flat tire SUBARU IMPREZA WRX 2003 2.G User Guide

9
9-1
– CONTINUED –
If you park your vehicle in case of
an emergency 9-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Temporary spare tire (if equipped) 9-3 . . . . . . . . . . . .
Flat tires 9-5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Changing a flat tire 9-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Jump starting 9-14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
How to jump start 9-15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Engine overheating 9-17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If steam is coming from the engine compartment 9-17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If no steam is coming from the engine compartment 9-17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Towing 9-18
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Towing and tie-down hooks 9-19 . . . . . . . . . . . . . . . . . . . . .
Using a flat-bed truck 9-21 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Towing with all wheels on the ground 9-22 . . . . . . . . .
Maintenance tools 9-23 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Jack and jack handle 9-24 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
In case of emergency

In case of emergency
9-3
– CONTINUED –
Temporary spare tire (if equipped)
The temporary spare tire is smaller and lighter than
a conventional tire and is designed for emergency
use only. Remove the temporary spare tire and re-
install the conventional tire as soon as possible be-
cause the spare tire is designed only for temporary use.
Check the inflation pressure of the temporary spare
tire periodically to keep the tire ready for use. The
correct pressure is 60 psi (4.2 kg/cm2
, 420 kPa) .
When using the temporary spare tire, note the fol-lowing: Do not exceed 50 mph (80 km/h).
Do not put a tire chain on the temporary spare tire.
Because of the smaller tire size, a tire chain will not
fit properly. Do not use two or more temporary spare tires at
the same time. Do not drive over obstacles. This tire has a smaller
diameter, so road clearance is reduced.
1) Tread wear indicator bar
2) Indicator location mark
When the wear indicator appears on the tread, re-
place the tire.

In case of emergency
9-5
– CONTINUED –
Flat tires
If you have a flat tire while driving, never brake sud- denly; keep driving straight ahead while gradually
reducing speed. Then slowly pull off the road to asafe place. Changing a flat tire
WARNING
Do not jack up the vehicle on an incline or a
loose road surface. The jack can come out of
the jacking point or sink into the ground and this can result in a severe accident. Use only the jack provided with your ve-
hicle. The jack supplied with the vehicle is de-signed only for changing a tire. Never get un-der the vehicle while supporting the vehicle with this jack. Always turn the engine off before raising the
flat tire off the ground using the jack. Neverswing or push the vehicle supported with the
jack. The jack can come out of the jackingpoint due to a jolt and this can result in a
severe accident. 1. Park on a hard, level surface, whenever possible,
then stop the engine.
2. Set the parking brake securely and shift a manual
transmission vehicle in reverse or an automatictransmission vehicle in the
“P” (Park) position.
3. Turn on the hazard warning flasher and have ev-
eryone get out of the vehicle.
4. Put wheel blocks at the front and rear of the tire
diagonally opposite the flat tire.

In case of emergency
9-11
– CONTINUED –
Others 8. Place the jack under the side sill at the front or
rear jack-up point closest to the flat tire.
Turn the jackscrew by hand until the jack head en-
gages firmly into the jack-up point.
9. Insert the jack handle into the jackscrew, and
turn the handle until the tire clears the ground. Do
not raise the vehicle higher than necessary.
10. Remove the wheel nuts and the flat tire.

In case of emergency
9-13
– CONTINUED –
the wheel nuts to the specified torque, following the
tightening order in the illustration.
The torque for tightening the nuts is 58 to 72 ft-lb (80
to 100 N-m, 8 to 10 kg-m). This torque is equivalentto applying about 88 to 110 lbs (40 to 50 kg) at the
top of the wheel nut wrench. Never use your foot on
the wheel nut wrench or a pipe extension on the
wrench because you may exceed the specified
torque. Have the wheel nut torque checked at the
nearest automotive service facility.
15. Store the flat tire in the spare tire compartment.
Put the spacer and tighten the attaching bolt firmly.
Also store the jack and wheel nut wrench in theirstorage locations.
After placing the jack in its storage location, turn the
jackscrew clockwise by hand until it becomes too
hard to turn. Then, tighten it by an additional 1/4 –
1/3 of a turn using a screwdriver or the jack handle.
Unless the jack is properly secured, it may rattlewhile the vehicle is moving.

In case of emergency
9-25
– CONTINUED –
Wagon
1) Jack
2) Jack handle 3) Spare tire
The jack handle is stored under the spare tire cover.
For how to use the jack, refer to “Flat tires ”.

Maintenance and service
11-49
– CONTINUED –
Wheel covers
Removing the wheel cover
Insert the wheel cover remover into the notch pro-
vided, and pry the wheel cover off.
Installing the wheel cover
Align the valve with the valve hole in the cover, then fit the cover on the wheel by tapping your hand
evenly around the circumference of the cover. NOTE When any of the wheels is removed and replaced for tire rotation or to change a flat tire, always
check the tightness of the wheel nuts after driv-ing approximately 600 miles (1,000 km). If anynut is loose, tighten it to the specified torque.

Maintenance and service
11-50
Aluminum wheels (If equipped)
Aluminum wheels can be scratched and damaged
easily. Handle them carefully to maintain their ap-
pearance, performance, and safety. When any of the wheels is removed and replaced
for tire rotation or to change a flat, always check the
tightness of the wheel nuts after driving approxi-mately 600 miles (1,000 km). If any nut is loose,
tighten it to the specified torque. Never apply oil to the threaded parts, wheel nuts,
or tapered surface of the wheel. Never let the wheel rub against sharp protrusions
or curbs. Be sure to fit tire chains on uniformly and com-
pletely around the tire, otherwise the chains mayscratch the wheel. When wheel nuts, balance weights, or the center
cap is replaced, be sure to replace them with genu-
ine SUBARU parts designed for aluminum wheels. Windshield washer fluid
Check the level of the washer fluid at each fuel stop.
If the level is low, fill the fluid up to the neck of the
reservoir. Use windshield washer fluid. If windshield washer
fluid is unavailable use clean water.
In areas where water freezes in winter, use an anti-
freeze type windshield washer fluid. SUBARU Wind-
shield Washer Fluid contains 58.5% methyl alcohol
and 41.5% surfactant, by volume. Its freezing tem-
perature varies according to how much it is diluted,
as indicated below.

Specifications
12-10
Vehicle identification
1) Vehicle identification number
2) Vacuum hose connectionslabel/Emission control label
3) Tire inflation pressure label
4) Certification plate
5) Bar cord label (USA only)
6) Vehicle identification number plate
7) Model number plate

Consumer information and Reporting safety defects
13-3
– CONTINUED –
WARNING
The traction grade assigned to this tire is based on straight-ahead braking tractiontests, and does not include acceleration, cor-
nering, hydroplaning, or peak traction charac- teristics.
Temperature A, B, C
The temperature grades are A (the highest), B, and
C, representing the tire ’s resistance to the genera-
tion of heat and its ability to dissipate heat when
tested under controlled conditions on a specified in-
door laboratory test wheel. Sustained high tempera-
ture can cause the material of the tire to degenerate
and reduce tire life, and excessive temperature can
lead to sudden tire failure. The grade C corresponds
to a level of performance which all passenger car
tires must meet under the Federal Motor Vehicle
Safety Standards No. 109. Grades B and A repre-
sent higher levels of performance on the laboratory
test wheel than the minimum required by law.
WARNING
The temperature grade for this tire is estab- lished for a tire that is properly inflated andnot overloaded. Excessive speed, underinfla-tion, or excessive loading, either separately or in combination, can cause heat buildup and
possible tire failure.