oil level SUBARU LEGACY 2000 3.G Owners Manual

3-12
If the light is blinking:
If the lig ht is b linking while d riving , an eng ine m isfire c ond ition has
b een d etec ted whic h may d amag e the emission c ontrol system.
To p revent serious d amag e to the emission c ontrol s ystem, you
should d o the following : Red uc e vehic le sp eed .
Avoid hard ac c eleration.
Avoid steep up hill g rad es.
Red uc e the amount of c arg o, if p ossib le.
Stop towing a trailer as soon as p ossib le.
The CHECK ENGINE warning lig ht may stop b linking an d c ome on
stead ily after several d riving trip s. You should ha ve your vehic le
c hec ked b y an authorized SUBARU d ealer immed iately.
Charge warning light
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
c harg ing system is not working p rop erly.
If the lig ht c omes on while d riving or d oes not g o out after the eng ine
starts, stop the eng ine at the first safe op p ortuni ty and c hec k the alterna-
tor b elt. If the b elt is loose, b roken or if the b e lt is in g ood c ond ition b ut
the lig ht remains on, c ontac t your nearest SUBARU d ealer immed iately.
Oil pressure warning light
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause serious engine damage.
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
eng ine oil p ressure is low and the lub ric ating syst em is not working p rop -
erly.
If the lig ht c omes on while d riving or d oes not g o out after the eng ine
starts, stop the eng ine at the first safe op p ortuni ty and c hec k the eng ine
oil level. If the oil level is low, ad d oil immed ia tely. If the eng ine oil is at

Instruments and controls3-13
–
CONTINUED –
the p rop er level b ut the lig ht remains on, c ontac t
your nearest SUBARU
d ealer immed iately. AT OIL TEMPerature warning light
(for AT vehicles)
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
automatic transmission fluid temp erature is too hot .
If the lig ht c omes on while d riving , it is unnec ess ary to stop the vehic le,
b ut avoid d riving up steep g rad es or in stop and g o traffic .
Automatic transmission control system warning
If the lig ht flashes after the eng ine starts, it ma y ind ic ate that the auto-
matic transmission c ontrol system is not working p r op erly. Contac t
your nearest SUBARU d ealer for servic e immed iately.
ABS warning light
The ABS warning lig ht c omes on when the ig nition sw itc h is turned to the
“ ON ” p osition and g oes out after ab out two sec ond s.
This is an ind ic ation that the ABS system is workin g p rop erly.
If the warning lig ht b ehaves as follows, the ABS sy stem may not work
p rop erly. The warning lig ht d oes not c ome on when the ig nitio n switc h is turned
to the “ON ” p osition.
The warning lig ht c omes on when the ig nition switc h is turned to the
“ ON ” p osition, b ut it d oes not g o out even when the veh ic le sp eed
exc eed s ap p roximately 8 mp h (12 km/h). The warning lig ht c omes on d uring d riving .
When the warning lig ht is on, the ABS func tion shut s d own; however, the
c onventional b rake system c ontinues to op erate norm ally. If this oc c urs,
have the ABS system rep aired at the first availab le op p ortunity b y your
SUBARU d ealer.
(U.S.) (Canada)

7-8
7. Fasten your seatb elt. Chec k that your p asseng ers
have fastened their
seatb elts.
8. Chec k the op eration of the warning and ind ic ator lig hts when the ig ni-
tion switc h is turned to the “ON ” p osition.
9. Chec k the g aug es, ind ic ator and warning lig hts af ter starting the en-
g ine. NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
levels should be checked daily, weekly or at fuel stops.
Starting the engine
CAUTION
Do not operate the starter motor continuously for more than ten
seconds. If the engine fails to start after operating the starter forfive to ten seconds, wait for ten seconds or more before tryingagain.
Starting the engine for a manual transmission vehicle
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Press the c lutc h p ed al to the floor and shift the shift lever into neutral.
Hold the c lutc h p ed al to the floor while starting t he eng ine. The starter
motor will only op erate when the c lutc h p ed al is p r essed fully to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op eration
of the warning and ind ic ator lig hts. Refer to the “Warning and ind ic ator
lig ht ” sec tion (c hap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine has
started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then turn
the ig nition switc h to the “START ” p osition ag ain while d ep ressing the ac -
c elerator p ed al half way d own.

In case of emergency9-23
–
CONTINUED –

Towing with all wheels on the ground
WARNING
Never turn the ignition switch to the “LOCK” position while the
vehicle is being towed because the steering wheel and the direc- tion of the wheels will be locked. Remember that the brake booster and power steering do not
function when the engine is not running. Because the engine isturned off, it will take greater effort to operate the brake pedal andsteering wheel.
CAUTION
If transmission failure occurs, transport your vehicle on a flat-
bed truck. For vehicles with automatic transmission, the traveling speed
must be limited to less than 20 mph (30 km/h) and the traveling
distance to less than 31 miles (50 km). For greater speeds and
distances, transport your vehicle on a flat-bed truck.
HB8010AA
1. Chec k the transmission and d ifferential oil level s and ad d oil to
b ring it to the up p er level if nec essary.
2. Release the p arking b rake and p ut the transmissio n in neutral.
3. The ig nition switc h should b e in the “ACC ” p osition while the ve-
hic le is b eing towed .

