remote control SSANGYONG KORANDO 2012 User Guide

03-50
Disarming by REKES remote control 2.
When unlocking the doors or turning the ignition switch to ON position.
When receiving the door unlock signal in theft deterrent mode, all doors are unlocked and the turn
signal lamps blink once (the horn does not sound).
When receiving the door unlock signal with the theft deterrent mode disarmed, the turn signal
lamps blink once (the horn does not sound). -
-
-
In theft deterrent mode
BCM observes the conditions below continuously: 3.
Battery connection (B+)
Front/rear door open
Tailgate open
4 doors lock/unlock
Engine hood open -
-
-
-
-
Activation of theft deterrent alarm 4.
When any of doors, tailgate or engine hood is open in theft deterrent mode
When unlocking the door lock switch in theft deterrent mode
When opening a door after completion of theft deterrent alarm (for 30 seconds)
Horn and the turn signal lamps operate for 30 seconds with the interval of 0.5s ON/0.5s OFF. -
-
-
-
Disarming conditions of theft deterrent mode 5.
When pressing any switch (lock, unlock, panic) on the remote control key during the theft deterrent
alarm, the alarm stops its operation.
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops its
operation.
(For vehicle with immobilizer system, the alarm stops after completion of authorization. For vehicle
without immobilizer system, the alarm stays ON for 30 seconds)
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops
and the theft deterrent mode is deactivated after 30 seconds (remaining time).
If there is not any disarming commend, the alarm stays ON for 30 seconds and the theft deterrent
mode continues. -
-
-
-
Operation when disarming 6.
The horn and the turn signal lamps stop their operation. -

03-52
Theft deterrent alarm control in BCM with SKM ▶
Entering into theft deterrent mode by smart key remote control 1.
When receiving the door lock signal from the smart key remote control with power OFF or ACC ON
and tailgate and engine hood closed, the doors are locked and the theft deterrent mode is
activated. At this time, the turn signal lamps blink twice and the exterior buzzer sounds once at
interval with 50 ms ON/50 ms OFF. (SKM turns off the vehicle and sends the signal, when ACC
ON)
The BCM unlock the doors immediately after locking them first without operating turn signal lamp
and exterior buzzer and the system does not enter into theft deterrent mode, if the door lock signal
is received from the smart key remote control when the driver door is unlocked and any of doors is
open.
The BCM locks all the doors and system does not enter into theft deterrent mode if all the doors are
closed when the door lock signal is received from the smart key remote control with the tailgate and
engine hood open. However, if the tailgate and engine hood is closed, the turn signal lamps blink
twice, exterior buzzer sounds once and theft deterrent mode is entered.
If all the doors, tailgate or engine hood is open or the ignition switch is not turned to ON position
within 30 seconds after receiving the door unlock signal from the smart key remote control, the
doors are locked, turn signal lamps blink twice, exterior buzzer sounds once and theft deterrent
mode is re-activated.
The theft deterrent mode can be activated only when the above conditions are satisfied, excepting
manual lock.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-

03-538710-01
Entering into theft deterrent mode by SKM passive entry 2.
When receiving the signal from the outside door handle switch with power OFF or ACC ON,
tailgate and engine hood closed and driver door unlocked, the doors are locked and the theft
deterrent mode is activated. At this time, the turn signal lamps blink twice and the exterior buzzer
sounds once at interval with 50 ms ON/50 ms OFF. (SKM turns off the vehicle and sends the
signal, when ACC ON)
The BCM unlock the doors immediately after locking them first without operating turn signal lamp
and exterior buzzer and the system does not enter into theft deterrent mode, if the door lock signal
is received from the outside door handle switch when the driver door is unlocked and any of doors
is open.
The BCM locks all the doors and system does not enter into theft deterrent mode if all the doors
are closed when the door lock signal is received from the outside door handle switch with the
tailgate and engine hood open. However, if the tailgate and engine hood is closed, the turn signal
lamps blink twice, exterior buzzer sounds once and theft deterrent mode is entered.
If all the doors, tailgate or engine hood is open or the ignition switch is not turned to ON position
within 30 seconds after receiving the door unlock signal from the outside door handle switch with
the driver door locked, the doors are locked, turn signal lamps blink twice, exterior buzzer sounds
once and theft deterrent mode is re-activated.
The theft deterrent mode can be activated only when the above conditions are satisfied, excepting
lock by smart key remote control signal.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-

03-54
Disarming 3.
If the door unlock signal is received from the smart key remote control with power OFF or the
outside door handle switch signal is received with the driver door locked, the doors are unlocked,
turn signal lamps blink once, exterior buzzer sounds twice at the intervals with 50 ms ON/450 ms
OFF and theft deterrent mode is deactivated. When receiving the door unlock signal with the theft
deterrent mode disarmed, the turn signal lamps blink and exterior buzzer sounds.
When tailgate is open by tailgate open switch signal (only tailgate disarmed)
When verified smart key is detected and manual tailgate is open by tailgate open switch signal
(only tailgate disarmed)
When ignition switch is turned to ON position -
-
-
-
In theft deterrent mode
BCM observes the conditions below continuously: 4.
Battery connection (B+)
Front/rear door open
Tailgate open
4 doors lock/unlock
Engine hood open -
-
-
-
-
Activation of theft deterrent alarm 5.
When any of doors, tailgate or engine hood is open in theft deterrent mode
When unlocking the door lock switch in theft deterrent mode
When opening a door after completion of theft deterrent alarm (for 30 seconds)
Horn and the turn signal lamps operate for 30 seconds with the interval of 0.5s ON/0.5s OFF. -
-
-
-
Warning cancellation requirements 6.
The theft deterrent alarm is deactivated by the following BCAN signals during its operation: (theft
deterrent mode maintains) -
When door is unlocked by smart key remote control
When door is locked by smart key remote control
When tailgate is open by smart key remote control
When passive door is unlocked due to smart key detection
When tailgate is open due to smart key detection
When panic alarm is activated by smart key remote control 1)
2)
3)
4)
5)
6)
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops
immediately.
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops and
the theft deterrent mode is deactivated after 30 seconds (remaining time).
If there is not any disarming commend, the alarm stays ON for 30 seconds and the theft deterrent
mode continues. -
-
-

