warning SUBARU ASCENT 2020 Quick Guide

2PURPOSE OF THIS GUIDE
5ENTRY AND EXIT
8INSTRUMENT PANEL
10GETTING COMFORTABLE
21CONTROLS
27GAUGES AND WARNING LIGHTS
28OPERATING THE VEHICLE
33REFUELING
34PASSENGER/CARGO AREAS
39ENGINE COMPARTMENT
41ADDITIONAL SPECIFICATIONS
43INDEX
TABLE OF CONTENTS

KEYLESS ENTRY
1Lock/Arm
• Pressing this button will lock all doors, rear gate and fuel
door and activate the security alarm.
• If any of the doors or the rear gate are not fully closed, five
rapid chirps will sound and the hazard warning flashers will
flash.
• Pressing this button three times (within five seconds) will
activate the vehicle finder function. If you are within 30 feet
of your Subaru, the horn will sound once, and the hazard
warning flashers will flash three times.
2Unlock/Disarm
• Pressing this button once will unlock the driver’s door and
fuel door if set to do so in the Touchscreen.
• Pressing this button twice (within five seconds) will unlock
all doors and rear gate.
• When you press this button, the interior lights will illuminate,
if set to the “DOOR” position on the overhead console
switch.
3Rear Gate
• Pressing this button will unlock the rear gate.
• If equipped with a Power Rear Gate, pressing and holding
this button will open or close the rear gate.
4Panic Alarm
• Pressing this button will sound the horn and flash the
hazard warning lights.
• Press any button on the access key fob or transmitter to deactivate.
Access Key Fob
Transmitter
ENTRY AND EXIT
5

Automatic Door Locking/Unlocking
With this function, all doors and the fuel lid will automatically lock or unlock when certain
conditions are met based on your preference. You can change the setting in the
Combination Meter Display (CMD) or the Touchscreen. Possible settings are:
AUTO DOOR LOCK
Vehicle Speed
(12 mph)Shift in/out of
PARKOFF
AUTO DOOR UNLOCK
Ignition OFF Drivers Door
OpenShift in/out of
PARKOFF
KEYLESS ACCESS WITH PUSH BUTTON START(if
equipped)
Your Subaru allows for customizing of the door unlock settings. The default setting is when
you unlock the vehicle, only the driver’s door and fuel lid unlock. If preferred, you can set
the vehicle to unlock all doors, the rear gate and the fuel lid. This adjustment can be
performed through the SUBARU STARLINK
®Multimedia Touchscreen under “Settings”,
then “Vehicle”.
Unlock Using Door Handles
Grip the driver’s door handle to unlock the driver’s
door (or all doors depending on the setting). Grip the
front passenger’s handle to unlock all doors and the
rear gate. Two chirps will sound and the hazard
warning flashers will flash twice.
Locking Using Door Handles
Close all doors and the rear gate and touch the door
lock sensor (two lines) on either front door handle. All
doors and the rear gate will lock. One chirp will sound
and the hazard warning flashers will flash once.
ENTRY AND EXIT
6

Opening the Rear Gate
Press the rear gate opener button to unlock and open
the rear gate (or also unlock all doors depending on
the setting). Two chirps will sound and the hazard
warning flashers will flash twice.
Locking Using the Rear Gate
Close all doors and the rear gate and press the rear
lock button. All doors and the rear gate will lock. One
chirp will sound and the hazard warning flashers will
flash once.
ENTRY AND EXIT
7

1Power Windows (p. 14)
2Power Exterior Mirrors (p. 13)
3Instrument Panel Switches (p. 25)
4I/Set Switch (p. 22)
5Audio Controls (p. 21)
6Light Controls (p. 22)
7Gauges and Warning Lights (p. 27)
INSTRUMENT PANEL
8

OVERHEAD PANEL
1SOS Emergency
Assistance:Press the
“SOS” button to connect
with a SUBARU STARLINK
®
Customer Care Advisor.
(Subscription required.)
Press and hold the button for
about two seconds to cancel
the call. Refer to the
SUBARU STARLINK
®Safety
and Security Owner’s
Manual or the SUBARU STARLINK
®Quick Guide.
2Enhanced Roadside Assistance:Press the “i” button to connect with a SUBARU
STARLINK
®Roadside Assistance Provider. (Subscription required.) Press and hold
the button for about two seconds to cancel the call. Refer to the SUBARU
STARLINK
®Quick Guide.
3Lane Departure Warning OFF switch:Press and hold this switch for two seconds to
turn off the Lane Departure Warning and the Lane Sway Warning function. Press and
hold the switch again for two seconds to turn the systems back on. Refer to the
EyeSight
®Owner’s Manual or Quick Guide.
4Pre-Collision Braking System OFF switch:Press and hold this switch for two
seconds to turn off the Pre-Collision Braking System and Pre-Collision Throttle
Management. Press and hold the switch again for two seconds to turn the systems
back on. Refer to the EyeSight
®Owner’s Manual or Quick Guide.
5Automatic Illumination:When the switch is in the “DOOR” position, the map lights
illuminate when any door is opened, the doors are unlocked using the remote keyless
entry system or keyless access function, or the ignition is turned from “ON” or “ACC”
to “LOCK”/“OFF”.
6Map Lights:Press a map light to turn it on or off.
CONTROLS
26

