oil level SUBARU LEGACY 2001 3.G Owners Manual

Instruments and controls3-13
–
CONTINUED –

Oil pressure warning light
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause serious engine damage.
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
eng ine oil p ressure is low and the lub ric ating syst em is not working p rop -
erly.
If the lig ht c omes on while d riving or d oes not g o out after the eng ine
starts, stop the eng ine at the first safe op p ortuni ty and c hec k the eng ine
oil level. If the oil level is low, ad d oil immed ia tely. If the eng ine oil is at
the p rop er level b ut the lig ht remains on, c ontac t your nearest SUBARU
d ealer immed iately. AT OIL TEMPerature warning light
(for AT vehicles)
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
automatic transmission fluid temp erature is too hot .
If the lig ht c omes on while d riving , it is unnec ess ary to stop the vehic le,
b ut avoid d riving up steep g rad es or in stop and g o traffic .
Automatic transmission control system warning
If the lig ht flashes after the eng ine starts, it ma y ind ic ate that the auto-
matic transmission c ontrol system is not working p r op erly. Contac t
your nearest SUBARU d ealer for servic e immed iately.
ABS warning light
The ABS warning lig ht c omes on when the ig nition sw itc h is turned to the
“ ON ” p osition and g oes out after ab out two sec ond s.
This is an ind ic ation that the ABS system is workin g p rop erly.
(U.S.) (Canada)

7-8
Preparing to drive
You should p erform the following c hec ks and ad justm
ents every d ay b e-
fore you start d riving .
1. Chec k that all wind ows, mirrors, and lig hts are c lean and unob -
struc ted .
2. Chec k the ap p earanc e and c ond ition of the tires. Also c hec k tires for
p rop er inflation.
3. Look und er the vehic le for any sig n of leaks.
4. Chec k that the hood , trunk and rear g ate are full y c losed .
5. Chec k the ad justment of the seat.
6. Chec k the ad justment of the insid e and outsid e mi rrors.
7. Fasten your seatb elt. Chec k that your p asseng ers have fastened their
seatb elts.
8. Chec k the op eration of the warning and ind ic ator lig hts when the ig ni-
tion switc h is turned to the “ON ” p osition.
9. Chec k the g aug es, ind ic ator and warning lig hts af ter starting the en-
g ine. NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
levels should be checked daily, weekly or at fuel stops.
Starting the engine
CAUTION
Do not operate the starter motor continuously for more than ten
seconds. If the engine fails to start after operating the starter forfive to ten seconds, wait for ten seconds or more before tryingagain.
Starting the engine for a manual transmission vehicle
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.

In case of emergency9-5
–
CONTINUED –

Do not use oil or grease on the wheel studs or nuts when the
spare tire is installed. This could cause the nuts to become loose and lead to an accident. Never place a tire or tire changing tools in the passenger
compartment after changing wheels. In a sudden stop or colli-
sions, loose equipment could strike occupants and cause injury.Store the tire and all tools in the proper place.
If you have a flat tire while d riving , never b rake sud d enly; keep d riving
straig ht ahead while g rad ually red uc ing sp eed . Then slowly p ull off the
road to a safe p lac e.
1. Park on a hard , level surfac e, whenever p ossib le, then stop the en-
g ine.
2. Set the p arking b rake sec urely and shift a manual transmission ve-
hic le in reverse or an automatic transmission vehic le in the “P ” (Park)
p osition.
3. Turn on the hazard warning flasher and have every one g et out of the
vehic le.
4. Put wheel b loc ks at the front and rear of the tir e d iag onally op p osite
the flat tire.
OM-H2259
Jacking position
Wheel blocks

9-14Engine overheating
WARNING
Never attempt to remove the radiator cap until the engine has been shut off and has fully cooled down. When the engine is hot,the coolant is under pressure. Removing the cap while the engineis still hot could release a spray of boiling hot coolant, which
could burn you very seriously.
If the eng ine overheats, safely p ull off the road a nd stop the vehic le in a
safe p lac e.
If steam is coming from the engine compartment
Turn the eng ine off and g et everyone away from the vehic le until it
c ools d own. If no steam is coming from the engine compartment
1. Keep the eng ine running at id ling sp eed .
2. Op en the hood to ventilate the eng ine c omp artment .
Confirm that the c ooling fan is turning . If the fan is not turning , im-
med iately turn the eng ine off and c ontac t your auth orized d ealer for
rep air.
3. After the eng ine c oolant temp erature has d rop p ed , turn off the en-
g ine.
If the temp erature g aug e stays at the overheated zo ne, turn the en-
g ine off.
4. After the eng ine has fully c ooled d own, c hec k the c oolant level in
the reserve tank.
If the c oolant level is b elow the “MIN ” mark, ad d c oolant up to the
“ MAX ” mark.
5. If there is no c oolant in the reserve tank, ad d c oolant to the reserve
tank. Then remove the rad iator c ap and fill the rad iator with c oolant.
If you remove the rad iator c ap from a hot rad iator, first wrap a thic k
c loth around the rad iator c ap , then turn the c ap c o unterc loc kwise
slowly without p ressing d own until it stop s. Releas e the p ressure from

9-24CAUTION
If transmission failure occurs, transport your vehicle on a flat-
bed truck. For vehicles with automatic transmission, the traveling speed
must be limited to less than 20 mph (30 km/h) and the traveling
distance to less than 31 miles (50 km). For greater speeds and
distances, transport your vehicle on a flat-bed truck.
HB8010AA
1. Chec k the transmission and d ifferential oil level s and ad d oil to
b ring it to the up p er level if nec essary.
2. Release the p arking b rake and p ut the transmissio n in neutral.
3. The ig nition switc h should b e in the “ACC ” p osition while the ve-
hic le is b eing towed .
4. Take up slac k in the towline slowly to p revent d a mag e to the ve-
hic le.

