window SUBARU FORESTER 2005 SG / 2.G Service Manual

8-12
Driving tips
lower gear when necessary.)
Avoid shifting down abruptly. Such behavior can
cause the wheels to lock, possibly leading to loss of
vehicle control.
An anti-lock brake system (ABS) enhances your vehi-
cle’s braking performance on snowy and icy roads.
Refer to the “ABS (Anti-lock Brake System)” section in
chapter 7 for information on braking on slippery sur-faces.
Do not use the cruise control on slippery roads
such as snowy or icy roads. This may cause
loss of vehicle control.
T Wiper operation when snowing
Before driving in cold weather, make sure the wiper
blades are not frozen to the windshield or rear window.
If the wiper blades are frozen to the windshield or rear
window, use the defroster with the airflow control but-
ton/dial in the “ ” position and the temperature
control dial set for maximum warmth until the wiper
blades are completely thawed out. If your vehicle is
equipped with a wiper deicer, it is helpful to thaw the
windshield wiper blades. To thaw out the rear wiper blade, use the rear window defogger.
When driving in snow, if frozen snow starts to stick on
the surface of the windshield despite wiper operation,
use the defroster with the airflow control button/dial in
“ ” and the temperature control dial set for maxi-
mum warmth. After the windshield gets warmed
enough to melt the frozen snow on it, wash it away us-
ing the windshield washer.
Snow stuck on the wiper arm prevents the wiper from
working effectively. If snow is stuck on the wiper arm,
pull off the road to a safe place, then remove it. If you
stop the vehicle at road side, use the hazard warning
flasher to alert other drivers.
We recommend use of non-freezing type wiper blades
(winter blades) during the seasons you could have
snow and sub-zero temperatures. Blades of this type
give superior wiping performance in snowy conditions.
Be sure to use blades that are suitable for your vehi- cle. „
Corrosion protection
Refer to the “Corrosion protection” section (chapter
10).

10-6
Appearance care
Cleaning the interior
Use a soft, damp cloth to clean the air conditioner pan-
el, audio equipment, instrument panel, center console,
combination meter panel, and switches. (Do not use
organic solvents.) „
Seat fabric
Remove loose dirt, dust or debris with a vacuum
cleaner. If the dirt is caked on the fabric or hard to re-
move with a vacuum cleaner, use a soft blush then
vacuum it.
Wipe the fabric surface with a tightly wrung cloth and
dry the seat fabric thoroughly. If the fabric is still dirty,
wipe using a solution of mild soap and lukewarm water
then dry thoroughly.
If the stain does not come out, try a commercially-
available fabric cleaner. Use the cleaner on a hidden
place and make sure it does not affect the fabric ad-
versely. Use the cleaner according to its instructions. „ Leather seat materials
The leather used by SUBARU is a high quality natural
product which will retain its distinctive appearance and
feel for many years with proper care. Allowing dust or road dirt to build up on the surface can
cause the material to become brittle and to wear pre-
maturely. Regular cleaning with a soft, moist, natural
fiber cloth should be performed monthly, taking care
not to soak the leather or allow water to penetrate the
stitched seams.
A mild detergent suitable for cleaning woolen fabrics
may be used to remove difficult dirt spots, rubbing with
a soft, dry cloth afterwards to restore the luster. If your
SUBARU is to be parked for a long time in bright sun-
light, it is recommended that the seats and headrests
be covered, or the windows shaded, to prevent fading
or shrinkage.
Minor surface blemishes or bald patches may be treat-
ed with a commercial leather spray lacquer. You will discover that each leather seat section will develop
soft folds or wrinkles, which is characteristic of genu-
ine leather. „
Synthetic leather upholstery
The synthetic leather material used on the SUBARU
may be cleaned using mild soap or detergent and wa-
ter, after first vacuuming or brushing away loose dirt.
Allow the soap to soak in for a few minutes and wipe
off with a clean, damp cloth. Commercial foam-type
cleaners suitable for synthetic leather materials may
be used when necessary.

10-7
Appearance care
– CONTINUED –
NOTE
Strong cleaning agents such as solvents, paint
thinners, window cleaner or gasoline must never
be used on leather or synthetic interior materials. „Ashtray
Particles of ash and tobacco will accumulate around
the hinges of the ashtray’s inner lid. Clean them off us-
ing a toothbrush or other narrow-ended implement. „
Climate control panel, audio panel, in-
strument panel, console panel, switch-
es, combination meter, and other plas-tic surfaces
Gently wipe away contamination using a clean, soft
cloth moistened with cold or lukewarm water.
NOTE
Do not use organic solvents such as paint thin-
ners or gasoline, or strong cleaning agents that
contain those solvents.
US6060BA

11 - 2
Maintenance and service
Tires and wheels .......................................... 11-43Types of tires .................................................... 11-43
Tire inspection .................................................. 11-43
Tire pressures and wear .................................. 11-44
Wheel balance ................................................... 11-46
Wear indicators ................................................. 11-47
Tire rotation ....................................................... 11-48
Tire replacement ............................................... 11-48
Wheel replacement ........................................... 11-49
Aluminum wheels (if equipped) .................. 11-50
Windshield washer fluid .............................. 11-50
Replacement of wiper blades ...................... 11-51 Windshield wiper blades .................................. 11-52
Rear window wiper blade ................................. 11-54
Battery ........................................................... 11-58
Fuses ............................................................. 11-60
Main fuse ....................................................... 11-62
Installation of accessories .......................... 11-63
Replacing bulbs ............................................ 11-63 Headlight ........................................................... 11-64
Front turn signal, side marker light and parking lights ................................................. 11-66
Front fog light ................................................... 11-70
Rear combination lights ................................... 11-70
License plate light ............................................ 11-72
Dome light, map light and cargo area light .... 11-72
High mount stop light ...................................... 11-74