Maintenance and service11-7
–
CONTINUED –
Engine compartment overview
HBB036BB
1 Manual transmission oil level
g aug e (MT) (p ag e 11-20) or
Differential g ear oil level g aug e
(AT) (p ag e 11-23)
2 Air c leaner element
(p ag e 11-17)
3 Clutc h fluid reservoir
(p ag e 11-29)
4 Automatic transmission fluid
level g aug e (p ag e 11-21)
5 Brake fluid reservoir
(p ag e 11-27)
6 Fuel filter 7
Wind shield washer tank
(p ag e 11-39)
8 Fuse b ox (p ag e 11-43)
9 Battery (p ag e 11-42)
Q Eng ine oil filler c ap
(p ag e 11-8)
W Eng ine c oolant reservoir
(p ag e 11-14)
E Rad iator c ap (p ag e 11-14)
R Eng ine oil level g aug e
(p ag e 11-8)
T Power steering fluid reservoir
(p ag e 11-26)

11-8Engine oil
Checking the oil level
Chec k the eng ine oil level at eac h fuel stop .
OM-H0189HBB004BA
1. Park the vehic le on a level surfac e and stop the eng ine.
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Be sure the d ip stic k is c orrec tly inserted until it stop s with the
g rap hic symb ol
on its top ap p earing as shown in the illustra-
tion.
4. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil to b ring the level up to t he up p er level.
CAUTION
Use only engine oil with the recommended grade and viscosity.
If you c hec k the oil level just after stop p ing the eng ine, wait a few min-
utes for the oil to d rain b ac k into the oil p an b ef ore c hec king the level.
Just after d riving or while the eng ine is warm, the eng ine oil level
read ing may b e in a rang e b etween the up p er level a nd the notc h
mark. This is c aused b y thermal exp ansion of the en g ine oil.
To p revent overfilling the eng ine oil, d o not ad d a ny ad d itional oil
ab ove the up p er level when the eng ine is c old .

Maintenance and service11-9
–
CONTINUED –

Changing the oil and oil filter
Chang e the oil and oil filter ac c ord ing to the main tenanc e sc hed ule in
the “Warranty and Maintenanc e Booklet ”.
The eng ine oil and oil filter must b e c hang ed more freq uently than
listed in the maintenanc e sc hed ule when d riving on d usty road s,
when short trip s are freq uently mad e, or when d rivi ng in extremely
c old whether.
1. Warm up the eng ine b y letting the eng ine id le for ab out 10 minutes
to ease d raining the eng ine oil.
2. Park the vehic le on a level surfac e and stop the eng ine.
3. Remove the oil filler c ap .
HBB005BB
4. Drain out the eng ine oil b y removing the d rain p l ug while the en-
g ine is still warm. The used oil should b e d rained into an ap p rop riate
c ontainer and d isp osed of p rop erly.
WARNING
Be careful not to burn yourself with hot engine oil.
5. Wip e the seating surfac e of the d rain p lug with a c lean c loth and
tig hten it sec urely with a new sealing washer after the oil has c om-
p letely d rained out.

Maintenance and service11-11
–
CONTINUED –
12. Reinstall the c over und er the oil filter.
13. Pour the sp ec ified amount of eng ine oil throug h
the filler nec k.
Oil c ap ac ity: 4.2 US q t (4.0 liters, 3.5 Imp q t)
14. Start the eng ine and make sure that no oil leak s ap p ear around
the filter ’s rub b er seal.
15. Run the eng ine until it reac hes the normal op er ating temp erature.
Then stop the eng ine and wait a few minutes to allo w the oil d rain
b ac k. Chec k the oil level ag ain and if nec essary, a d d more eng ine oil.
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new API certification mark (Starburst mark) dis-
played on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities

11-20p ulleys and ap p ly a forc e of 22 lb (98 N, 10 kg ) mi
d way b etween the
p ulleys b y using a sp ring sc ale. Belt d eflec tion sh ould b e the amount
sp ec ified . If a b elt is loose, c rac ked , or worn, c o ntac t your SUBARU
d ealer.
Manual transmission oil
Checking the oil level
Chec k the oil level monthly.
1. Park the vehic le on a level surfac e and stop the eng ine.
OM-H0210
Upper level Lower level
HBB004DB
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil throug h the d ip stic k hole to b ring the level up
to the up p er level. Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5

Maintenance and service11-23
–
CONTINUED –
Front differential gear oil (AT vehicles)
Checking the oil level
Chec k the d ifferential oil level monthly.
HBA010BB
Lower level Upper levelHBB004EB
1. Park the vehic le on a level surfac e and stop the
eng ine.
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil to b ring the level up to t he up p er level.
Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5