, FM2 and FM3.
Activation of the AM bandActivate the AM band by pressing the RADIO button for a long time followed bythe AM
12
button. By briefly pressing the button RADIO, you can select betweenthe memory levels AM1, AM2 and AM3.
Ð
The process of searching for and storing the radio stations
Manual search
›
Search the frequency of the desired radio station by turning the menu controlbutton
2
.
4General information