SSANGYONG TURISMO 2013 User Guide
TURISMO 2013
SSANGYONG
SSANGYONG
https://www.carmanualsonline.info/img/67/57526/w960_57526-0.png
SSANGYONG TURISMO 2013 User Guide
Page 421 of 796
01-8
3. CIRCUIT DIAGRAM
▶SB1~SB4, C/FAN (HI,LO) REALY, F/HEATER RELAY
1) Engine Room Fuse and Relay Box
Page 439 of 796
02-8
(2) Rain Sensor Coupled Wiper
▶ System layout
This vehicle has a different wiper control logic compared to other models. As shown in the system
diagram, the rain sensor unit does not control wiper directly. The rain sensor unit sends infrared rays
signal through LED and then receives it with photo diode and then sends the returned signal to STICS
and the STICS controls the wipers directly.
For more details, refer to rain sensing wiper section in this manual.
Page 472 of 796
02-418710-01
3. CIRCUIT DIAGRAM
▶ Tail lamp, key reminder SW, chime bell
Page 479 of 796
03-57010-06
2) System Diagram
The certification for the immobilizer is performed when turning the ignition switch to the "ON" position
after the CAN communication between the ECU and immobilizer is established.
Page 484 of 796
Page 496 of 796
07-10
3. CIRCUIT DIAGRAM
1) Interior Lamp
Page 514 of 796
07-77810-01
2. CIRCUIT DIAGRAM
Page 518 of 796
08-6
1) Rain Sensor Coupled Wiper
▶ System layout
This vehicle has a different wiper control logic compared to other models. As shown in the system
diagram, the rain sensor unit does not control wiper directly. The rain sensor unit sends infrared rays
signal through LED and then receives it with photo diode and then sends the returned signal to STICS
and the STICS controls the wipers directly.
For more details, refer to rain sensing wiper section in this manual.
Page 528 of 796
08-16
6. RAIN SENSOR RELATED CIRCUIT
The rain sensor has one connector with 4 pins and each pin has following function as shown in the
circuit diagram.
However, in this vehicle, the terminal No. 1 and No. 2 are for communications between STICS and the
rain sensor; the No. 1 terminal sends the detected value from the rain sensor to STICS then the STICS
drives wiper motor.
to the rain sensor to recognize whether it is actual rain or it is in rain sensing wiper operation mode.
No.2 terminal sends the wiper and washer operation information such as
washer operation mode,
MIST mode, or
AUTO wiper position -
-
-
Page 538 of 796
09-118790-01
5. Wiring diagram