GAUGES
1Tachometer
2Combination Meter Display (CMD)
3Speedometer
4Fuel gauge5Trip meter and odometer
6Select lever/gear position indicator
7Engine coolant temperature gauge
WARNING AND INDICATOR LIGHTS
Red lights indicate immediate attention is required. Some examples are:
Seatbelt
warningDoor
openBrake system
Yellow lights indicate caution. Some examples are:
Low fuelEngine oil
level warning
lightTire pressure
warning light
Green and blue lights are for information. Some examples are:
Headlight
indicator
lightAuto Vehicle
Hold ONHigh beam
indicator
light
GAUGES AND WARNING LIGHTS
27

FUEL FILLER LID
The fuel filler lid is located toward the rear of the
passenger side. To open the lid:
1. Make sure your vehicle is stopped and the selector
placed in PARK. Then turn the ignition to the
"LOCK"/ "OFF" position.
2. Unlock the lid by pressing the unlock/disarm button
on the access key fob or transmitter, pressing the
unlock side of the power door locking switch, or
putting the vehicle in “LOCK”/“OFF”.
3. Push the rear side of the lid.
4. When the lid opens slightly, open it further by hand.
While refueling, place the fuel filler cap on the cap
holder inside the lid.
To close the lid, press it until you hear it latch.
FUEL
Use regular unleaded gasoline with an octane rating of 87 AKI or higher. Do not use fuels
with more than 15% ethanol. See the Owner’s Manual for more information.
FUEL CAPACITY
19.3 US gallons
The low fuel warning light illuminates when the tank is nearly empty,
at approximately 2.6 US gallons.
REFUELING
33

REAR SEAT REMINDER
The Rear Seat Reminder system assists you in
preventing a child or pet from being left in your
Subaru. The system monitors the opening and
closing of the rear side door. It does not
physically sense the presence of a child or pet.
The system turns on if your Subaru is started
within 30 minutes of a rear side door opening
or closing. It also turns on if a rear side door is
opened and closed when your Subaru is
running and stationary. The system remains on
if your Subaru is turned off and back on again
within 30 minutes and the rear side doors
remained closed.
When you turn your Subaru off, the system warns you audibly and with a “Reminder, Look
in Rear Seat” message in the Combination Meter Display (CMD).
The system operates only one time with each ignition cycle and opening and closing of a
rear side door. You can turn the Rear Seat Reminder off in the Combination Meter Display
(CMD).
POWER REAR GATE (PRG)(if equipped)
Power Rear Gate Button
Briefly press and release the button on the instrument
panel to automatically open or close the rear gate. Two
chirps will sound and the hazard warning flashers will
flash twice. If you briefly press the button while it is
closing, it will open. If you briefly press the button
while it is opening, it will pause. Press the button again
to close the rear gate. If you attempt to open the Power Rear Gate with the doors locked,
three rapid beeps will sound.
The operation is the same using the Power Rear Gate Button on the access key fob or
transmitter.
NOTE: This button only functions to open the PRG when the doors are unlocked. If the
doors are locked, you will hear three rapid beeps from the vehicle.
PASSENGER/CARGO AREAS
36

From the Rear of the Vehicle
To open the rear gate, unlock your Subaru or have
your access key fob with you. Then, briefly press the
button on the underside trim near the license plate.
The rear gate will automatically open. If you briefly
press the button while the gate is opening, it will
pause. Press the button again to close the rear gate.
To close the rear gate, briefly press the Power Rear
Gate Button on the inside edge of the rear gate. If you
press the button again, the rear gate will open.
Power Rear Gate Lock
With the rear gate open, press the lock button on the
inside edge of the rear gate. All doors, the rear gate
and the fuel lid will lock, and the rear gate will close.
Memory Height
You can set where the rear gate stops when it opens.
To set the height:
1. Make sure the ignition is in the “LOCK”/”OFF”
position.
2. Open the rear gate using the Power Rear Gate
function.
3. Stop the rear gate when it reaches the desired
height by pressing the PRG button on the rear gate,
instrument panel, or key fob.
4. Press the memory switch in the instrument panel to
select the “ON” status (switch indented).
5. With the rear gate at the desired height, press and hold the Power Rear Gate Button on
the inside edge of the rear gate. A chirp will sound and the hazard warning flashers will
flash three times to confirm the height is set.
When the memory switch is in the “ON” status, the rear gate will stop at the set memory
height when you use any of the Power Rear Gate switches.
PASSENGER/CARGO AREAS
37