tow SMART FORTWO COUPE 2008 Owner's Guide

Towing
>> Practical hints.
279
!
Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension
parts.
!
Towing the vehicle with a base carrier*
mounted is not permissible. The vehicle must
not be towed by the base carrier*.
Towing eye boltThe towing eye bolt is located in the passen

ger’s footwell under the carpet.1
Towing eye bolt
>Unscrew the carpet holder in the
passenger’s footwell (

page 234).
>Lift the carpet.
>Take out towing eye bolt1.Covers
Depending on whether you are towing a vehi

cle or you are being towed, the towing eye bolt
can be screwed into threaded holes which are
located behind covers on the front and rear
bumper.
1
Front cover
G
Warning!
With the engine not running, there is no
power assistance for the brake and
steering systems. In this case, it is im

portant to keep in mind that a consider

ably higher degree of effort is necessary
to brake and steer the vehicle. Adapt
your driving accordingly.

Towing
280
>> Practical hints.
2
Rear cover
>Remove cover
1 or
2 using a suitable
object to reveal the threaded hole for the
towing eye bolt.Installing towing eye bolt
>Screw towing eye bolt in clockwise to its
stop and tighten with a suitable object.
G
Warning!
High outside temperature, stop
and
go
traffic, driving on long uphill grades, or
driving at high engine speed may increa

se the temperature in the engine com

partment. Therefore the area around the
air slots in the rear apron may be hot. Let
the engine cool off before touching this
area to prevent burns.P88.20
2930
31
G
Warning!
For safety reasons, recovery or lashing
down of the vehicle by means of the tow

ing eye is not allowed. Failure to observe
this could result in the towing eye being
ripped out of its mounting and people
being injured.

Towing
>> Practical hints.
281 Towing the vehicle
Towing with all wheels on the ground or front
axle raised: !
The vehicle may only be towed when:
• You are sure that no gear is engaged,
• the engine is shut off,
• the key is in starter switch position0.
>Set the parking brake.
>Secure the towing rope or tow bar to the
towing eye.
>Depress the brake pedal.
>Move the gear selector lever to neutral
positionN.appears in the transmission position
indicator.
>Turn the key in starter switch position0
>Release the parking brake.
>Release the brake pedal.