tow SKODA ROOMSTER 2008 1.G Technical Change
[x] Cancel search | Manufacturer: SKODA, Model Year: 2008, Model line: ROOMSTER, Model: SKODA ROOMSTER 2008 1.GPages: 10, PDF Size: 4.9 MB
Page 6 of 10
Technical changes5
– Lift up a part of the loading floor with the handle and secure it by
moving it into the grooves ⇒page 4, fig. 10.
Static separation net*
Install the static separation net behind the front seats or the rear seats.
Install the static separation net behind the rear seats
– Remove the luggage compartment cover.
– Take the separation net out of the bag.
– Unfold both parts of the cross rod until they are heard to engage.
– Insert the cross rod into the mount first on the one side and push
the cross rod forward. In the same way, fix the cross rod to the other
side of the vehicle, mount ⇒fig. 11.
– Hang the carabines at the ends of the strap into the lashing eyes
behind the rear seats.
– Pull the strap through the tensioning clasp, first of all on the one side
and then on the other side.
Remove the static separation net behind the rear seats
– Slacken the bands on both sides and take off the carabines
⇒ fig. 11.
– Push the cross rod first of all on the one side and then on the other
side towards the rear.
– Take the cross rod out of the mounts .
Pack static separation net
– Press the red button of the joint - so that it releases.
– Put the separation net folded together in the bag and close it.
– Attach the bag with the aid of the pl astic carabines to the eyes on the
left and right luggage compartment trim panel.
Installing and removing the static se paration net behind the front seats ⇒fig. 12 is carried out analogously as behind the rear seats. Use the eyes behind the front seats to attach the carabines. Remove the rear seats to enlarge the luggage compartment.
Installing and removing the static separation net behind the rear seats with variable loading floor* ⇒page 2 is carried out analogously as behind the rear seats without variable loading floor. Use the lower eyes at the fixing wedges on the front part of the variable loading floor in order to attach the carabines.
Fig. 11 Use of the static separation net behind the rear seats
Fig. 12 Use of the static separation net behind the front seats
AB
AB
AC
AC
AB
AA
dod RoomA05 20.book Page 5 Wednesday, April 16, 2008 1:10 PM
Page 8 of 10
Technical changes7
The vehicle tool kit and the lifting jack, on which a note sticker is affixed, are stored in a plastic box in the spare wheel ⇒page 6, fig. 14. There is also space here for the removable ball for the trailer towing device.
The vehicle tool kit contains the following parts (depending on equipment fitted):
•Torx wrench,
•Wheel wrench,
•Hook for pulling off a full wheel trim,
•To w i n g e y e ,
•Adapter for the wheel bolts lock.
After using the lifting jack, screw in the arm of the lifting jack fully before placing it back in its stowage area.
WARNING
•The factory-supplied lifting jack is only intended for your model of vehicle. On no account attempt to lift a heavier vehicle or other loads - risk of injury!
•Ensure that the vehicle tool kit is safely attached in the luggage compartment.
dod RoomA05 20.book Page 7 Wednesday, April 16, 2008 1:10 PM