03-678710-01
24) Buzzer Control
Priority are as follows:With SKM ▶
Approach lamp ON 1.
When turning the ignition switch to OFF from ON position and opening the driver door, the
approach lamps come ON.
When receiving the UNLOCK signal from the smart key remote control or outside door handle
switch signal in the theft deterrent mode, the approach lamps come ON for 30 seconds.
When receiving the AUTO approach signal in the theft deterrent mode, the approach lamps
come ON for 30 seconds. -
-
-
Approach lamp OFF 2.
When receiving the door lock signal from the smart key remote control or outside door handle
switch signal with the approach lamps ON, the lamps go OFF (reactivation of theft deterrent
mode).
When turning the ignition switch to ON position with the approach lamps ON, the lamps go OFF.
The approach lamps go OFF after 30 seconds. -
-
-

03-68
2. IMMOBILIZER/REMOTE CONTROL KEY CODING
1) System Overview
While the communication between BCM/SKM and ECU is based on the CAN communication, the
communication between transponder and BCM/SKM is based on LF (Low frequency) and RF (Radio
frequency). When the ignition switch is turned to ON position, the BCM checks the verified transponder
according to the immobilizer verification procedure, if correct, allows the vehicle to start the engine. The
immobilizer indicator comes on during the communication and if the verification is carried out
successfully the indicator goes off.
If there is something wrong in the system, the indicator blinks.
2) System Layout

03-70
4) Components of REKES Key
Battery cover
Side & main cover Battery: CR2032TransponderKey plate Remote control PCB
How to replace battery ▶
Remove the battery cover using a flat screwdriver to replace the battery.
How to replace transponder ▶
Remove battery cover and battery
Remove rubber cover and screw then remove key plate
Remove side cover and main cover
Replace transponder -
-
-
-
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove, damage
or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. -
-
-
-
-

04-4
1. SYSTEM LAYOUT
The vehicles with smart key system are equipped with the SKM (Smart Key Module) unit. The SKM,
which does not use the traditional key or remote controller to access the vehicle, provides 3 functions.
The passive UNLOCK function unlocks the door after confirming the smart key information and the
driver's door conditions when the driver carrying a smart key touches the door handle. The passive
START function starts the engine when the START switch is pressed by the driver sitting on the driver's
seat. The passive LOCK function locks the door when the door handle switch is pressed by the driver
after exiting the vehicle.
Buzzer
Start switch
SKM unit
Outside door handle
switch and antenna

04-178712-03
3) REKES Control Function
(2) REKES UNLOCK
The SKM receives the signal for [REKES UNLOCK] 0.1 sec. after the UNLOCK button on the smart
key is turned ON, and sends this signal through the BCAN. - When the SKM receives the REKES signals by the buttons on the smart key, it transmits the
corresponding signals through the BCAN.
Switch Stage Remark
LOCK 1 step
100 ms: 1 step CMD
1500 ms: 2 step CMD
1000 ms: 3 step CMD unlocked 1 step
Tailgate open 3 step
PANIC 3 step
(3) Remote keyless tailgate open
When the SKM receives the signal for [REKES UNLOCK] by the UNLOCK button on the smart key, it
transmits this signal through the BCAN.
(1) REKES LOCK
The SKM receives the signal for [REKES LOCK] 0.1 sec. after the LOCK button on the smart key is
turned ON, and it transmits this signal through the BCAN.
When the REKES LOCK signal is received with the ACC ON, the ACC is turned OFF and the signal
for [REKES LOCK] is sent. -
- When the SKM receives the signal for [REKES LOCK] by the LOCK button on the smart key, it transmits
this signal through the BCAN.
The SKM receives the tailgate open signal 1 sec. after the tailgate open button on the smart key is
turned ON with the ignition status OFF, ACC or IGN ON, and it transmits the signal for [REKES
tailgate open] through the BCAN. - When the SKM receives the signal for [REKES tailgate open] by the tailgate open button on the smart
key, it transmits this signal through the BCAN.
Remote keyless tailgate open ▶

04-18
(4) Remote keyless panic
When the SKM receives the panic signal with the ignition status OFF, ACC ON or IGN ON, the SKM
transmits the REKES panic signal through the BCAN. The SKM transmits the signals for [REKES panic] by the panic button of the smart key to the BCM.
Panic siren mode by REKES panic control ▶ The SKM receives the REKES panic signal 1 sec. after the panic button on the smart key is turned ON
with the ignition status OFF, ACC or IGN ON, and it transmits this signal through the BCAN.Remote keyless panic ▶