8
Trip meter A/B
selection and trip meter reset knob
Trip meter and odometer
Forester 2.5i
Forester 2.5i Premium Tachometer
TRIPCHECK
ENGINE
AW D
ABS
E
ASET
B
F
x1000r/min
AT OIL
TEMP
SELECT
Gauges
Seatbelt warning
Front passenger
seatbelt warning
SRS airbag system
Security indicator light
Door open
Charge warning
Oil pressure warning
Power steering warning Brake system
Hot coolant temperature /
Cold coolant temperature
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Windshield washer
fluid warning
Immediate Attention
Caution
Informational
1980916_16a_Subaru_Forester_QRG_061015.indd 86/10/15 10:59 AM
10
TRIPCHECK
ENGINE
AW D
SRF
OFF
EyeSighStay
AlertObstacle
Detected Lane
Departure
ABS
E
A
B
F
x1000r/min
AT OIL
TEMP
SELECT
Gauges
Forester 2.5i Limited
Forester 2.5i Touring
Forester 2.0i XT Premium
Forester 2.0i XT Touring
Seatbelt warning
Front passenger
seatbelt warning
SRS airbag system
Security indicator light
Door open
Charge warning
Oil pressure warning
Power steering warning Brake system
Hot coolant temperature /
Cold coolant temperature
High beam indicator light
AT OIL TEMP
(Automatic Transmission)
ABS warning
Low fuel
All-Wheel Drive
(Automatic Transmission)
Headlight leveler
(if equipped)
Immediate Attention
Caution
Informational
Trip meter A/B
selection and trip meter reset knob
Tachometer
1980916_16a_Subaru_Forester_QRG_061015.indd 106/10/15 10:59 AM
15
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob
downward to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a reduced brightness
high beam will be automatically turned on when the engine has started, the
parking brake is fully released and the light switch is in the “OFF” or “
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
1980916_16a_Subaru_Forester_QRG_061015.indd 156/10/15 11:00 AM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
