wheel SUBARU LEGACY 2000 3.G Owner's Manual

Instruments and controls3-33
–
CONTINUED –
HB4004CB
To turn on the outsid e mirror d efog g er, p ush the sw itc h while the en-
g ine is running .
The ind ic ator lig ht loc ated on the switc h will c ome on when the out-
sid e mirror d efog g er heater in op eration.
To turn it off, p ush the switc h ag ain.
Tilt steering wheel
WARNING
Do not adjust the steering wheel tilt position while driving. This
may cause loss of vehicle control and result in personal injury.
HB4002BA

3-341. Ad just the seat p osition. Refer to the
“Front seat ” sec tion (c hap ter 1).
2. Pull the tilt loc k lever d own.
3. Move the steering wheel to the d esired level.
4. Push the lever up to loc k the steering wheel in p lac e.
5. Make sure that the steering wheel is sec urely loc ked b y moving it up
and d own.
Horn
OM-H0440
To sound the horn, p ush the horn p ad .

Climate control4-7
–
CONTINUED –
4. Set the fan sp eed c ontrol d ial to the hig hest sp e
ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Heating and defrosting
HB5012AA
To d irec t warm air toward the floor and the wind shi eld :
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.

4-8
Heating
HB5013AA
To d irec t warm air toward the floor:
1. Set the air inlet selec tion b utton to the “OFF ” p osition
2 Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Bi-level heating
HB5014AA
This setting allows you to d irec t air of d ifferent temp eratures from the

7-63. Stop filling the tank after the fuel filler p ump
automatic ally c lic ks off.
Do not ad d any more fuel.
4. Put the c ap b ac k on, turn it c loc kwise until you hear a c lic king
noise. Be c ertain not to c atc h the tether und er the c ap while tig hten-
ing .
5. Close the fuel filler lid c omp letely.
If you sp ill any fuel on the p ainted surfac e, rinse it off immed iately.
Otherwise, the p ainted surfac e c ould b e d amag ed . NOTE If the fuel filler cap is not tightened until it clicks or if the tether is caught under the cap, the CHECK ENGINE warning light maycome on. Refer to the “Warning and indicator lights ” section lo-
cated in chapter 3.
State emission testing (U.S. only)
WARNING
Testing of an All-Wheel Drive vehicle must NEVER be performed
on a single two-wheel dynamometer. Attempting to do so willresult in uncontrolled vehicle movement and may cause an acci-
dent or injuries to persons nearby.
CAUTION
Resultant vehicle damage due to improper testing is not covered
under the SUBARU Limited Warranty and is the responsibility ofthe state inspection program or its contractors or licensees.
At state inspection time, remember to tell your inspection or service
station in advance not to place your Subaru AWD vehicle on a two-
wheel dynamometer. Otherwise, serious transmission damage willresult.
Some states have started using d ynamometers in thei r state insp ec tion
p rog rams in ord er to meet their ob lig ation und er fe d eral law to imp lement

Starting and operating7-7
–
CONTINUED –
stric ter vehic le emission stand ard s to red uc e air p
ollution from c ars. A
d ynamometer is a tread mill or roller-like testing d evic e that allows your
c ar ’s wheels to turn while the c ar remains in one p lac e . Dep end ing on
the severity of a state ’s air p ollution p rob lems, the states must ad op t
either a “b asic ” or “enhanc ed ” vehic le emission insp ec tion test. Nor-
mally, a p ortion of the b asic emission test c onsist s of an emission
insp ec tor inserting an analyzer p rob e into the exha ust p ip e of an id ling
vehic le for a short p eriod of time. States with mor e severe air p ollution
p rob lems are req uired to ad op t an enhanc ed vehic le emission test. This
test simulates ac tual d riving c ond itions on a d ynam ometer and p ermits
more ac c urate measurement of tailp ip e emitted p ollu tion than the b asic
emission test.
The U.S. Environmental Protec tion Ag enc y (EPA) and states using two-
wheel d ynamometers in their emission testing p rog ra ms have
EXEMPTED Sub aru AWD vehic les from the p ortion of the testin g p ro-
g ram that involves a two-wheel d ynamometer.
There are some states that use four-wheel d ynamomet ers in their testing
p rog rams. When p rop erly used , that eq uip ment will n ot d amag e an AWD
Sub aru vehic le.
Und er no c irc umstanc es should the rear wheels b e ja c ked off the
g round , nor should the d riveshaft b e d isc onnec ted f or state emission
testing .
Preparing to drive
You should p erform the following c hec ks and ad justm ents every d ay b e-
fore you start d riving .
1. Chec k that all wind ows, mirrors, and lig hts are c lean and unob -
struc ted .
2. Chec k the ap p earanc e and c ond ition of the tires. Also c hec k tires for
p rop er inflation.
3. Look und er the vehic le for any sig n of leaks.
4. Chec k that the hood , trunk and rear g ate are full y c losed .
5. Chec k the ad justment of the seat.
6. Chec k the ad justment of the insid e and outsid e mi rrors.

