engine SMART FORTWO COUPE 2008 Workshop Manual

Engine compartment
174
>> Operation Adding engine oil
!
Only use approved engine oils and oil fil

ters required for vehicles with Maintenance
System. For a listing of approved engine oils
and oil filters contact an authorized smart
center.
Using engine oils and oil filters of specifica

tion other than those expressly required for
the Maintenance System, or changing of oil
and oil filter at change intervals longer than
those called for by the Maintenance System
will result in engine or emission control sys

tem damage not covered by the smart Limited
Warranty.The filler cap is located in the engine
compartment on the passenger side.
1
Filler cap
>Unscrew filler cap
1
from filler neck.
>Add engine oil as required.
Do not add more than 0.53 US qt (0.5 l)
engine oil at a time.
>Wait one minute until the engine oil has run
into the oil pan.
>Check the engine oil level once more.
>Add engine oil once more if necessary.
G
Warning!
When adding engine oil, always use a fun

nel to avoid spilling oil on any hot parts
such as the catalytic converter or ex

haust system.
If this should happen, however, the en

gine must be thoroughly cleaned before
you continue your trip. The engine oil
could otherwise ignite.P01.00
2852
31

Engine compartment
>> Operation
175
Be careful not to spill any oil when adding to
avoid environmental damage caused by oil
entering the ground and water.!
Excess engine oil must be siphoned or
drained off. It could cause damage to the
engine or emission control system not
covered by the smart Limited Warranty.
>Screw filler cap
1
back on filler neck.
>Close the engine compartment cover.

Front compartment
176
>> Operation
Service flapYou can remove the service flap and hang it on
the front of the vehicle so that it does not get
damaged or dirty.
!
Check the fill levels at regular intervals.
!
Carefully remove ice, snow, and any other
deposits from the air intake grilles above the
service flap to ensure air intake at all times.>Park the vehicle on level ground.
>Turn off the engine.
>Set the parking brake.
1
Lever
2
Service flap
>Removing: Fold both levers
1 outwards in
the direction of the arrows.
Service flap
2 is unlocked.
>Lift service flap2 at the front.
>Remove service flap2.
G
Warning!
Always turn key in starter switch to
position0 and remove the key from the
starter switch before opening the ser

vice flap.
If the windshield wipers should inadvert

ently be switched on, you could be seri

ously injured by the wiper washer drive,
which is located just below the service
flap.
G
Warning!
Make sure that the service flap is locked
while driving. Otherwise, the service flap
could become detached and pose a haz

ard to you or others.G
Warning!
To help prevent personal injury, stay
clear of moving parts when the service
flap is open.
The radiator fan may continue to run for
approximately 30 seconds or may even
restart after the engine has been turned
off. Stay clear of fan blades.

Front compartment
178
>> Operation
Coolant
The engine coolant is a mixture of water and
anticorrosion/antifreeze.
To check the coolant level the vehicle must be
parked on level ground and the engine must
have cooled down. For more information, see
"Coolants" (

page 309).Checking coolant level
The coolant reservoir is located in the front
compartment on the driver’s side.
1
Pressure cap
2
Marking bar
G
Warning!
In order to avoid potentially serious
burns:
• Use extreme caution when opening the
service flap if there are any signs of
steam or coolant leaking from the
cooling system, or if the coolant
temperature warning lampD in the
instrument cluster indicates that the
coolant is overheated.
• Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid
and is under pressure.
• Using a rag, slowly open the cap ap

proximately
1/2 turn to relieve excess
pressure. If opened immediately,
scalding hot fluid and steam will be
blown out under pressure.
P20.30
2265
31

Winter driving
208
>> Operation Before the onset of winter, have your vehicle
winterized at an authorized smart center. This
service includes:
>Check of anticorrosion and antifreeze
concentration.
• Addition of washer concentrate to the water
of the windshield/rear window.
Use a windshield washer concentrate la

beled for winter which is formulated for
temperatures below freezing point
(
page 308).
• Battery test. Battery capacity drops with
decreasing ambient temperature. A well
charged battery helps to make sure that the
engine can be started, even at low ambient
temperatures.
• Tire change.
Winter tiresAlways use winter tires at temperatures
below 45°F (7°C) and whenever wintry road
conditions prevail. Not all M+S rated tires
provide special winter performance. Make
sure the tires you use show the mountain/
snowflake marking.on the tire sidewall.
These tires meet specific snow traction
performance requirements of the Rubber
Manufacturers Association (RMA) and the
Rubber Association of Canada (RAC) and have
been designed specifically for use in snow
conditions. Use of winter tires is the only way
to achieve the maximum effectiveness of the
ABS and ESP
® in winter operation.
For safe handling, make sure that all mounted
winter tires are of the same make and have the
same tread design.Always observe the speed rating of the winter
tires installed on your vehicle. If the maximum
speed for which your tires are rated is below
the speed rating of your vehicle, you must
place a notice to this effect where it will be
seen by the driver. Such notices are available
at your tire dealer or any authorized smart
center.
G
Warning!
Winter tires with a tread depth of less
than
1/6 in (4 mm) must be replaced. They
are no longer suitable for winter opera

tion.

Driving instructions
>> Operation
211 Drinking and driving Pedals Power assistance
G
Warning!
Do not drink alcohol or take drugs and
drive or allow anyone to drive who has
been drinking alcohol or taking drugs.
Even a small amount of alcohol or drugs
can affect your reflexes, perceptions and
judgment.
The possibility of a serious or even fatal
accident greatly increased when you
drink or take drugs and drive.
G
Warning!
Make sure that absolutely no objects are
obstructing the pedals’ range of move

ment. Keep the driver’s footwell clear of
all obstacles. If there are any floormats
or carpets in the footwell, make sure that
the pedals still have sufficient clearance.
During sudden driving or braking maneu

vers, the objects could get caught be

tween or beneath the pedals and restrict
your ability to brake or accelerate. This
could lead to accidents and injury.
G
Warning!
Without the engine running, there is no
power assistance for the brake and the
steering* systems. In this case, it is im

portant to keep in mind that a consider

ably higher degree of effort is necessary
to brake and steer the vehicle.

Driving instructions
212
>> Operation
BrakesRefer to the description of the hydraulic
brake assistant (

page 75).
!
Because the ESP
® operates automatically,
the engine must be shut off (key in starter
switch position0) when
• the parking brake is being tested on a
brake test dynamometer
• the vehicle is being towed with the front
axle raised
Active braking action through the
ESP
® may
otherwise seriously damage the brake system
which is not covered by the smart Limited
Warranty.Brake pad wear or a leak in the brake system
may be the reason for low brake fluid level in
the brake fluid reservoir.
The brake fluid level in the brake fluid
reservoir may be too low if the brake warning
lamp in the instrument cluster comes on
(

page 34) although the parking brake is
released.
Have the brake system inspected immediately.
Contact an authorized smart center.
All checks and service work on the brake
system should be carried out by qualified
technicians only. Contact an authorized smart
center.
Only install brake pads and use brake fluid
recommended by smart.Inclines
!
When driving down long and steep grades,
relieve the load on the brakes by shifting into
a lower gear to use the engine’s braking
power. This helps prevent overheating of the
brakes and reduces brake pad wear.
When using the engine’s braking power, a
drive wheel may not spin for an extended pe

riod of time, e.g. on slippery road surfaces.
This may cause serious damage to the drive

train which is not covered by the smart
Limited Warranty.
G
Warning!
Make sure not to endanger any other
road users when carrying out braking
maneuvers.

Driving instructions
>> Operation
215 Drive sensibly
save fuel
Fuel consumption, to a great extent, depends
on driving habits and operating conditions.
To save fuel you should:
• Shift gears in a timely manner.
• Avoid frequent acceleration and decelera

tion.
• Keep tires at the recommended inflation
pressures.
• Remove carriers* when not in use.
• Remove unnecessary loads.
• Allow engine to warm up under low load use.
• Have all maintenance work performed at the
intervals specified in the Maintenance
Booklet and as required by the Maintenance
System. Contact an authorized smart cen

ter.
Fuel consumption is also increased by driving
in cold weather, in stop
and
go traffic, on
short trips, and in hilly areas.
Catalytic converterYour smart is equipped with monolithic
type
catalytic converter, an important element in
conjunction with the oxygen sensors to
achieve substantial control of the pollutants
in the exhaust emissions. Keep your vehicle in
proper operating condition by following our
recommended maintenance instructions as
outlined in your Maintenance Booklet.
G
Warning
The catalytic converter can become very
hot. Coming into contact with the catalytic
converter could result in burns.
Note the following:
• Do not remove the protective heat
guards.
• Do not apply any underseal.
• As with any vehicle, do not idle, park, or
operate this vehicle in areas where
combustible materials such as grass,
hay, or leaves can come into contact
with the hot exhaust system, as these
materials could be ignited and cause a
vehicle fire.

