AUX SKODA YETI 2010 1.G / 5L Technical Change

Tow-starting and towing vehicle9
If you reached a tyre inflation pressure of 2.0 – 2.5 bar, resume driving at a maximum
speed of 80 km/h (50 mph).
Check the tyre inflation pressure after driving 10 minutes page 9, “Check after
driving for 10 minutes”.
WARNING
•
During inflation, the tyre inflation hose and air compressor may get hot-
risk of injury!
•
Do not place hot tyre inflation hoses or hot air compressors on flammable
materials - risk of fire!
•
If you cannot inflate the tyre to at least 2.0 bar, this means the damage
sustained was too serious. The sealing agent cannot be used to seal the tyre. Do
not drive the vehicle. Get professional assistance.Caution
Switch off the air compressor after running 8 minutes at the latest - danger of over-
heating! Allow the air compressor to cool a few moments before switching it on
again.Check after driving for 10 minutesCheck the tyre inflation pressu re after driving 10 minutes.If the tyre inflation pressure is 1.3 bar or less:–Do not drive the vehicle! You cannot properly seal wi th tyre with the breakdown
kit.
– Obtain professional assistance.If the tyre inflation pressure is 1.3 bar or more:– Adjust the tyre inflation pressure to the corr ect value (see inside of fuel filler cap).
– Continue driving carefully to the nearest specialist garage at a maximum speed of 80 km/h (50 mph).
Tow-starting and towing vehicleGeneral
Caution
Do not push or two the vehicle to start the engine - likely engine damage! In vehicles
with catalytic converters, fuel may get into the catalytic converter where it may ignite.
This results in the catalytic converter overheating and being destroyed. To help start
the engine, you can use a battery from another vehicle, see Owner's manual.Electric fusesFuse assignment in engine compartmentFuse assignment in the dash panelNo.
Power consumer
Amperes
F11
Control unit for auxiliary heating
30
No.
Power consumer
Amperes
36
DVD
5
s35k.9.book Page 9 Thursday, September 16, 2010 10:24 AM

Technical Data
12
Capacities (in liter)
Weight (in kg)
Angle (in degree)Engine oil
a)
a)Oil capacity with oil filter change. Inspec t oil level when filling; do not fill up too much. The oil level must be between the markings.
3.6
Cooling system of the vehicle
b)
b)On vehicles which are fitted with an independent auxiliary heating and ventilation, the volume of the coolant is greater by approx. 1 ltr.
7.7
Permissible gross weight
1920/1975
a)
a)Vehicles of the group N1.Unladen weight ready for operation
1375
Loading capacity
620/675
a)
Loading capacity when using the TLC
540
Max. permissible gross weight per front axle
1000/980
a)
Max. permissible gross weight per rear axle
960/1100
a)
Permissible trailer loads, trailer braked
1300
Permissible trailer loads, trailer unbraked
650
Slope angle (°)/climbing ability (%)
27/50
s35k.9.book Page 12 Thursday, September 16, 2010 10:24 AM

Technical Data
14
Capacities (in liter)
Weight (in kg)
Dimensions (mm)
Angle (in degree)Engine oil
a)
a)Oil capacity with oil filter change. Inspec t oil level when filling; do not fill up too much. The oil level must be between the markings.
4.3
Cooling system of the vehicle
b)
b)On vehicles which are fitted with an independent auxiliary heating and ventilation, the volume of the coolant is greater by approx. 1 ltr.
8.4
Permissible gross weight
1955/2010
a)
a)Vehicles of the group N1.Unladen weight ready for operation
1410
Loading capacity
620/675
a)
Loading capacity when using the TLC
540
Max. permissible gross weight per front axle
1040/1000
a)
Max. permissible gross weight per rear axle
960/1100
a)
Permissible trailer loads, trailer braked
1400
Permissible trailer loads, trailer unbraked
650
Clearance
155
Front embankment angle
17.1
Rear embankment angle
25.2
Ramp angle
17.2
Slope angle (°)/climbing ability (%)
29/55
s35k.9.book Page 14 Thursday, September 16, 2010 10:24 AM