door SSANGYONG KORANDO 2013 Service Manual

0000-00
Luggage lampDoor courtesy lamp
Center room lamp

Hazard warning switch
bezel assembly
Drive door main switch
& Outside rearview mirror
switch
FATC switch
Steering wheel remote
control switchPassenger door switch
Lower main panel
switch
Start/stop switch
Cruise control switch
Multifunction switch
3. SWITCH SYSTEM LAYOUT

0000-00
Luggage lamp switch
Overhead console
switchFront seat heating and ventilation switch
With heating and ventilation
switchWith heating switch
Driver power seat
switch
Center room lamp
switch
Rear door switch (RH)Rear door switch (LH)
Tailgate switch

8710-01
1. SPECIFICATIONS
Item Conditions Description
Rated voltage 13.5 V
Operating voltage 9.0 V to 16.0 V
(CAN communication: 7.0 V to 18.0 V)Should be operated normally within
this range.
Operating
temperature
Should be operated normally within
this range.
Storage temperature
Max. operating
humidity95%
Dark current BCM without SKM: 7.0 mA or less
BCM with SKM: 4.0 mA or lessAll switches turned OFF, Key
removed, entering sleep mode after
all doors are locked

2. INPUT SIGNALS
NO Input signal Logic
1 IGN1 ON = Battery voltage (IGN ON or START)
2 IGN2 ON = Battery voltage (IGN ON)
3 Alternator ON = Battery voltage (engine running)
4 Key reminder switch IN = Battery voltage (key inserted)
5 Driver door LOCK detecting switch LOCK = GND, UNLOCK = OPEN
6 Driver door UNLOCK detecting switch LOCK = OPEN, UNLOCK = GND
7 Passenger door LOCK detecting switch LOCK = GND, UNLOCK = OPEN
8 Passenger door UNLOCK detecting
switchLOCK = OPEN, UNLOCK = GND
9 Rear door LOCK detecting switch LOCK = OPEN, UNLOCK = GND
10 Puddle lamp ON = (-) OUTPUT
11 Driver door open switch OPEN = GND, CLOSE = OPEN
12 Passenger door open switch OPEN = GND, CLOSE = OPEN
13 Rear LH door open switch OPEN = GND, CLOSE = OPEN
14 Rear RH door open switch OPEN = GND, CLOSE = OPEN
15 Tailgate switch OPEN = GND, CLOSE = OPEN
16 Hood switch OPEN = GND, CLOSE = OPEN
17 Sunroof switch OPEN = GND, CLOSE = OPEN
18 headlamp switch ON = GND, OFF = OPEN
19 Folding/unfolding switch ON = GND, OFF = OPEN
20 Crash door LOCK/UNLOCK switch ON = GND, OFF = OPEN
21 Crash sensor (air bag) ON = 200 ms Low signal, OFF = OPEN
22 Front defogger (heated wire) switch ON = GND, OFF = OPEN
23 Rear defogger (heated wire) switch ON = GND, OFF = OPEN
24 Wiper switch 1 ON = GND, OFF = OPEN
25 Wiper switch 2 ON = GND, OFF = OPEN
26 Driver seat belt switch Unbuckled = GND, Fastened = OPEN
27 Passenger seat belt switch (only EU) Unbuckled = GND, Fastened = OPEN
28 Rain & AUTO light sensor LIN communication

3. MAJOR FUNCTIONS
Item Functionw/o SKM w/ SKM
1 WIPER CONTROL Wiper MIST and washer coupled wiper O O
AUTO washer coupled wiper operation O O
Rain sensor coupled wiper (LIN) O O
Speed sensitive intermittent wiper O O
Wiper LO/HI control O O
2 Ignition key warning
lampIgnition key reminder warning O X
Ignition key reminder O X
External buzzer control X O
Door LOCK prevention function when a door
is ajarOO
3 Tail lamp control Tail lamp switch ON warning O O
Tail lamp warning display X O
Tail lamp AUTO switching off O O
4 Door ajar warning Door ajar control X O
Door ajar warning O O
5 Seat belt control Seat belt warning O O
Seat belt reminder O O
6 Sunroof warning Sunroof warning O O
Sunroof warning display X O
7 Room lamp control Door coupled room lamp dim control O O
Room lamp AUTO switching off O O
Room lamp control display X O
8 Ignition key hole lamp Ignition key hole lamp control O X
9 Defogger (heated wire)
controlFront defogger (heated wire) control O O
Rear defogger (heated wire) control O O