Driving instructions
216
>> Operation
!
To prevent damage to the catalytic
converter, only use premium unleaded gaso

line in this vehicle.
Any noticeable irregularities in engine oper

ation should be repaired promptly. Otherwise,
excessive unburned fuel may reach the cata

lytic converter, causing it to overheat and
potentially start a fire.
It is essential to observe the following points,
as there is otherwise a danger of overheating
and the catalytic converter may be damaged.
• Fill up only with premium unleaded gasoline.
Even small quantities of leaded gasoline can
damage the catalytic converter.
• Make sure you adhere to the prescribed
service intervals.
• Never run the fuel tank empty.
• If the engine starts to misfire, bring the ve

hicle to an immediate standstill without en

dangering traffic.
• If the engine fails to start the first time, you
should not try to start it any more than
three times in succession.
• Do not try to start for more than four sec

onds at a time.
TiresTreadwear indicators (TWI) are required by
law. These indicators are located in six places
on the tread circumference and become visi

ble at a tread depth of approximately
1/16in
(1.6 mm), at which point the tire is considered
worn and should be replaced. The treadwear indicator appears as a solid
band across the tread.
Specified tire inflation pressures must be
maintained. This applies particularly if the
tires are subject to high loads (e.g. high
speeds, heavy loads, high ambient tempera

tures).
G
Warning!
If you feel a sudden significant vibration
or ride disturbance, or you suspect that
possible damage to your vehicle has
occurred, you should turn on the hazard
warning flashers, carefully slow down,
and drive with caution to an area which is
a safe distance from the road.
Inspect the tires and the vehicle under

body for possible damage. If the vehicle
or tires appear unsafe, have the vehicle
towed to the nearest smart center or tire
dealer for repairs.
G
Warning!
Although the applicable federal motor
vehicle safety laws consider a tire to be
worn when the treadwear indicators (TWI)
become visible at approximately
1/16in
(1.6 mm), we recommend that you do not
allow your tires to wear down to that
level. As tread depth approaches
1/8in
(3 mm), the adhesion properties on a wet
road are sharply reduced.
Depending upon the weather and/or road
surface (conditions), the tire traction
varies widely.

Driving instructions
>> Operation
219
Road salts and chemicals can adversely affect
braking efficiency. Increased pedal force may
become necessary to produce the normal
braking effect.
Depressing the brake pedal periodically when
traveling at length on salt
strewn roads can
bring road
salt
impaired braking efficiency
back to normal.
If the vehicle is parked after being driven on
salt
treated roads, the braking efficiency
should be tested as soon as possible after
driving is resumed.For more information, see "Winter driving"
(

page 208).
Standing water!
Do not drive through flooded areas or
water of unknown depth. Before driving
through water, determine its depth. Never
accelerate before driving into water. The bow
wave could force water into the engine and
auxiliary equipment, thus damaging them.
If you must drive through standing water,
drive slowly to prevent water from entering
the passenger compartment, the front com

partment, or the engine compartment. Water
in these areas could cause damage to electri

cal components or wiring of the engine or
transmission, or could result in water being
ingested by the engine through the air intake,
causing severe internal engine damage.
Any such damage is not covered by the smart
Limited Warranty.
G
Warning!
Make sure not to endanger any other
road users when carrying out these
braking maneuvers.
G
Warning!
If the vehicle becomes stuck in snow,
make sure snow is kept clear of the
exhaust pipe and from around the vehicle
with the engine running. Otherwise,
deadly carbon monoxide (CO) gases may
enter vehicle interior resulting in uncon

sciousness and death.
To assure sufficient fresh air ventilation,
open a window slightly on the side of the
vehicle not facing the wind.G
Warning!
The outside temperature display is not
designed to serve as an ice
warning
device and is therefore unsuitable for
that purpose. Indicated temperatures
just above the freezing point do not
guarantee that the road surface is free of
ice.