Maintenance and service11-7
–
CONTINUED –
Engine compartment overview
2.5 liter models
HBB036BB
1 Manual transmission oil level
g aug e (MT) (p ag e 11-23) or
Differential g ear oil level g aug e
(AT) (p ag e 11-26)
2 Air c leaner element
(p ag e 11-18)
3 Clutc h fluid reservoir
(p ag e 11-32)
4 Automatic transmission fluid
level g aug e (p ag e 11-24)
5 Brake fluid reservoir
(p ag e 11-30)
6 Fuel filter 7
Wind shield washer tank
(p ag e 11-42)
8 Fuse b ox (p ag e 11-46)
9 Battery (p ag e 11-45)
Q Eng ine oil filler c ap
(p ag e 11-9)
W Eng ine c oolant reservoir
(p ag e 11-15)
E Rad iator c ap (p ag e 11-15)
R Eng ine oil level g aug e
(p ag e 11-9)
T Power steering fluid reservoir
(p ag e 11-29)

11-8
3.0 liter models
HBB058BB
1 Air c leaner element
(p ag e 11-18)
2 Differential g ear oil level g aug e
(AT) (p ag e 11-26)
3 Automatic transmission fluid
level g aug e (p ag e 11-24)
4 Brake fluid reservoir
(p ag e 11-30)
5 Fuel filter
6 Wind shield washer tank
(p ag e 11-42) 7
Fuse b ox (p ag e 11-46)
8 Battery (p ag e 11-45)
9 Eng ine c oolant reservoir
(p ag e 11-15)
Q Eng ine oil filler c ap
(p ag e 11-9)
W Eng ine oil level g aug e
(p ag e 11-9)
E Rad iator c ap (p ag e 11-15)
R Power steering fluid reservoir
(p ag e 11-29)

Maintenance and service11-9
–
CONTINUED –
Engine oil
Checking the oil level
Chec k the eng ine oil level at eac h fuel stop .
HSB008BB
HBB004BA
1. Park the vehic le on a level surfac e and stop the eng ine.
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Be sure the d ip stic k is c orrec tly inserted until it stop s with the
g rap hic symb ol
on its top ap p earing as shown in the illustra-
tion.
4. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil to b ring the level up to t he up p er level.
CAUTION
Use only engine oil with the recommended grade and viscosity.
If you c hec k the oil level just after stop p ing the eng ine, wait a few min-
utes for the oil to d rain b ac k into the oil p an b ef ore c hec king the level.
Just after d riving or while the eng ine is warm, the eng ine oil level
read ing may b e in a rang e b etween the up p er level a nd the notc h
mark. This is c aused b y thermal exp ansion of the en g ine oil.
To p revent overfilling the eng ine oil, d o not ad d a ny ad d itional oil
ab ove the up p er level when the eng ine is c old .

11-10
Changing the oil and oil filter
Chang e the oil and oil filter ac c ord ing to the main tenanc e sc hed ule in
the “Warranty and Maintenanc e Booklet ”.
The eng ine oil and oil filter must b e c hang ed more freq uently than
listed in the maintenanc e sc hed ule when d riving on d usty road s,
when short trip s are freq uently mad e, or when d rivi ng in extremely
c old whether.
1. Warm up the eng ine b y letting the eng ine id le for ab out 10 minutes
to ease d raining the eng ine oil.
2. Park the vehic le on a level surfac e and stop the eng ine.
3. Remove the oil filler c ap .
HBB005BB
4. Drain out the eng ine oil b y removing the d rain p l ug while the en-
g ine is still warm. The used oil should b e d rained into an ap p rop riate
c ontainer and d isp osed of p rop erly.
WARNING
Be careful not to burn yourself with hot engine oil.
5. Wip e the seating surfac e of the d rain p lug with a c lean c loth and
tig hten it sec urely with a new sealing washer after the oil has c om-
p letely d rained out.

11-1212. Reinstall the c over und er the oil filter.
13. Pour the sp ec ified amount of eng ine oil throug h
the filler nec k.
Oil c ap ac ity: 2.5 liter mod els: 4.2 US q t (4.0 liters, 3.5 Imp q t )
3.0 liter mod els: 6.0 US q t (5.7 liters, 5.0 Imp q t )
14. Start the eng ine and make sure that no oil leak s ap p ear around
the filter ’s rub b er seal.
15. Run the eng ine until it reac hes the normal op er ating temp erature.
Then stop the eng ine and wait a few minutes to allo w the oil d rain
b ac k. Chec k the oil level ag ain and if nec essary, a d d more eng ine oil.
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new API certification mark (Starburst mark) dis-
played on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities