fuel type SMART FORTWO COUPE 2008 Owners Manual
[x] Cancel search | Manufacturer: SMART, Model Year: 2008, Model line: FORTWO COUPE, Model: SMART FORTWO COUPE 2008Pages: 314, PDF Size: 4.41 MB
Page 170 of 314
At the gas station
>> Operation
169 Refueling
!
Do not put diesel in vehicles with gasoline
engines. Do not mix gasoline with diesel. Even
small quantities of diesel will damage the in
jection system. Damage caused by adding die
sel will not be covered by the smart Limited
Warranty.
If diesel has mixed with gasoline, do not start
the engine. Otherwise the catalytic converter
will be irreparably damaged.
Contact an authorized smart center or Road
side Assistance immediately and have the ve
hicle towed.
!
Damage resulting from mixing gasoline
with diesel fuel is not covered by the smart
Limited Warranty.
The fuel filler flap is located on the passenger
side towards the rear.
Locking/unlocking the vehicle with the key
automatically locks/unlocks the fuel filler flap.
i
In case the central locking system does
not release the fuel filler flap, or the opening
mechanisms is clamping, contact Roadside As
sistance or an authorized smart center.
1
Opening the fuel filler flap
2
Tether
3
Fuel type label
G
Warning!
Gasoline is highly flammable and poison
ous. It burns violently and can cause
serious personal injury.
Never allow sparks, flame or smoking
materials near gasoline!
Turn off the engine before refueling.
Never allow fire, sparks, flame, or com
bustible materials near gasoline!
Direct skin contact with gasoline and the
inhalation of gasoline vapors are damag
ing to your health.
Page 205 of 314
Tires and wheels
204
>> Operation Tire ply material
1
Plies in sidewall
2
Plies under tread
i
For illustration purposes only. Actual data
on tires are specific to each vehicle and may
vary from data shown in above illustration.
This marking tells you about the type of cord
and number of plies in the sidewall and under
the tread.
Tire and loading terminologyAccessory weight
The combined weight (in excess of those stan
dard items which may be replaced) of auto
matic transmission, power steering, power
brakes, power windows, power seats, radio,
and heater, to the extent that these items are
available as factoryinstalled equipment
(whether installed or not).
Air pressure
The amount of air inside the tire pressing
outward on each square inch of the tire.
Air pressure is expressed in pounds per
square inch (psi), or kilopascal (kPa) or bars.
Aspect ratio
Dimensional relationship between tire section
height and section width expressed in per
centage.Bar
Another metric unit for air pressure. There
are 14.5038 pounds per square inch (psi)
to 1 bar; there are 100 kilopascals (kPa)
to 1 bar.
Bead
The tire bead contains steel wires wrapped by
steel cords that hold the tire onto the rim.
Cold tire inflation pressure
Tire inflation pressure when your vehicle has
been sitting for at least 3 hours or driven no
more than 1 mile (1.6 km).
Curb weight
The weight of a motor vehicle with standard
equipment including the maximum capacity of
fuel, oil, and coolant, and, if so equipped, air
conditioning and additional optional equip
ment, but without passengers and cargo.
Page 216 of 314
Driving instructions
>> Operation
215 Drive sensibly save fuel
Fuel consumption, to a great extent, depends
on driving habits and operating conditions.
To save fuel you should:
• Shift gears in a timely manner.
• Avoid frequent acceleration and decelera
tion.
• Keep tires at the recommended inflation
pressures.
• Remove carriers* when not in use.
• Remove unnecessary loads.
• Allow engine to warm up under low load use.
• Have all maintenance work performed at the
intervals specified in the Maintenance
Booklet and as required by the Maintenance
System. Contact an authorized smart cen
ter.
Fuel consumption is also increased by driving
in cold weather, in stopandgo traffic, on
short trips, and in hilly areas.
Catalytic converterYour smart is equipped with monolithictype
catalytic converter, an important element in
conjunction with the oxygen sensors to
achieve substantial control of the pollutants
in the exhaust emissions. Keep your vehicle in
proper operating condition by following our
recommended maintenance instructions as
outlined in your Maintenance Booklet.
G
Warning
The catalytic converter can become very
hot. Coming into contact with the catalytic
converter could result in burns.
Note the following:
• Do not remove the protective heat
guards.
• Do not apply any underseal.
• As with any vehicle, do not idle, park, or
operate this vehicle in areas where
combustible materials such as grass,
hay, or leaves can come into contact
with the hot exhaust system, as these
materials could be ignited and cause a
vehicle fire.