Heating SSANGYONG TURISMO 2013 User Guide

07-6
1. GENERAL DESCRIPTION
The cooling system maintains the engine temperature at an efficient level during all engine operating
conditions. When the engine is cold, the cooling system cools the engine slowly or not at all. This slo
w
cooling of the engine allows the engine to warm up quickly. The cooling system includes a radiator and
recovery subsystem, cooling fans, a thermostat and housing, a water pump, and a water pump drive
belt. The timing belt drives the water pump. All components must function properly for the cooling
system to operation. The water pump draws the coolant from the radiator.
The coolant then circulates through water jackets in the engine block, the intake manifold, and the
cylinder head. When the coolant reaches the operating temperature of the thermostat, the thermostat
opens. The coolant then goes back to the radiator where it cools. This system directs some coolant
through the hoses to the heat core. This provides for heating and defrosting. The coolant reservoir is
connected to the radiator to recover the coolant displaced by expansion from the high temperatures.
The coolant reservoir maintains the correct coolant level. The cooling system for this vehicle has no
radiator cap or filler neck. The coolant is added to the cooling system through the coolant reservoir.

06-58510-00
2. MAJOR CHANGES
Center fascia switch
- Design changed
Steering wheel switch assembly
- Power button deleted, steering wheel heating (option) switch added
- Design changed
Multifunction switch assembly
- Connector pin layout changed due to newly added steering wheel heating (option) circuit
- Contact coil and steering wheel angle sensor changed

06-8
Outside Rearview
Mirror Adjusting/
Folding Switches
Window switch
Steering Wheel Audio/Heating Switch & Gear Shift Switch (A/T)
Multifunction Switch and Steering
Wheel Angle Sensor
4WD Switch, Headlamp
Leveling Switch, Rear Wiper
Switch
1. LAYOUT
Seek button
Volume button Manual gear shift down
switchManual gear shift up switch
Mode button
Bluetooth handsfree
Steering wheel heating switch
With audio OFF: press the MUTE
button briefly to switch on
With audio ON: press and hold the
MUTE button to switch off
MUTE button -
-
-

11-58910-05
Audio head unit assembly
Bluetooth setting mode and design changed
Steering wheel switch
- Power button deleted, steering wheel heating (option) switch added
- Design changed
2. MAJOR CHANGES
USB/AUX jack assembly
Ø3.5 3-pole stereo AUX input and USB port used, USB/AUX jack assembly added

11-34610-00
1. SPECIFICATIONS
Description Specification
Steering wheelType 4-spoke type
Outer diameter (mm) 390
Steering gear boxType Rack and pinion type
Steering angleInner36.4°
Outer31.5°
Steering oil pumpType Vane type
Maximum pressure (kgf/cm2) 93.3 ~ 100.4
Pulley size (mm)Ø115
Operating temperature-40℃ ~ 150℃
Steering oilType S-PSF3
Capacity (L) approx. 1.1
Lower shaftType Universal joint
Angle(°) 38°
ConfigurationUniversal joint(top/bottom)
rubber coupling
Minimum turning radius (m) 6.09
Steering column shaft Tilting angle±2°
Steering wheel heating
indicatorPower consumption Below 95 W
Rated voltage13.5 ± 0.1 V
Usable voltage 9~16 V
Low voltage7.5 ± 0.5 V
High voltage18.0 ± 0.5 V
Rated voltage Max. 12.4 A
MemoryLast switch ON/OFF mode
memorized

11-4
Steering column shaft assembly
Steering column shat assembly mounting bracket changed due to change of multifunction switch
Steering wheel body and heating system
Heating controller added due to newly adopted steering wheel heating system
2. CHANGES IN STEERING SYSTEM
Steering wheel heating switch
Heated wire used in steering wheel switch
(option)
Heating controller
Mounting bracket

01-36810-30
1. SPECIFICATION
Item FATC Manual
A/C controllerRated voltage DC 12 V DC 12 V
Operating voltage DC 9 to 16 V DC 9 to 16 V
Current consumption 2 A 2.5 A
Operating temperature-30~75℃ -30~80℃
Dark current 2 mA or less -
A/C compressorDiameter of pulley 120 mm
Rated voltage DC 12 V
Current consumption 2.2 A
Refrigerant fluid PAG RL 897 150cc
CondenserSize 655.8wX485.6hX16.0t
Receiver drierMoisture absorbent XH-9
Pressure switch Refrigerant pressure sensor
Front heater &
A/C moduleHeating capacity 7000 Kcal/hr
Cooling capacity 6200 Kcal/hr
Expansion valve Block type
Rear heater &
A/C moduleHeating capacity 4300 Kcal/hr
Cooling capacity 3200 Kcal/hr
Refrigeranttype R134a
Volume1050g ± 30g
PTC heaterMaterial barium titanate (BaTiO3)
Power consumption 1,000 W

01-6
AQS & ambient temperature
sensor
1. OVERVIEW
The climate system controls the temperature and air quality inside the vehicle by providing the
heating/cooling and preventing the hazardous gas from entering to keep indoor air fresh.
2. LAYOUT
1) External Climate System
Front expansion valve
Condenser
AQS sensor
Ambient temperature
sensor