center console SSANGYONG MUSSO 2003 Service Manual
[x] Cancel search | Manufacturer: SSANGYONG, Model Year: 2003, Model line: MUSSO, Model: SSANGYONG MUSSO 2003Pages: 1574, PDF Size: 26.41 MB
Page 1201 of 1574

SUPPLEMENTAL RESTRAINT SYSTEM(SRS) 8B-21
AIR BAG CONTROL UNIT(AC4) Removal & Installation Procedure AC4 is installed on the center portion of the front floor tunnel.
Built-in accelerometer sensor detects collision and determines action or non-action and ignition time. Notice
Do not disassemble the AC4 to repair. If defective, replace it. AC4 should not be shocked or vibrated by dropping on the ground or bumping. Replace the AC4 with new after air bag inflation.
1. Disconnect the negative battery cable and wait for 30seconds before starting service. Notice Though battery cable is disconnected, air bag control unit will maintain backup power for 150ms and air bag can beinflated, so wait for min.30 seconds.
2. Remove the console box and center fascia panel assembly.
3. Remove the heater control switch and audio assembly.
4. Remove the lower side panel of the driver ’ s portion and glove box.
5. Remove the lower main panel.
6. Release the lock lever of the AC4 connector and disconnect the connector.
7. Unscrew 3 nuts and remove the AC4.
NoticeFor installation, horizontal position should be secured for the better changes of collision pulse between the vehiclebody and air bag control unit.
8. Installation should follow the removal procedure in the reverse order.
Inspection Procedure
1. Check AC4 case and welt bolts for crack or deformation.
2. Check connector, lock lever and terminal for deformation. NoticeReplace the AC4 with new if dust, deformation or corrosion found.
Page 1306 of 1574

9U-10 CONTROL UNITS AND SYSTEMMAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
STICS STICS, electonic control warning device, controls 16 functions and contains the self diagnostic function detecting any malfunctions in the sensors and load. Removal & Installation Procedure
1. Disconnector the battery negative cable.
2. Unscrew 4screw from center console box.
3. Remove the center console box and disconnect 3 STICS connectors.
4. Unscrew 3 fastening bolts and remove the STICS unit.
5. Installation should follow the removal procedure in the reverse order.
1 STICS Unit
2 STICS Connector 3 STICS Unit Fastening Bolt
4 Parking Brake Lever
Page 1353 of 1574

POSITION OF CONNECTORS AND GROUNDS 2-3
C361 C371C381C401C402C403 22
88626 White
ColorlessColorlessColorlessColorlessColorless Main - Co-Driver DoorFloor - Rear Left DoorFloor - Rear Right DoorFloor - Tail GateFloor - Tail GateFloor - Tail Gate
Inside Co-Driver Side Cowl PanelCenter 'B' PillarCenter Left 'B' PillarBehind The Left LampBehind The Left LampBehind The Left Lamp
2. CONNECTOR, GROUND AND SPLICE PACK INFORMATION
1) CONNECTOR
Connector
Number Connecting Wiring HarnessConnector PositionColorPin
Number
C101 C102C103C104C105C106C107 C108 C109C110C111C112C201C203C204C205 C206
C206B C207 C208C208
C208B C209C210C211C212 C213 C251C301C302C303 C304 C305 C351212 2
15 143 2
16 6
40 6 84
10 33
4 [6]
1616121584
1417 6 3
20 1614 12 6
22 Colorless Colorless
WhiteBlackBlackBlackBlack Black BlackBlackBlack Gray
White
Colorless WhiteBlackBlack Black BlackBlackBlackBlackBlackBlackBlack
White
Colorless Black
White WhiteWhite
Colorless White
Blue Main - Engine Main - EngineMain - EngineEngine - MainEngine - EngineGenerator - EngineGenerator - Engine Genertor - Engine Engine - MainMain - Engine MainEngine Main - ECM MainEngine Main - ECM MainMain - RoofMain Air BagMain - Driver SeatMain - T/MMain - Fuel Tank Main - Fuel Tank Main - T/MMain - T/MMain - T/MMain - T/MMain - T/MMain - T/MDLC Connector - MainMain - Air ConMain - ECM Main Driver Seat - Driver Seat, AUX Main - FloorMain - Floor Main - Floor Main - FloorMain - Floor Main - Driver DoorInside The Engine Room Fuse Block Inside The Engine Room Fuse BlockInside The Engine Room Fuse BlockUnder The Engine Room Fuse BlockBeside Pre-Heating Unit (DSL)Under The Air Cleaner Housing (DSL, Turbo)Under The Air Cleaner Housing (DSL, N/Turbo) Under The Air Cleaner Housing (GSL) Under The Coolant Reservoir TankBehind The ABS Module (HFM)Center The Engine Room Dash PanelCenter The Engine Room Dash PanelUpper The I/P Fuse BlockLeft The AudioUnder The Driver SeatUpper The T/C MotorUpper The T/C (DSL) Upper The T/C (GSL) Upper The T/CUpper The T/C (GSL)Upper The T/C (DSL)Upper The T/C (GSL)Upper The T/C (DSL)Upper The T/C (GSL)Beside The Steering ColumnBehind The Glove BoxBeside The ECM (MSE) Under The Driver Seat Beside The I/P Relay BlockBeside The I/P Relay BlockBeside The I/P Relay Block Inside Co-Driver Side Cowl Panel Beside Center ConsoleUpper The I/P Fuse Block
Connector
Number Connecting Wiring HarnessConnector PositionColorPin
Number
2) GROUND
G101 G102 G103G201 G202 G203G204G205 G206 G207G208 G209 G301G302G303 Ground Position
Wiring Harness
Ground
Number
Behind The Left LampBeside The Start Motor Behind The Right Head Lamp Right The I/P Fuse BlockBeside The STICSUpper The ECM Behind The Ashtray Beside The TCCUBeside The ABS Module Beside THe ECM Under THe CO-Driver SeatBeside The EBCMCenter The Left 'B' Pillar Beside The Left Rear Speaker Beside The Right Rear Speaker
Engine Engine Engine
Main MainMain Main MainMain Main MainMain
Floor Floor Floor
* [ ] : EURO III
Page 1368 of 1574

