radio antenna SMART FORTWO 2016 Owners Manual

Useful information
i
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's Man- ual. Country-specific differences are pos-
sible. Bear in mind that your vehicle may
not feature all functions described here.
This also applies to safety-relevant sys-
tems and functions.
iRead the information on qualified spe-
cialist workshops: (Ypage 20).
Information regarding technical data
General information
i
The data stated here specifically refers
to a vehicle with standard equipment. Con- sult a smart center for the data for all vehi-
cle variants and trim levels.
Vehicle electronics
Retrofitting two-way radios and
mobile phones (RF transmitters)
GWARNING
The electromagnetic radiation from modi-
fied or incorrectly retrofitted RF-trans-
mitters can interfere with the vehicle
electronics. This can compromise the
operational safety of the vehicle. There is
a risk of an accident.
You should have all work to electrical and
electronic equipment carried out at a
qualified specialist workshop.
GWARNING
The electromagnetic radiation from incor-
rectly operated RF transmitters can inter-
fere with the vehicle electronics, for
example:
Rif the RF transmitter is not connected
with an exterior antenna
Rthe exterior antenna has been installed
incorrectly or is not a low-reflection
type
This can compromise the operational safety
of the vehicle. There is a risk of an acci-
dent.
Have the low-reflection exterior antenna
mounted at a qualified specialist work-
shop. When operating RF transmitters in
the vehicle, always connect them with the
low-reflection exterior antenna.
!The operating permit may be invalidated
if the instructions for installation and use of RF transmitters are not observed.
In particular, the following conditions
must be complied with:
Ronly approved wavebands may be used.
Rcompliance with the maximum permissi-
ble output in these wavebands is
required.
Ronly approved antenna positions may be
used.
Excessive levels of electromagnetic radia-
tion may cause damage to your health and the
health of others. Using an exterior antenna
takes into account current scientific discus-
sions relating to the possible health hazards
that may result from electromagnetic fields.
The following antenna positions may be used
if RF transmitters have been properly instal- led:
204Vehicle electronics
>> Technical data.

Approved antenna positions
0043
Front roof area
0044Rear roof area
Use the Technical Specification ISO/TS 21609
when retrofitting RF transmitters (Road
Vehicles - EMC guidelines for installation of
aftermarket radio frequency transmitting
equipment). Observe the legal requirements
for retrofittings.
If your vehicle has fittings for two-way radio
equipment, use the power supply or antenna
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or antenna posi-
tions must be approved by smart.
iDamage or consequential damage arising
from retrofitting RF transmitters in the
vehicle, is not covered by the smart war-
ranty.
The maximum transmission output (PEAK) at
the base of the antenna must not exceed the
following values:
WavebandMaximum trans- mission output
Tetra
380 - 410 MHz20 W
Mobile communications
generation 2G/3G/4G6 W
The following can be used in the vehicle with-
out restrictions:
RRF transmitters with a maximum transmis-
sion output of up to 100 mW
RMobile phones (2G/3G/4G) There is no restriction for antenna positions
on the outside of the vehicle for the following
wavebands:
RTetra
RMobile communications (2G/3G/4G)
Identification plates
Vehicle identification plate with
vehicle identification number (VIN)
XOpen the driver's door.
You will see vehicle identification
plate
0043.
Example: vehicle identification plate (USA
only)
0044
Vehicle model
0087Paint code
Identification plates205
>> Technical data.
Z