11 -5 1
Maintenance and service
– CONTINUED –
Never use engine coolant as washer fluid be-
cause it could cause paint damage.
Replacement of wiper blades
Grease, wax, insects, or other material on the wind-
shield or the wiper blade results in jerky wiper opera-
tion and streaking on the glass. If you cannot remove
the streaks after operating the windshield washer or if
the wiper operation is jerky, clean the outer surface of
the windshield (or rear window) and the wiper blades
using a sponge or soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning, rinse the wind-
shield and wiper blades with clean water. The wind-
shield is clean if beads do not form when you rinse the
windshield with water.
Do not clean the wiper blades with gasoline or
a solvent, such as paint thinner or benzene.
This will cause deterioration of the wiper
blades.
If you cannot eliminate the streaking even after follow-
ing this method, replace the wiper blades using the fol-
lowing procedures:
Washer Fluid Concentration Freezing Temperature
30% 10.4 °F (–12 °C)
50% –4 °F (–20 °C)
100% –49 °F (–45 °C)

11 - 5 4
Maintenance and service
A) Stopper
Be sure to position the claws at the end of the metal
support between the stoppers on the rubber as shown.
If the rubber is not retained properly, the wiper blade
may scratch the windshield.
6. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
7. Lower the wiper arm. „
Rear window wiper blade
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
A
HSB062BC
USB581BA

11 -5 7
Maintenance and service
– CONTINUED –
7. Align the claws of the plastic support with the
grooves in the blade rubber assembly, then slide the
blade rubber assembly into place. Securely lock the end of the plastic support as shown
in the illustration. If the rubber is not retained properly,
the wiper may scratch the rear window glass.
8. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
9. Lower the wiper arm.
USB586CAUSB584BA

12-7
Specifications
– CONTINUED –
1115AyEngine ignition system
y SRS airbag
y AT control system
1210AyIllumination brightness
control
1320AyWiper deicer
y Outside mirror defogger
1410AyMeter
1530AyWindshield wiper and
washer
1620AyBrake light
1715AyAir conditioner
1815AyBackup light
y Cruise control
1915AyPower outlet (cargo)
2010AyRear window wiper and
washer
2115AyIgnition coil (Non-turbo
model only)
Fuse panelFuse ratingCircuit
2215AySeat heater
23Empty
Fuse panelFuse ratingCircuit

12-8
Specifications
„
Fuse panel located in the engine com-
partment
A) FWD socket (AT models without Vehicle Dynamics Control system)
B) Main fuse
A
12 4
3 B
5
6 7
89
10 11 12
13
USC003BB
Fuse panelFuse ratingCircuit
130Ay
Radiator cooling fan
(Main)
230AyRadiator cooling fan
(Sub)
350AyVehicle Dynamics
Control system (Mod-
els with Vehicle Dy-
namics Control system
only)
30AyEngine sensor (Non-
turbo models only)
430AyABS motor
520AyRear window defogger
615AyHazard warning flasher
y Horn
715AyTurn signal lights
810AyAutomatic transmis- sion control unit
910AyAlternator

14-6
Index
Outside temperature indicator ........................... 3-11
Overhead console ............................................... 6-6 P
Parking brake ......................................... 7-34, 11-42
Stroke ......................................................... 11-42
Parking light switch ............................................ 3-27
Parking your vehicle .......................................... 7-34
Periodic inspections ............................................ 8-5 Power
Door locking switches ..................................... 2-8
Seat ................................................................ 1-5
Steering ........................................................ 7-21
Steering fluid level ...................................... 11-34
Windows ....................................................... 2-24
R
Rear Combination lights ...................................... 11-70
Differential gear oil level ............................. 11-33
Gate ..................................................... 2-27, 9-17
Seats ............................................................ 1-11
Viscous limited slip differential (LSD) ........... 7-21
Rear window
Defogger button ............................................ 3-33
Wiper and washer switch .............................. 3-31
Wiper blades ............................................... 11-54 Remote keyless entry system ............................. 2-9
Replacing
Air cleaner element .................................... 11-21
Battery (remote keyless entry) ..................... 2-11
Bulbs .......................................................... 11-63
Transmitters ................................................. 2-13
Rocking the vehicle ........................................... 8-14
Roof rail and crossbar ....................................... 8-17 S
Seat height adjustment (driver’s side) ................. 1-5
Seatbelt
Extender ....................................................... 1-29
Maintenance ................................................. 1-29
Pretensioners ............................................... 1-31
Safety tips ..................................................... 1-14
Warning light and chime ...................... 1-16, 3-13
Seatbelts ........................................................... 1-14Seats
Fabric ........................................................... 10-6
Heater ........................................................... 1-10
Security system ................................................. 2-17
Selector lever (AT vehicles) .............................. 7-16
Self-leveling rear suspension ............................ 7-43
Shift lock release ............................................... 7-20
Shift position indicator ....................................... 3-20
Shopping bag hook ........................................... 6-18