tow SKODA ROOMSTER 2009 1.G Cruise Navigation System Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2009, Model line: ROOMSTER, Model: SKODA ROOMSTER 2009 1.GPages: 20, PDF Size: 1.39 MB
Page 13 of 20

Navigation
11
NavigationOverviewSafety information regarding the use of the navigation systemThe route is recalculated each time if 
you ignore driving recommendations or  
change the route. This process takes only a few seconds. Driving recommendations can only then be re-transmitted. Incomplete navigation data The navigation system cannot receive any data from GPS satellites if you drive for  longer periods under thick forest canopy or 
 when your vehicle is in a garage, under- 
pass or tunnel. In this case, the navigation system orientates itself solely with the  help of the vehicle sensors. In regions not at all or only partially digitalised and stored as such on the navigation  CD, the navigation system will try to prov 
ide guidance to the destination. Please  
note that under these circumstances the  
guidance to the destination may not be  
completely correct if, for example, one-wa 
y streets and road categories (motorway,  
country road etc.) are not at all or only  
partially included in 
the navigation data  
used.
WARNING
Please observe the legal requirements  
for road traffic when following the  
driving recommendations provided by your radio navigation system.•
The driving recommendations provided may vary from current situa-
tions, e.g. due to road works or out of 
 date navigation data. In such a case,  
always observe the traffic regulations and ignore the driving recommenda- tions.•
Traffic signs and traffice regulations al 
ways have priority over the driving  
recommendations provided by the navigation system.•
Route guidance is subject to consta 
nt changes despite the information  
about one-way streets, pedestrian zone 
s etc. stored on the navigation CD.  
Information on traffic lights, stop and right of way signs, parking and stop- 
ping restrictions as well as lane constrictions and speed restrictions is not  included in the radio navigation system.Navigation CDInserting the navigation CD – Insert the CD into the CD case  . The program stored on the naviga- 
tion CD is loaded. Do not remove the navigation CD before the loading process is finished.
After route guidance has started, the na 
vigation CD may not 
be taken out under  
certain circumstances, e.°g in order to play an Audio CD. Up to date navigation data and new navigation CD Road guidance is subject to 
 constant changes (e.g. new streets, changes of street  
names and house numbers). A navigation CD 
 is a huge data store, which unfortu- 
nately will not be up to date after a certai 
n time. This can lead to complaints during  
route guidance. It is for this reason that you must regula 
rly update the navigation data on your unit  
with a current navigation CD.GeneralYou can continue to listen to the radio  
or play CDs during the route guidance  
When entering an address (town, street),  
only those letters or symbols which make  
up a logical entry will be presented. A list  
of possible names will be shown. Do not  
forget to enter the blank space in names made up of more than one word, such as  High Wycombe.
WARNING (continued)
A7
s28k.book  Page 11  Friday, May 16, 2008  10:17 AM 
Page 15 of 20

Navigation
13
Route guidanceEnter a travel destinationEnter names and numbers – Turn the button   to select the letters or numbers, press the button  
 so that they are accepted in the entry line  
⇒
fig. 6
. Characters  
which do not apply fade out so that only the actual names and those stored on the navigation CD can be entered. 
– Select   if you wish to enter digits (e.°g for the entry of a post code). – Select   if you wish to  
enter special characters. 
– The entry in the upper line changes with each entry carried out. If the  
entry corresponds to your search or comes close to it, change over to a list with   or with the function key   where you mark and confirm the desired entry using the button. 
– Press the function key   if yo 
u wish to delete a character. 
Call up navigation and select destination entry –Press the button  . – Select the type of destination entry using the button  .Possibilites for destination entry With  
country
, town/post code
, street
 and 
intersection
 - an address is entered as  
a destination. When selecting a country, th 
e following input possibilities are limited  
to the relevant country as for e.°g special destinations. Special destinations 
 - special points such as fill
ing stations or hospitals are  
entered as a destination. Start route guidance 
 - starts the route guidance to the entered destination. 
Position 
 - enter the destination using the c
oordinates for longitude and latitude. 
Function keys in the Navigation main menu: 
 - calls up the destination memory.  - Entry of stopover destinations, route list, route options, blocked stretches. - calls up the position  
display. The current vehicl
e position is displayed to  
you as an address (if stored on the navigation CD) and via coordinates. The current  direction of travel is shown to you by 
 a compass on the left in the display. 
 - starts the route guidance to the shown destination. The  
current route guidance is ended with  .
Note
•
A small marking can be found below some 
 of the letters. If you mark these  
letters and wait for a few seconds, special characters which are based on these  letters fade in.
Fig. 5  Destination entryFig. 6  Enter names and  numbers
A1
A1
0-9*?!
OK
LIST / OK
DELETE
NAV
A1
MEMORYROUTESYMBOLSTART ROUTE GUIDANCE.
STOP ROUTE GD.
s28k.book  Page 13  Friday, May 16, 2008  10:17 AM