tailgate SKODA ROOMSTER 2012 1.G Owner's Manual

Fixing of the loading floor
Fig. 156
Loop for raising the loading floor/Fixing the loading floor with a
plastic hook
You can fix the loading floor with a hook on the top edge of the boot lid cutout, in
order to e. g. reach the spare wheel.
› Raise the loading floor at the loop
» Fig. 156 -  and fix it with a plastic hook (it
is located below the loading floor edge) to the top edge of the tailgate cut-
out » Fig. 156 - . ÐAdjustment of the safety partition
Fig. 157
Top/lower support of the safety partition
Only valid for some countries. › Raise the loading floor part behind the safety partition.
› On each side in the upper area of the body, undo and remove a bolt
» Fig. 157 -
 and undo and remove a bolt in the lower area » Fig. 157 - . ›
Move the safety partition into the required position. Ensure it is always move
the same distance- the same number of holes on both sides both upwards and
downwards.
› On each side in the upper area of the body, undo and remove a bolt and undo
and remove a bolt in the lower area.
› Have the
tightening torque of the bolts checked with a torque wrench as soon
as possible. The tightening torque must be 20 Nm.
› Change the position of the cover of the luggage compartment floor behind the
safety partition so that it lines up with the new position of the safety partition.
› Fold back the loading floor part. Ð Emergency unlocking of the loading area door
Fig. 158
Emergency unlocking of the
loading area door
If there is a fault in the central locking, you can unlock the loading area door as
follows:
› Pull the control cable towards you and pull on it.
› Press on the loading area door to open it.
› Press the control cable back again. Ð
175
Praktik