warning SSANGYONG REXTON 2006 Service Manual

undefined
8710-08
RKSTICS
Ignition Key Reminder Warning
(The ignition key reminder warning has priority over the "TAILLAMP ON WARNING".)
The chime bell sounds continuously with the interval of 0.3 seconds when opening the
driver's door while the ignition key is in ignition switch.
When removing the ignition key or closing the driver's door during chime buzzer operation,
the buzzer stops.
This function is not available when the ignition switch is in "ON" position. 1.
2.
3.
Chime bell location: bottom of audio unit
(right to the sensor cluster)
Sensor clusterChime bell

RKSTICS
undefined
8710-08
Tail Lamp Left On Warning
The buzzer sounds with the interval of 0.3 second when opening the driver's door while the
tail lamp is turned on and the ignition key is removed.
The buzzer output stops when turning off the tail lamp and closing the driver's door.
The system outputs "UNLOCK" signal for 5 seconds when the driver's and passenger's
door lock switch is locked (while the tail lamp is turned on and the driver's door is open).
This function is not available when the ignition key is in the "ON" position. 1.
2.
3.
4.

undefined
8710-08
RKSTICS
Door Ajar Warning
The warning light in instrument panel comes on when opening any of doors including
tailgate while the vehicle speed is below 10 km/h.
The warning light goes off when closing the door under step 1.
The warning light blinks when the vehicle speed is over 10 km/h while the warning light is
turned on.
The warning light blinks when a door is open while the vehicle speed is over 10 km/h.
The warning light goes off when closing the door under step 3.
The warning light comes on when the vehicle speed goes below 10 km/h under step 3. 1.
2.
3.
4.
5.
6.

RKSTICS
undefined
8710-08
Seat Belt Warning
The seat belt warning light comes on and the chime bell sounds for 6 seconds when turning
the ignition key to "ON" from "OFF".
If the seat belt is fastened before turning the ignition key to the the "ON" position, the
warning light in the instrument panel blinks, however, the chime bell does not sound.
The seat belt warning light goes off and the chime bell stops when turning the ignition switch
to the "OFF" position.
The chime bell stops and the seat belt warning light stays on for the specified period of time
when fastening the seat belt during the warning operation.
The seat belt warning light comes on and the chime bell sounds for 6 seconds again when
unfastening the seat belt during fastening operation while the ignition key is "ON" position. 1.
2.
3.
4.
The seat belt warning light comes on and the chime buzzer sounds for 6 seconds when turning
the ignition key to "ON" from "OFF". After fastening the seat belt, the chime bell stops.
Seat Belt Warning Light

undefined
8710-08
RKSTICS
Parking Brake Warning
The parking brake warning light comes on for approx. 4 seconds when turning the ignition
key from the "OFF" to the "ON" position regardless of the vehicle speed and the parking
brake switch position. After this 4 seconds, the warning lamp comes on, goes off or blinks
according to the vehicle speed and the parking brake switch position.
The warning light comes on when the parking brake switch is turned on while the vehicle
speed is below 10 km/h.
The warning light goes off when turning off the parking brake switch under step 2.
The warning light blinks and the chime bell sounds for 0.6 seconds and stops for 0.3
seconds when the vehicle speed is over 10 km/h for more than 2 seconds while the parking
brake switch is turned on.
The warning light goes off and the chime buzzer stops when turning off the parking brake
switch under step 4.
The warning light comes on and the chime buzzer stops when the vehicle speed goes down
below 10 km/h under step 4.
This function is not available when the ignition key is turned to the "OFF" position. 1.
2.
3.
4.
5.
6.
7.

