lock SUBARU BAJA 2006 1.G User Guide

1-5
Seat, seatbelt and SRS airbags
– CONTINUED –
To adjust the angle and height of the seat cushion,
move the control switch in the corresponding direction. „
Reclining the seatback
Pull the reclining lever up and adjust the seatback to
the desired position. Then release the lever and make
sure the seat is secu rely locked into place.
The seatback placed in a reclined position can spring
back upward with force when released. When operat-
ing the reclining lever to return the seatback, hold it
lightly so that it may be raised back gradually.
UB1062BA
UB1072BA

1-9
Seat, seatbelt and SRS airbags
– CONTINUED –
Rear seats
ySeatbelts provide maximum restraint when
the occupant sits well back and upright in the
seat. Do not put cushions or any other materi-
als between occupants and seatbacks or seat
cushions. If you do so, the risk of sliding under
the lap belt and of the lap belt sliding up over
the abdomen will increase, and both can result
in serious internal injury or death. y To avoid the possibility of serious injury or
death, passengers must never be allowed to sit on the rear center console while the vehicle is
in motion. The rear seat of this vehicle is de-
signed for no more than two passengers and is
equipped with only two seatbelts. y
Make sure that the rear seatback is securely
locked. When it is securely locked, the red
marking on the lock is no longer visible. If it is
not locked, the seatback may move forward
when the vehicle is operated.
„ Rear headrest
Rear headrest are not adjustable, nor removable.
UB0302
UB1153AA

1-10
Seat, seatbelt and SRS airbags
„
Folding down the rear seat
yAfter returning the rear seat to its original po-
sition, be certain to place all of the seatbelts
and the tab attached to the seat cushion above
the seat cushion. And make certain that the
shoulder belts are fully visible. y Make sure that the rear seatback is securely
locked after returning the seatback to its origi-
nal position. When securely locked, the red
marking on the lock is no longer visible. If it is
not locked securely, the rear seatback may fold
down during driving. y Never allow passengers to ride on the folded
rear seatback. Doing so may result in serious
injury or death.y Secure skis and other lengthy items properly
to prevent them from being thrown around in-
side the vehicle and causing serious injury dur-
ing a sudden stop, a sudden steering maneuver
or a rapid acceleration.
Never stack luggage or other cargo higher than
the top of the front seatback because it could
tumble forward and injure passengers in the
event of a sudden stop or accident.
HS8005BA

1-11
Seat, seatbelt and SRS airbags
– CONTINUED –
TFolding down the seatback
Before folding down the seatback, check that
there is nothing in the seatback pocket. If there
is something in the pocket, it could be damaged
or cause damage to the seatback and rear cen-
ter console when the seatback is folded.
A) LOCK
B) UNLOCK
1) Red 1. Unlock the seatback by pulling the release knob up
and then fold the seatback down.
1
AB
UB1109BB
UB1110BA

1-13
Seat, seatbelt and SRS airbags
– CONTINUED –
A) LOCK
B) UNLOCK
1) Red 4. Unlock the seatback by pulling the release knob up
and fold the seatback down. Confirm that the pin locat-
ed at the bottom of the seat cushion is inserted into the
slot at the top of the seatback.
Be careful not to pinch your hand or fingers
with the seat cushion or the seatback when per-
forming the fold down operation.
5. To return the rear seat to its original position, raise
the seatback and seat cushion until they lock into
1
AB
UB1112CBUB1113BA

1-14
Seat, seatbelt and SRS airbags
place and make sure that they are securely locked.
Make sure that the rear seatbelt buckles are not under
the seat cushion or seatback, when returning the seat
cushion and the seatback to their original position.
Confirm that the rear seatbelts are stored in the
seatbelt pocket prior to returning the seat cush-
ion to its original position.
Seatbelts „
Seatbelt safety tips
yAll persons in the vehicle should fasten their
seatbelts BEFORE the vehicle starts to move.
Otherwise, the possibility of serious injury be-
comes greater in the event of a sudden stop or
accident.y All belts should fit snugly in order to provide
full restraint. Loose fitting belts are not as ef-
fective in preventing or reducing injury.y Each seatbelt is designed to support only
one person. Never use a single belt for two or
more persons – even children. Otherwise, in an
accident, serious injury or death could result. y Replace all seatbelt assemblies including re-
tractors and attaching hardware worn by occu-
pants of a vehicle that has been in a serious ac-
cident. The entire assembly should be replaced
even if damage is not obvious.y Put children aged 12 and under in the rear
seat properly restrained at all times. The SRS
airbag deploys with considerable speed and
force and can injure or even kill children, espe-

