height SUBARU CROSSTREK 2018 Quick Guide

3
Getting
Started
Seat Controls
1. Forward/Backward
Pull up on the lever below the
front of the driver’s seat to move
the seat forward or backward.
2. Raise/Lower Seat Cushion
To adjust the height of the driver’s
seat, pull up or push down the
seat height adjustment lever, located on the lower left side front of the seat.
3. Recline Seatback To adjust the seatback to the desired position, pull up on the recline lever, located
on the lower left rear of the driver’s seat or lower right rear of the passenger’s
seat. Do not adjust seats while driving.
1
23
Seating
3053393_18b_Crosstrek_QG_071917.indd 37/19/17 3:55 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

4
Power Driver’s Seat (if equipped)
1. Forward/Backward, Angle and Height
Move the switch toward the front or rear to move the seat forward or backward. Pull the
switch up or push down on the front of the switch to adjust the angle of the seat cushion.
Pulling the switch straight up or pushing the switch straight down will \
adjust the height of
the entire seat cushion.
2. Seatback Move the switch in the corresponding direction to adjust the angle of the seatback.
1
2
Heated Seats (if equipped)
Switches are located on the center console between the driver’s and passenger’s seats;
choose low (bottom of switch) for normal heating or high (top of swit\
ch) for rapid heating.
Choose the center position to turn off the seat heaters.
Seating
3053393_18b_Crosstrek_QG_071917.indd 47/19/17 3:55 PM

12
Personalize
Tilt and Telescopic Steering Column
Push the lever down firmly to adjust the height and lengthwise positio\
n of the column; firmly
push the lever back up to lock the column in place. Do not adjust while \
driving.
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to
adjust the right-hand mirror. Move the knob in the direction you want to move the
mirror. Then return the knob to the neutral/center position.
i/SET Combination Meter Display Controls (if equipped)
Use the controls to display and switch
selected items in the combination meter
display. Please refer to your Owner’s Manual
for details on these controls.
3053393_18b_Crosstrek_QG_071917.indd 127/19/17 3:55 PM