7-10
Starting the engine during cold weather below –4F
(–20 C)
If the eng ine is d iffic ult to start using the norma l method (without d e-
p ressing the ac c elerator p ed al), turn the ig nition switc h to the “START ”
p osition while slig htly d ep ressing the ac c elerator p ed al.
Starting a flooded engine
If the eng ine d oes not start, it may b e flood ed (ex c essive fuel in the en-
g ine).
In c ase of a flood ed eng ine, turn the starter motor for five sec ond s with
the ac c elerator p ed al fully d ep ressed . Rep eat this two or three times until
the eng ine starts. Release the ig nition switc h and ac c elerator p ed al as
soon as the eng ine starts.
Stopping the engine
WARNING
Do not stop the engine when the vehicle is moving. This will
cause loss of power to the power steering and the brake booster,making steering and braking more difficult. It could also result in
accidental activation of the “LOCK” position on the ignition
switch, causing the steering wheel to lock.
The ig nition switc h should b e turned off only when the eng ine is id ling .

7-12
Shifting speeds
n Recommended shifting speeds
The b est c omp romise b etween fuel ec onomy and vehic l e p erfor-
manc e d uring normal d riving is ensured b y shifting up at the sp eed s
listed in the following tab le.
Shift up
mp h (km/h)
1st to 2nd15 (24)
2nd to 3rd25 (40)
3rd to 4th40 (65)
4th to 5th45 (73)
nMaximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travel- ling at a speed exceeding the Maximum Allowable Speed for thegear which is about to be selected. Failure to observe this pre-caution can lead to engine over-revving and this in turn canresult in engine damage.In addition, sudden application of engine brakes when the vehicleis travelling on a slippery surface can lead to wheel locking; as a
consequence, control of the vehicle may be lost and the risk ofan accident increased.
The following tab le shows the maximum sp eed s that a re p ossib le with
eac h d ifferent g ear.
Never exc eed the sp eed limit b elow for eac h g ear p o sition exc ep t for
b rief ac c eleration in an emerg enc y. The tac hometer ’s need le (if so
eq uip p ed ) will enter the red area if these sp eed s a re exc eed ed . Fail-
ure to ob seve this p rec aution c an lead to exc essive eng ine wear and
p oor fuel ec onomy.

7-16
N (Neutral)
WARNING
Do not drive the vehicle with the selector lever in the “N” (neutral)
position. Engine braking has no effect in this condition and the risk of an accident is consequently increased.
This p osition is for restarting a stalled eng ine.
In this p osition the wheels and transmission are no t loc ked . In this
p osition, the transmission is neutral; the vehic le will roll freely, even on
the slig htest inc line unless the p arking b rake or f oot b rake is on.
D (Drive)
This p osition is for normal d riving .
The transmission automatic ally shifts into a suitab le g ear from 1st to
4th ac c ord ing to the vehic le sp eed and the ac c elera tion you req uire.
When more ac c eleration is req uired in this p osition , p ress the ac c eler-
ator p ed al fully to the floor and hold that p ositio n. The transmission
will automatic ally d ownshift to 3rd , 2nd or 1st g ea r. When you release
the p ed al, the transmission will return to the orig inal g ear p osition.
n While climbing a grade
When d riving up a hill, und esired up shift to 4th g e ar is p revented from
taking p lac e when the ac c elerator is released . This minimizes the
c hanc e of sub seq uent d ownshifting to a lower g ear w hen ac c elerat-
ing ag ain. This p revents rep eated up shifting and d o wnshifting result-
ing in a smoother op eration of the vehic le. NOTE
The transmission may downshift to 2nd or 1st gear, depending on the way the accelerator pedal is pressed to accelerate the vehicleagain. n While going down a hill
When d esc end ing a steep hill, d ep ressing the b rake p ed al will c ause
the transmission to d ownshift to 3rd g ear, thus ap p lying eng ine b rak-
ing . Reac c eleration for a short time will c ause the transmission to up -

7-18
Maximum speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travel- ling at a speed exceeding the Maximum Allowable Speed for thegear which is about to be selected. Failure to observe this pre-caution can lead to engine over-revving and this in turn canresult in engine damage.In addition, sudden application of engine brakes when the vehicleis travelling on a slippery surface can lead to wheel locking; as a
consequence, control of the vehicle may be lost and the risk ofan accident increased.
The following tab les show the maximum sp eed s that a re p ossib le with
eac h d ifferent g ear. The tac hometer ’s (if so eq uip p ed ) need le will
enter the red area if these sp eed s are exc eed ed .
When shifting d own a g ear, it is imp ortant to c onfi rm that the c urrent
vehic le sp eed is not in exc ess of the Maximum Allow ab le Sp eed of
the g ear whic h is ab out to b e selec ted .
Exc eed ing the Maximum Allowab le Sp eed s will result in over-revving
of the eng ine. In ad d ition a p owerful eng ine b rake will eng ag e and
c ontrol of the vehic le may b e lost.
mph (km/h)
Vehicle type
PositionBrighton, LGTOUTBACK
133 (53)27 (43)29 (47)
264 (103)57 (92)62 (100)
3102 (164)97 (156)104 (167)
NOTE In order to prevent over-revving during acceleration of the
vehicle, the transmission will automatically shift to the next high- est gear if the Maximum Allowable Speed for the current gear isexceeded.