AUX SKODA RAPID 2014 1.G Blues Car Radio Manual

Button MENU to access a menu for setting the parameters of the device or
CD Player
Function keys
› Select and store radio stations
› Enter code
› Call up Menu Setup
Button 
for sound adjustment
CD slot
CD eject button

Switching the unit on and off
›
The unit is switched on or off by briefly pressing the on/off knob
1
.
If the key is removed from the ignition while the unit is still switched on, it will
turn off automatically. The unit can be switched on again by pressing the on/off
knob
1
. If the ignition is switched off, the unit protects the vehicle battery by
switching itself off automatically after approx. one hour.
If you have switched the device off by removing the ignition key, the device
switches back on when the ignition is turned on again.

Unit set-up
Adjusting the sound
›
Select the desired setting by pressing the  button.
›
Set the desired value by turning the settings knob
2
.
The following parameters are available:
› TRE
- Treble setting;
› BAS
- Bass setting;
› BAL
- setting of the volume ratio between the left and the right side;
› FAD
- setting of the volume balance between the front and the rear.

Setting special functions
›
Press the MENU button and then the
SET function key to activate the setup
menu.
7891011› Select individual menu functions by pressing the function keys.›Select the value desired by pressing the button
 or .
SKM
Automatic station search.
› ALL
- stops the station finding on all available stations;
› PRESET
- stops the station finding only at the stored stations
VOL
Your device stores the last volume set before switching off. If the value is higher,
the volume is reduced to the value of the parameter ON VOLUME after switching
on the device again.
GAL
Your device automatically adjusts the volume to the vehicle speed. Higher num- bers mean a bigger change in the volume level.
DIS
Adjusting the display backlight.
PHONE
If your vehicle is equipped with a hands-free system, the mono phone play func- tion of mobile phone calls can be switched on/off via the loudspeakers.
PDC AT
If your vehicle is equipped with “parking aid”, the volume is automatically de- creased to a pre-defined value, when the “parking aid” is active.
› 0
- No volume limit;
› 1
- Volume limit at medium level;
› 2
- Volume limit at low level;
› 3
- Mute.
AUX
Setting of the input sensitivity AUX VOL LEVEL:
› AUX VOL LEV 1
- high level, used in particular for notebooks;
› AUX VOL LEV 2
- medium level, used for audio cassette or CD player;
› AUX VOL LEV 3
- low level, used for MP3 player;
Note
Each setting change is stored by changing to another menu point.
4General information

CD player
Using the system
Information on how to use a CD
The internal drive can play CD-ROM, CD-R, CD-RW discs.
Insert the CD
With the labelled side facing up, only insert a CD into CD slot
10
until it is auto-
matically drawn in.
The play function will start automatically.
Taking out the CD
Press the 
button – the CD is ejected.
If the “ejected” CD is not taken out within 10 seconds, it will be drawn in again for
safety reasons.
Buttons on the unit for controlling the current audio source
The arrow buttons 
or  on the unit will always affect the audio source current-
ly being listened to, irrespective of the current menu used.

- brief pressing within 2 seconds of playback takes you to the beginning of the
previous track or chapter, or after 2 seconds to the beginning of the current title
or chapter.

