Shift SUBARU IMPREZA 2000 2.G Owner's Manual

Starting and operating7-55
–
CONTINUED –
4. Ap p ly the reg ular b rakes and then ap p ly the p arki
ng b rake; slowly
release the reg ular b rakes.
5. Shift into 1st or reverse g ear (manual transmissi on) or “P ” (auto-
matic transmission) and shut off the eng ine.
If the ABS warning lig ht illuminates while the vehi c le is in motion, stop
towing the trailer and have rep airs c arried out imm ed iately b y the
nearest SUBARU d ealer.

8-6mod erate sp eed . Then start the eng ine of the vehic l
e that has the d is-
c harg ed b attery.
6. When finished , c arefully d isc onnec t the c ab les in exac tly the re-
verse ord er.
Flat tires
WARNING
Do not jack up the vehicle on an incline or a loose road sur-
face. The jack can come out of the jacking point or sink into theground and this can result in a severe accident. Use only the jack provided with your vehicle. The jack sup-
plied with the vehicle is designed only for changing a tire. Neverget under the vehicle while supporting the vehicle with this jack. Always turn the engine off before raising the flat tire off the
ground using the jack. Never swing or push the vehicle sup-ported with the jack. The jack can come out of the jacking pointdue to a jolt and this can result in a severe accident. Do not use oil or grease on the wheel studs or nuts when the
spare tire is installed. This could cause the nuts to become looseand lead to an accident. Never place a tire or tire changing tools in the passenger
compartment after changing wheels. In a sudden stop or colli-
sions, loose equipment could strike occupants and cause injury.Store the tire and all tools in the proper place.
If you have a flat tire while d riving , never b rake sud d enly; keep d riving
straig ht ahead while g rad ually red uc ing sp eed . Then slowly p ull off the
road to a safe p lac e.
1. Park on a hard , level surfac e, whenever p ossib le, then stop the en-
g ine.
2. Set the p arking b rake sec urely and shift a manual transmission ve-
hic le in reverse or an automatic transmission vehic le in the “P ” (Park)
p osition.

8-14Towing
If towing is nec essary, it is b est d one b y your SUB
ARU d ealer or a c om-
merc ial towing servic e. Ob serve the following p roc e d ures for safety.
Transporting your vehicle using a flat-bed truck
HG0108
This is the b est way to transp ort your vehic le. Use the following p roc e-
d ures to ensure safe transp ortation.
1. Shift the selec tor lever into the “P ” p osition for automatic transmis-
sion vehic les or “1st ” for manual transmission vehic les.
2. Pull up the p arking b rake lever firmly.
3. Sec ure the vehic le onto the c arrier p rop erly with safety c hains.
Eac h safety c hain should b e eq ually tig htened and c are must b e
taken not to p ull the c hains so tig htly that the su sp ension b ottoms out.
Towing with the front wheels raised off the ground
WARNING
Never tow manual transmission AWD vehicles with the front wheels raised off the ground while the rear wheels are on theground. This will cause the vehicle to spin away due to the opera-tion or deterioration of the viscous coupling.

10-20SAE viscosity No. and Applicable Temperature
OM-H0205
Automatic transmission fluid
Checking the fluid level
The automatic transmission fluid exp and s larg ely as its temp erature
rises; the fluid level d iffers ac c ord ing to fluid t emp erature. Therefore,
there are two d ifferent sc ales for c hec king the lev el of hot fluid and
c old fluid on the d ip stic k.
Thoug h the fluid level c an b e c hec ked without warmi ng up the fluid
on the “COLD ” sid e, we rec ommend c hec king the fluid level when t he
fluid is at op erating temp erature. n Checking the fluid level when the fluid is hot
Chec k the fluid level monthly.
1. Drive the vehic le several miles to raise the temp erature of the
transmission fluid up to normal op erating temp eratu re; 140 to 176F
(60 to 80 C) is normal.
2. Park the vehic le on a level surfac e and set the p arking b rake.
3. First shift the selec tor lever in eac h p osition. Then shift it in the “P ”
p osition, and run the eng ine at id ling sp eed .

10-36Clutch pedal (Manual transmission vehicles)
Chec k the c lutc h p ed al free p lay and reserve d istan
c e ac c ord ing to the
maintenanc e sc hed ule in the “Warranty and Maintenanc e Booklet ”.
Checking the clutch function
Chec k the c lutc h eng ag ement and d iseng ag ement.
1. With the eng ine id ling , c hec k that there are no a b normal noises
when the c lutc h p ed al is d ep ressed , and that shifti ng into 1st or re-
verse feels smooth.
2. Start the vehic le b y releasing the p ed al slowly t o c hec k that the en-
g ine and transmission smoothly c oup le without any s ig n of slip p ag e.
Checking the clutch pedal free play
OM-H0224
2.5L MT models
0.11 — 5.59 in
(3.0 — 15.0 mm)
2.2L MT models 0.40 — 0.79 in
(10.0 — 20.0 mm)
Lig htly p ress the c lutc h p ed al d own with your fing e r until you feel re-
sistanc e, and c hec k the free p lay.
If the free p lay is not within p rop er sp ec ific ation , c ontac t your
SUBARU d ealer.

11-6Fuse panel Circuit
Fuse rating
10Emp ty
1115AEng ine ig nition system
SRS airb ag
1210AIllumination b rig htness c ontrol
13Emp ty
1415AAT shift loc k unit
ABS c ontrol
Cruise c ontrol
1520AWind shield wip er and washer
Rear wind ow wip er and washer
1620ABrake lig ht
1715AAir c ond itioner
1815ABac kup lig ht
Turn lig ht
SRS airb ag system warning lig ht
1920ARear ac c essory p ower soc ket
Seat heater