8710-01
Item Functionw/o
SKMw/ SKM
10 Ignition key remote
control functionTransmitter function O X
Remote control door LOCK O X
Remote control door UNLOCK O X
Remote control panic O X
Remote control escort O X
AUTO door LOCK after 30 seconds O X
11 Door
LOCK/UNLOCK
controlDoor LOCK/UNLOCK control by door knob switch O O
Door LOCK/UNLOCK control by center door LOCK
switchOO
Door LOCK/UNLOCK control by REKES key signal O X
Door LOCK/UNLOCK control by smart key X O
Door LOCK/UNLOCK control by door handle switch
(passive entry)XO
AUTO door LOCK control O O
AUTO UNLOCK upon receiving air bag deployment
signalOO
12 Panic alarm Panic alarm control by REKES key signal O X
Panic alarm control by smart key signal X O
13 Tailgate control Tailgate open control
(for vehicles without SKM)OX
Tailgate open control
(for vehicles with SKM)XO
14 Theft deterrent
alarm controlTheft deterrent alarm control (for vehicles without
SKM)OX
Theft deterrent alarm control (for vehicles with SKM) X O
15 Time lag window
controlTime lag power window control O O

8710-01
4. WITH SKM VS. WITHOUT SKM
BCM (BODY CONTROL MODULE)
BCM (Body Control Module) inputs/outputs data from various switches, sensors, and other modules
through the hard wire and CAN communication, and controls the body and electronic system of the
vehicle.
For the vehicles with SKM, the SKM unit communicates with BCM through B-CAN. It sends the door
LOCK/UNLOCK signal by smart key, theft deterrent mode signal, and passive entry signal, etc. to the
BCM to control each module. The signals for engine running and stopping controls are sent to the EMS
(ECU) through the P-CAN.
For the vehicles without SKM, the BCM receives door LOCK/UNLOCK signal by smart key, theft
deterrent mode signal, and passive entry signal, etc. directly from the modules to control them. The
BCM controls the engine running and stopping by sending the corresponding signals to the EMS (ECU)
after verifying the ignition key. The controls for other modules may vary depending on the vehicle
specifications.

Internal buzzer (chime) operation for ignition key reminder
When the driver door is opened with the ignition key inserted, the internal buzzer (chime) is operated
for 10 seconds at intervals of 0.02 sec. ON/1.38 sec. OFF. A. Operation 1.
When the ignition key is removed or the driver door is closed while the internal buzzer (chime) is
activated for up to 10 seconds, the buzzer is deactivated. B. Operation 2.
5. IGNITION KEY REMINDER
The 2 operations stated above are not available after the ignition is turned ON. C. Operation 3.
This function overrides the tail lamp switch warning function.

Ignition key reminder operation
The door LOCK switch is in LOCK position after the driver door is opened with the ignition key
inserted.
The UNLOCK signal is output for 0.5 seconds (T2) immediately after the LOCK signal output. A.
B. Operation 1.
The door LOCK switch is in LOCK position within 0.5 seconds (T1) after the door is closed with the
ignition key inserted.
The UNLOCK signal is output for 0.5 seconds (T2) immediately after the LOCK signal output. C.
D. Operation 2.
The door LOCK switch is in LOCK position after the driver door is opened with the ignition key
inserted.
The door UNLOCK signal is not output when the ignition key is removed during the door LOCK
output. E.
F. Operation 3.
Operating process