technical data SMART FORTWO COUPE 2008 User Guide

Engine electronics
>> Technical data.
291
The transmitting power of the telephone or
radio must not exceed the following maximum
values.Frequency range
(band)
Maximum transmit

ting power (Watts)
Short wave (<50 MHz)
100
2 m wavelength
50
0.7 m wavelength
35
0.25 m wavelength
10
G
Warning!
Radio transmitters can interfere with the
vehicle's electronic system, endanger
the operating safety of the vehicle and
thus your own safety, if
• there is no external antenna
• the external antenna is not low
reflec

tion
• the external antenna is incorrectly in

stalled
Excessive electromagnetic radiation can
damage your health and that of others.
Using an external antenna addresses and
considers the concerns currently being
discussed in scientific circles about the
health hazards possibly posed by elec

tromagnetic fields.
Because of this, have the external anten

na installed exclusively at a qualified
specialist workshop which has the neces

sary specialist knowledge and tools to
carry out the work required, e.g. at a
smart center. In particular, work rele

vant to safety or on safety
related sys

tems must be carried out at a qualified
specialist workshop.

Engine electronics
292
>> Technical data.
On
board Diagnostics Socket
(OBD)The on
board diagnostics socket is located
inside the vehicle on the right side of the left
footwell.1
On
board diagnostics socket

Identification labels
>> Technical data.
293 Signs and labels
1
Air bag information signs
(sun visor)
2
VIN (engine compartment)
3
Emission control information label,
includes both federal and California
certification exhaust emission standards
(engine compartment)
4
Heat warning label (engine compartment)
5
Certification label (driver’s door B
pillar)
6
Tire and loading information placard
(driver’s door B
pillar)
7
VIN (lower edge of windshield)
Certification labelThe certification label is located on the
driver’s door B
pillar.1
Driver’s door B
pillar
>Open the driver's door.
i
Data shown on the example certification
label are for illustration purpose only. These
data are specific to each vehicle and may vary
from data shown in the illustration. Refer to
certification label on vehicle for actual data
specific to your vehicle.

Identification labels
294
>> Technical data. Example certification label (U.S. vehicles)
1
Vehicle I
dentification N
umber (VIN)Example certification label (Canada vehicles)
1
Vehicle I
dentification N
umber (VIN)
Vehicle Identification Number
(VIN)The V
ehicle I
dentification N
umber (VIN) can
be found in the following locations:
• on the certification label on the driver’s
door B
pillar (

page 293)
• on the rear right on the cargo compartment
floor (

page 295)
• in the lower edge of the windshield
(

page 293)

Identification labels
>> Technical data.
295
1
VIN (on the cargo compartment floor)
>Open the cargo compartment.
>Fold back the carpet.
Engine numberThe engine number is engraved into the
engine block. For more information, contact
any authorized smart center.i
When ordering parts, please specify
vehicle identification and engine number. P00.01
3349
31

Layout of poly
V
belt
296
>> Technical data. For dimensions of the poly
V
belt, see
"Engine" (

page 297).
All modelsVehicles with air conditioning with climate
control* have two poly
V
belts. The additional
poly
V
belt is shown in black. The standard
poly
V
belt is shown in purple.1
Automatic belt tensioner
2
Generator (alternator)
3
Coolant pump
4
Air conditioning compressor*
5
Crankshaft

Engine
>> Technical data.
297
Engine specifications
All models
1
1 The quoted data apply only to the standard vehicle. Contact an authorized smart center for the corresponding data of all special bodies and special equipment.Engine
M132
Mode of operation
4
stroke engine, gasoline injection
Number of cylinders
3
Valves per cylinder
4
Bore
2.83 in (72 mm)
Stroke
3.22 in (81.8 mm)
Total piston displacement
61 cu in (1 000 cm
3)
Compression ratio
10.0:1
Output acc. to SAE J 1349
70 hp/5 800 rpm
(52 kW/5 800 rpm)
Maximum torque acc. to SAE J 1349
68 lb
ft/4 500 rpm
(92 Nm/4 500 rpm)
Maximum engine speed
6400rpm
Firing order
1
2
3
Poly
V
belt
802 mm

Rims and tires
298
>> Technical data.
!
Only use tires which have been tested and
approved by smart. Tires approved by smart
are developed to provide best possible
performance in conjunction with the driving
safety systems on your vehicle such as ABS
or ESP
®.
Using tires other than those approved by
smart may result in damage that is not
covered by the smart Limited Warranty.
!
Using tires other than those approved by
smart can have detrimental effects, such as
• poor handling characteristics
• increased noise
• increased fuel consumption
Moreover, tires and rims not approved by
smart may, under load, exhibit dimensional
variations and different tire deformation
characteristics that could cause them to come
into contact with the vehicle body or axle
parts. Damage to the tires or the vehicle may
be the result.
i
Further information on tires and rims is
available at any authorized smart center.
A placard with the recommended tire inflation
pressure is located on the driver’s door
B
pillar (

page 185).
The tire inflation pressure should be checked
regularly and should only be adjusted on cold
tires. Follow tire manufacturer’s maintenance
recommendation included with vehicle.

Rims and tires
>> Technical data.
299
Rims and tires
Model pure
Model passion
Front axle:Rims (steel)
4.5 J x 15 H2
Rims (light alloy)
4.5 J x 15 H2*
4.5Jx15H2
Wheel offset
0.93 in (23.5 mm)
0.93 in (23.5 mm)
All
season tires
155/60 R15 74 T M+S
155/60 R15 74 T M+S
Winter tires
1
1 Not available as factory equipment
155/60 R15 74 T M+S
.
155/60 R15 74 T M+S
.
Rear axle:Rims (steel)
5.5 J x 15 H2
Rims (light alloy)
5.5 J x 15 H2*
5.5Jx15H2
Wheel offset
0.87 in (22 mm)
0.87 in (22 mm)
All
season tires
175/55 R15 77 T M+S
175/55 R15 77 T M+S
Winter tires
1
175/55 R15 77 T M+S
.
175/55 R15 77 T M+S
.

Electrical system
300
>> Technical data.
Electrical system
All models
Generator (alternator)
14 V/90 A
Starter motor
12 V/0.95 kW
Battery
12 V/42 Ah
Spark plugs
DENSO XU22 HDR9
Electrode gap
0.035 in (0.9 mm)
Tightening torque
11
15lb
ft(15
20Nm)