ignition SKODA SUPERB 2012 2.G / (B6/3T) Swing Car Radio Manual

Windscreen cleaning
CAUTION
■Do not use solvent such as turpentine or petrol as they will corrode the displaysurface.■
Carefully handle the display because dents and scratches can occur throughpressure of the finger or contact with sharp objects.
Note
The display can be cleaned with a soft cloth and finger marks can be wiped awaywith pure alcohol.
Ð
Anti-theft protection
Anti-theft coding
Your radio is equipped with a convenience coding. If the radio is being operatedfor the first time, the safety code is not only stored in the radio but also in thevehicle.
After disconnecting and reconnecting the battery, first of all switch on the igni-tion and then the radio.
If you wish to install the radio in another vehicle, the safety code must be en-tered. In this case, please do not hesitate to contact a ŠKODA Service Partner or aŠKODA importer.
As the unit only functions after entering the safety code, this practically excludesits use after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cluster. This ensures that it is automaticallydecoded (convenience coding). Manual input of the code is normally not necessa-ry.
Ð
Enter code
›
Switch on the radio if the ignition is on.
›Enter the safety code using the station keys 1 - 4.›Confirm the safety code by pressing the station key 6.
If you have confirmed a wrongly entered code, you can repeat once again the en-tire process.
If the code number is entered incorrectly for the second time, the unit will beblocked for approx. one hour. It is possible to enter again the safety code afterone hour has expired, when the unit and the ignition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply.
Ð
Basic setting
Switching the unit on and off
›
The system is switched on or off by briefly pressing the control button
1
.
If the key is pulled out of the ignition lock while the unit is switched on, the unitwill switch off automatically. You can switch on the unit again by pressing thecontrol button
1
. If the ignition is switched off, the unit (discharge protection ofthe vehicle battery) switches off automatically after approx. one hour.
If you have switched off the radio by withdrawing the ignition key, the radioswitches on again once the ignition is on.
Ð
Audio settings
›
Press the button  and then the station key
12
and select the desired parame-ter.
›
Set the desired value by turning the menu control button
2
.
You can select between the following parameters:
›BASS - bass setting;›MIDDLE - midtone setting;›TREBLE - treble setting;›BALANCE - setting of the volume ratio between the left and right side;›FADER - setting of the volume ratio between the front and the rear;›ON VOL - Your radio stores the last volume set before switching off. If the valueis higher, the volume is reduced to the value of the parameter ON VOL afterswitching on the radio again.
3General information