- pressing this briefly changes over to the beginning of the next title or chap-
ter, repeated pressing changes over to the beginning of the subsequent title or
chapter.
Changing between the audio sources
Press the MEDIA
button to select the audio source:
CD (internal CD drive), EXT (CD
changer, if it is connected to the device) or AUX.
WARNINGThe CD-player is a laser product. On the manufacturing date, this unit was
classified as a class 1 laser product in accordance with the national/interna-
tional standards DIN EN 60825-1: 2008-05 and DHHS Rules 21 CFR,
Subchapter J classed as a class 1 laser product. The laser used in this class 1 laser product is so weak that there is no risk of danger when operated cor-
rectly. This product is designed such that the laser is restricted to the inside of
the unit. However, the installed laser could be classified in a higher class were the housing to be removed. For this reason, never remove the housing of the
unit.
CAUTION
■ Never insert CDs with the designation “ into the internal drive. Do not insert in
drives without a drawer ” or use Eco Discs.■
After pressing the button  there is a time delay of a few seconds before the
CD is ejected. During this time the lock in front of the CD-slot is open.
■
Be sure to wait until the CD has been fully ejected before you try to insert a new
CD. Otherwise you can damage the drive inside the unit.
■
A dirty, mechanically damaged, unreadable or incorrectly inserted CD can cause
playback problems. The CD may not be playable because of this or may cause it to
jump. Check the CD and insert it properly into the unit. Should problems persist ,
try using another CD and visit a specialist garage if necessary.
■
If the internal temperature of the device is too high, no CDs will be accepted.
The unit switches into the last active operating mode.
■
Never use liquids such as gasoline, paint thinner or record cleaner to clean the
surface of the CD - this may cause damage.
■
Never expose the CD to direct sunlight!
■
Only write on the CD using appropriate pens.
■
Do not stick anything to the CD.
Note
■ Poor or unsealed road surfaces and severe vibrations may cause the CD to jump.■In cold weather or after rain showers, moisture (condensate) may deposit in the
unit. This can effect the CD jump or impair the play function. In that case, wait un- til the moisture has dissipated.■
If a CD is dirty, never clean it in a circular motion, but instead work from the in-
side out. Use a soft, lint-free cloth. For heavy stains, we recommend that you
clean the CD with a commercially available CD cleaner and allow it to dry. 
6CD player

External sources
Using the system
Advice for dealing with external sources
An external audio source connected to the AUX-IN input can be played in the car through the speakers of the device.
External audio sources cannot be controlled via the device.
A different audio source can be selected on the device at any time. As long as the
external audio source is not switched off, it always remains active in the back-
ground.
See the owner's manual of the specific manufacturer for operating the external
audio source.
Conditions for a successful connection
To connect external audio sources via the AUX-IN input a 3,5 mm standard jack
plug is needed. If the external audio source does not have this jack plug, you must
use an adapter.
› Only USB devices with the specification 2.0 can be connected.
› The version of the file allocation table FAT (File Allocation Table) of the connec-
ted device must be FAT16 ( <2 GB) or FAT32 (> 2 GB).
› In order to replay from a unit with a hard disk (HDD) which includes a large data
volume, it can lead to a time delay when reading in the overview of the music
data.
› In order to replay from a unit, which includes a complicated folder structure, it
can lead to a time delay when reading in the overview of the music data.
› The folder structure in the connected unit must not exceed a depth of 8 levels.
One folder must not contain more than 1000°data.
› A USB extension cable or USB distributor (HUB) must not be used to connect
the unit.
Adapter
We recommend that you purchase an adapter for connecting the USB devices, the
devices with Mini USB output or an iPod, at an authorised ŠKODA Service Partner.
Adjust the play function volume of the external audio source
The playback volume of the external audio source can be adjusted via the volume
control on the device.
Depending on the connected audio source, the output volume on the external au-
dio source can be changed.
You can also change the input sensitivity of the external audio source » page 4,
AUX , in order to adapt the play volume of the external audio source to that of the
other audio sources or to avoid distortions .WARNING■ Never place external sources on the console panel. They could be thrown in-
to the passenger compartment during sudden driving manoeuvres, thereby in-
juring the occupants.■
Never place external sources close to the airbags. These could be thrown in-
to the passenger compartment when the airbags are deployed, injuring the
occupants.
■
Never hold external sources in your hand or on your knees while driving.
They could be thrown into the passenger compartment during sudden driving
manoeuvres, thereby injuring the occupants.
■
Always route the connection cable for the external source such that it does
not restrict you when driving.
CAUTION
The AUX-IN input must only be used for audio sources!
Note
■ See the owner's manual of the specific manufacturer for instructions on operat-
ing the external source.■
If an external audio source is connected via AUX-IN, which is equipped with an
adapter for external power supply, it can occur that the audio signal is interrup-
ted. This depends on the quality of the adapter which is used.

AUX input
The input for external audio sources AUX-IN is located below the armrest of the
front seats and is marked with the logo .
›
The AUX-IN jack is activated by pressing the MEDIA button and by pressing the
selection button AUX.
The play function starts automatically after connecting the source. 
8External sources

External audio sources connected via the AUX-IN input cannot be controlled via
the device.
9External sources