radio controls SUBARU FORESTER 2001 SF / 1.G Owners Manual

Instruments and controls3-3
– CONTINUED –
n
Automatic transmission vehicles:
HS0124
HS0123
The key can be turned from “ACC” to “LOCK” only when the selector lever is in the “P” position. n Manual transmission vehicles:
HS0125
1
2
The key can be turned from “ACC” to “LOCK” only when the key is
pushed in while turning it. ACC
In this position the electrical accessories (radio, accessory power socket, etc.) can be used. ON
This is the normal operating position after the engine is started.

5-16Type B audio set (if equipped) The radio will operate only when the ignition switch is in the
“ACC” or
“ON” position.
Radio operation
HS5004BB
1 FM button
2 AM button
3 SCAN button
4 Tuning knob
5 Preset buttons 6
Fader/Balance selection button
7 Power switch, Volume control,
Bass/Treble control and
Fader/Balance control dial
8 Bass/Treble selection button
Power switch and volume/bass/treble/fader/balance control (PWR/VOL)
The dial 7 is used for both power (ON/OFF) and volume control. The
radio is turned ON and OFF by pushing the dial and the volume is
controlled by turning the dial.
This dial is used for bass/treble controls when the “BAS/TRE” button
8 is in the depressed position. It is also used for fader/balance con-

5-18n
Fader and balance control
The volume control dial 7 normally function as volume control. The
dial become the controls for Fader or Balance when you select the
appropriate fader and balance control mode.
Choose desired setting for each mode by turning the volume control
dial. The control function returns to volume control mode after about 5seconds.
To change control modes: Each brief press of the “FAD/BAL” button
6 changes control modes in the following sequence starting from
fader control mode. (When the radio is turned on, the control mode is
in the volume control.)
Balance Fader Volume
(BAL) (FAd) (VOL)
nDisplay illumination dimness cancellation
The brightness of the radio display dims when the light switch is in the “ p ” or “w ” positions. If this makes the display difficult to read,
press the volume dial for more than two seconds to return the displayto original brightness. FM/AM selection button
Push the “FM”
1 or “AM” 2 button when the radio is off to turn on the
radio. Push the “FM” or “AM” button when the radio is on to select FM1, FM2
or AM reception. Stereo indicator
The stereo indicator “ST” will come on when an FM stereo broadcast
is received.