undefined
8710-08
RKSTICS
Description of Burglar Alarm Function
1. Armed mode activation requirements
1) The "LOCK" output is "ON" when receiving the "LOCK" signal from transmitter while the
ignition key is removed and all doors are closed. The armed mode is activated when the doo
r
lock switch is locked (hazard relay output: twice).
2) The theft deterrent horn and hazard relay outputs are "ON" when receiving the "LOCK"
signal from the remote control key again in armed mode (hazard relay output: twice).
3) When receiving "LOCK" signal from the remote control key while any of doors is not closed,
only the "LOCK" output can be done and then activates the armed ready mode (without hazard
warning flasher). At this moment, if the ignition key is in the ignition switch, the door unlock
switch is turned "ON" or the door lock switch is unlocked, it cancels the armed mode and
activates the normal mode. However, when closing and locking the opened door, the hazard
warning lamps flash twice.
4) When the door is not opened or the ignition key is not inserted into ignition switch for 30
seconds after receiving "UNLOCK" signal, it outputs "LOCK" and then activates armed mode
(RELOCK operation). Also, at this moment, the system outputs the hazard warning flashe
r
twice.
5) The armed mode will not be activated except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key.

RKSTICS
undefined
8710-08
2. Armed mode cancellation requirements
1) Unlocking by remote control key
2) Door unlocking by the driver's and passenger's key cylinder switch
3) The armed mode is cancelled when turning the ignition key "ON". The siren is deactivated in
27 seconds.
3. Warning operation requirements
1) When opening the door in armed mode
2) When unlocking the door lock switch in armed mode
3) When closing and then opening the door after completion of warning (27 seconds)
4. Warning operation
1) The siren and hazard warning flasher output is "ON" for 27 seconds with the interval of 1
second.
5. Warning cancellation requirements
1) Cancels warning by using any signal from the remote control key (LOCK, UNLOCK, PANIC)
during warning operation.
2) Cancels warning after 27 seconds (remaining period) while the ignition key is turned to "ON"
position.
3) If the ignition switch is turned to ON position when the warning is activated in armed mode,
the warning is canceled immediately and the warning buzzer stops after 27 seconds (remaining
time).
4) When unlocking the doors by the driver's/passenger's door key cylinder in armed mode, the
armed mode is cancelled.
6. Operation when warning is cancelled
1) The siren and hazard warning flasher outputs are "OFF".

undefined
8710-08
RKSTICS
7. Operations when removing and installing the battery
If the system is in armed mode while installing a battery, the siren sounds and the emergency
warning lamp blinks.
(Same operations with warning in armed mode).
RELOCK Operation: It the door is not opened or the ignition key is not inserted into the
key cylinder within 30 seconds after unlocking the door with remote control key, the
system outputs "LOCK" signal and activates the armed mode. -

RKSTICS
undefined
8710-08
Specifications of Remote Control Key
When any of switches on remote control key is pressed, the integrated CPU in remote control
key sends the coded control message to the CPU in receiver to control the vehicle.
Switch Functions on Remote Control Key
Door Lock Button
Lock (briefly press)
If you press this button briefly, all doors and the
tailgate are locked and the theft deterrent mode
is activated.
When the theft deterrent mode is activated, the
hazard warning flashers blink twice. -
-
Door Unlock/Panic Button
1. Unlock (briefly press)
If you press this button briefly, all doors and the
tail gate are unlocked and the theft deterrent
mode is deactivated.
When the deterrent mode is deactivated,
hazard warning flashers blink once. -
-
2. Panic function (press and hold)
If you are in your vehicle and feel threatened while the
ignition key is inserted into the key switch, you may activate
the alarm to call attention. If you press this button, the
warning siren will sound for approx. 27 seconds.
The panic function will stop when any of the buttons on the
remote control key is pressed. -
-Panic Button
(operative only when the ignition
key is inserted)
The coding signal is transmitted only if pressing the door unlock button long (approx.
2 seconds) when coding the remote control key.

undefined
8710-08
RKSTICS
Remote Door Lock
All doors are locked when briefly pressing the door LOCK switch on remote control key (less
than 0.5 seconds).
The system outputs LOCK signal immediately after receiving the door lock message from
the remote control key. The system activates the theft deterrent mode when all doors are
locked while they are fully closed (the hazard warning lamps blink twice.). 1.
2.