1-16
Seat, seatbelt and SRS airbags
T
Expectant mothers
Expectant mothers also need to use the seatbelts.
They should consult their doctor for specific recom-
mendations. The lap belt should be worn securely and
as low as possible over the hips, not over the waist. „ Emergency Locking Retractor (ELR)
The driver’s seatbelt has an Emergency Locking Re-
tractor (ELR).
The emergency locking retractor allows normal bodymovement but the retracto r locks automatically during
a sudden stop, impact or if you pull the belt very quick-
ly out of the retractor. „
Automatic/Emergency Locking Retrac- tor (A/ELR)
Each passenger’s seatbelt has an Automatic/Emer-
gency Locking Retractor (A/ELR). The Automatic/
Emergency Locking Retractor normally functions as
an Emergency Locking Retractor (ELR). The A/ELR
has an additional locking mode “Automatic Locking
Retractor (ALR) mode” intended to secure a child re-
straint system. When the seat belt is once drawn out
completely and is then retracted even slightly, the re-
tractor locks the seatbelt in that position and the seat-
belt cannot be extended. As the belt is rewinding,
clicks will be heard which indicate the retractor func-
tions as ALR. When the seatbelt is retracted fully, ALR
mode is released. When securing a child rest raint system on the passen-
gers’ seats, the seatbelt mu st be changed over to the
Automatic Locking Retractor (ALR) mode.
When the child restraint system is removed, make
sure that the retractor is restored to the Emergency
Locking Retractor (ELR) function by allowing the seat-
belt to retract fully.
For instructions on how to convert the retractor to the
ALR mode and restore it to the ELR mode, see the “Child restraint systems” section in this chapter.
HS1107AA

1-18
Seat, seatbelt and SRS airbags
Never place the shoulder belt under the arm or
behind the back. If an accident occurs, this can
increase the risk or severity of injury.
Metallic parts of the seatbelt can become very
hot in a vehicle that has been closed up in sun-
ny weather; they could burn an occupant. Do
not touch such hot parts until they cool.
T Front seatbelts
1. Adjust the seat position:
Driver’s seat: Adjust the seatback to the upright posi-
tion. Move the seatback as far from the steering wheel
as practical while still maintaining full vehicle control.
Front passenger’s seat: Adjust the seatback to the
upright position. Move the seat as far back as possi-
ble.
2. Sit well back in the seat.
3. Pick up the tongue plate and pull the belt out slowly.
Do not let it get twisted. If the belt stops before reach-
ing the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the
belt retract slightly after giving it a strong pull, then pull
it out slowly again.
4. Insert the tongue plate into the buckle until you
hear a click.
HS1050BA

1-19
Seat, seatbelt and SRS airbags
– CONTINUED –
5. To make the lap part tight, pull up on the shoulder
belt.
6. Place the lap belt as low as possible on your hips,
not on your waist. V
Adjusting the front seat shoulder belt anchor
height
The shoulder belt anchor height should be adjusted to
the position best suited for the driver/front passenger.
To lower the anchor height, push the release button
and slide the anchor down. To raise the anchor height,
slide the anchor up. Pull down on the anchor to make
sure that it is locked in place.
Always adjust the anchor height so that the shoulder
belt passes over the middle of the shoulder without
touching the neck.
HS1051BA
HS1052BA

1-20
Seat, seatbelt and SRS airbags
When wearing the seatbelts, make sure the
shoulder portion of the webbing does not pass
over your neck. If it does, adjust the seatbelt an-
chor to a lower position. Placing the shoulder
belt over the neck may result in neck injury dur-
ing sudden braking or in a collision.
V Unfastening the seatbelt
Push the button on the buckle.
Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing
in the door. T
Rear seatbelts
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly.
Do not let it get twisted. If the belt stops before reach-
ing the buckle, return the belt slightly and pull it out
more slowly. If the belt still cannot be unlocked, let the
belt retract slightly after giving a strong pull on it, then
pull it out slowly again.
3. Insert the tongue plate into the buckle until you
hear a click.
HS1053BAHS1050BA