child lock SUBARU LEGACY 1999 Service Repair Manual

6) Remove nut and then separate glass holder (A)
from guide channel A (B).
B5M0064C
NOTE:
When removing nut, move door window lower
glass connecting section to service hole of door
panel.
7) Remove window glass upward.
CAUTION:
After removing window glass, do not move
regulator.
8) Remove regulator installing bolt and guide
channel B installing nut.
B5M0065
9) Remove regulator through lower service hole of
door panel.
10) Installation is in the reverse order of removal.
6. INNER REMOTE
1) Remove trim panel.
2) Remove sealing cover.
3) Disconnect joints of two rods.
G5M0394
4) Unlatch rod holder.
5) Remove remote holder (A) and then remove
inner remote assembly (B).
B5M0066C
6) Installation is in the reverse order of removal.
NOTE:
IAfter passing two rods through holder, attach
remote assembly to inner panel.
ILatch rod holder.
7) Lock the door and then loosen bolt (A).
8) Lower bell-crank (B) and then tighten bolt (A).
B5M0330C
NOTE:
If rear door is equipped with child safety lock,
check that child lock lever moves without dragging.
7. DOOR LATCH
1) Remove trim panel.
2) Remove inner remote assembly. [W2A6].>
3) Remove sealing cover around latch service
hole.
4) Completely close door glass.
5) Remove latch and actuator assembly:
16
5-2[W2A6]SERVICE PROCEDURE
2. Door