dimensions SUBARU LEGACY 1995 Service Owner's Manual

4. REAR DOOR GLASS
Alignment of rear door glass is basically the same as for
the front door glass. Due to slight difference in adjustment
dimensions for fore-aft, up-down, and in-out alignments,
key points for rear door adjustment are described below.
B5M0078A
B5M0074A
Fore-aft adjustment
1) Door glass alignment must be adjusted so that glass-
to-center pillar fit is equal at all points. Always use dimen-
sions (indicated in figure) as a guide during adjustment.
NOTE:
If dimensions are smaller than those indicated, glass will be
caught in weatherstrip and may not raise to the fully closed
position.
2) After making fore-aft adjustment, raise and lower glass
to ensure it is free from any binding.
25
5-2SERVICE PROCEDURE
2. Door

B5M0076A
Fit adjustment
Increasing contact pressure causes rear door glass to be
caught in center pillar upper and lower weatherstrip; this
will cause premature weatherstrip wear. For this reason,
always use dimensions indicated below as a guide during
glass fit adjustment.
C: INSPECTION
1. FRONT AND REAR DOOR GLASS
1) Close front door and make sure of all clearances.
B5M0079A
2) If any clearance is not correct, adjust affected parts.
Re-check all clearances.
CAUTION:
Repeatedly adjust parts until all clearances are cor-
rect.
After clearance adjustment, make sure that all
adjusting bolts and nuts are tightened.
26
5-2SERVICE PROCEDURE
2. Door