key SKODA ROOMSTER 2008 1.G Technical Change

Technical changes3
– Unlock the loading floor by turnin g the locking bolts by approx.
180° to the left ⇒page 2, fig. 4.
– You can fold together the loading floor by moving in the direction of
arrow.
– Lift up the loading floor in direction of arrow ⇒page 2, fig. 5 and
take out the loading floor by pulling in direction of arrow
⇒ page 2, fig. 5.
Install variable loading floor
– Place the loading floor once folded together onto the carrier rails.
– Fold open the loading floor.
– Lock the loading floor by turning th e locking bolts by approx. 180°
to the right.
– Attach the loops of the elastic partition to the fixing points.
WARNING
Pay attention when installing that the carrier rails and the variable loading floor are correctly fixed, otherw ise the occupants are at risk.
Note
If the variable loading floor* is installed, no flexible storage compartment or fixing net* can be installed.
Remove carrier rails
Install carrier rails
– Slacken the check point on the ca rrier rails using the vehicle key or
a flat screwdriver ⇒fig. 6.
– Grasp the carrier rail ⇒fig. 7 and take it out by pulling in direction
of arrow. The carrier rail on the other side of the luggage compartment
can be removed in the same way.
Install carrier rails
– Position the carrier rails on the sides of the luggage compartment.
AB
A1
A2
AB
Fig. 6 Luggage compart- ment: Slacken check points
Fig. 7 Luggage compart-ment: Remove carrier rails
AB
AA
dod RoomA05 20.book Page 3 Wednesday, April 16, 2008 1:10 PM

Technical changes6
Coolant temperature/coolant level 
After the ignition is switched on the warning light  lights up blue until the engine reaches operating temperature 1). Avoid running at high engine speeds, at full throttle and at severe engine loads. The bl ue warning light goes out once the oper- ating temperature has been reached .
Radio and mobile phone operation
By pressing the buttons, you can carry out the following functions:
Front seat heating*
WARNING
•Do not use the seat heating if objects are fastened or stored on the seat for example a child seat, a bag etc. - a fault in the seat heating system can occur.
Selector lever lock
Keylock2)- Ignition key withdrawal lock
You can only withdraw the ignition key after switching off the ignition if the selector lever is in position P. If the ignition key is withdrawn, the selector lever is blocked in position P.
Vehicle tool kit
1)Not valid for vehicles with information display*.
ButtonRadioCDPhone
without function
Receive, accept a call, call up menu tele- phone,
confirm menu selection  /  / 
Fig. 13 Multi-functional module: Buttons for the radio and mobile phone operation
A5
2)This function is only valid for some countries.
Fig. 14 Luggage compart-ment: Storage compartment for vehicle too kit
dod RoomA05 20.book Page 6 Wednesday, April 16, 2008 1:10 PM