4-4 USAGE AND CAPACITY OF FUSES IN FUSE BOXSDM Chime BellImmobilizer UnitSticsRekesEBCM
4 Pin 4 Pin 4 Pin4 Pin4 Pin4 Pin4 Pin 4 Pin 3 Pin3 Pin
82330-05000 84190-05100 84150-0130084150-0130084150-0130084150-0130084150-01300 84150-01300 84130-0500084130-05000
Part Name Part Number
Remarks
Resistor W/Diode (GSL) A/C Compressor Relaly (DSL)A/C RelayCooling Fan - 1 RelayCooling Fan - 2 RelayFront Fog Lamp Relay Head Lamp Relay (Low) Head Lamp Relay (Hi)Illumination RelayHorn Relay
3. POSITION OF RELAY, CONTROL UNIT AND PARTS NUMBER
1) ENGINE ROOM FUSE BLOCK
2) RELAY BOX ABOVE I.P FUSE BLOCK
5 Pin 5 Pin 3 Pin5 Pin5 Pin4 Pin4 Pin 4 Pin 4 Pin 4 Pin 4 Pin 4 Pin
84210-05001 84210-05001 84410-05100
66182253386618225338
84150-0130084150-01300 84150-01300 84150-01300 84150-0130084150-0130084190-05100
Part Name Part Number Remarks
Front Wiper Relay Defogger RelayTurn Signal Lamp RelayFuel Pump Relay (GSL)Cigar Lighter, P/socket Relay (DSL)A/T Shift lock Relay PNP Relay Sun Roof RelayA/T "B" Switch Interlock Relay Power Window Relay ECL RelayABS Warning Lamp Relay
3) CONTROL UNIT
Below The Audio
Beside The SDM
Behind the Wiper Switch Upper The Accelerator Upper The Stics
I/P Center Console Floor Panel
8690005800 8661005000869500580087110058008716105000
4891005000X
Part Name Part Number Remarks
Page 1563 of 1574

5-188 ELECTRICAL WIRING DIAGRAMSb. CONNECTOR IDENTIFICATION SYMBOL & PIN NUMBER POSITIONC103
W/H MAIN C109
W/H ENGINE C305
W/H MAIN
a. CONNECTOR INFORMATION
ACCELERATIONSENSOR
EBCM (ABD) CLUSTERWHEEL SPEED
SENSOR
12312
11 2
29 38
28
13 2021
39 434842
Main - Engine Engine - Main Main - Floor MainMain Main
C103 (2Pin, White) C109 (16Pin, Black) C305 (6Pin, White) S202 (Gray) G201 G209
CONNECTOR(NUMBER)
CONNECTING. WIRING HARNESSCONNECTOR POSITION
Inside The Engine Room Fuse Block Under The Coolant Reservoir Tank Beside Center ConsoleBehind The Cluster Right The I/P Fuse Block Beside The EBCM
Ef8F22
60A
F17 10A 10A
F3
10A
R G
RY RY LB
BW
LW
1 C103 18
50 32
1
B+
G209 G201
1
8 S202
28 29
B B LY GW WR
12
LH12RH
SIG
SIG
IGN1
5V SIG36
39 51 43 10 15 14
BrB BrB BrBBrB
BrWBrW
BrWBrW
1 23
Front Wheel Speed Sensor
12LH12 RH
SIG SIG
13 12 11 38
BrB BrB BrB
C305
BrB B
BrWBrW
BrWBrW
3
6
2
Rear Wheel Speed Sensor
Acceleration Sensor G C109
4
RG
30
8
BW
31
9
TCS EBD
ABS
Valve Relay
"87"
ABS
Warning
Lamp Relay
30 86
87 85
B R
Cluster
EBCM
30 BAT+
15 IGN 1
31 GND
Ef2 80A
121
3
4
1
22
3 4
1
6
5