radio SUBARU LEGACY 2002 3.G Owner's Guide

Audio5-53
–
CONTINUED –
nFADER control
The balance control adjusts the volume balance between the front
and rear speakers.
The balance is adjusted by turning the knob from left to right in thiscondition.
Turn clockwise to increase the relative sound volume in the front of thevehicle.
Turn counterclockwise to increase the relative sound volume in the
rear of the vehicle. n BALANCE control
The balance control adjusts the volume balance between the left and
right speakers. Pull the knob out until it stops. The balance is adjusted
by turning the knob from left to right in this condition.
Turn clockwise to make the sound louder on the right of the vehicle.
Turn counterclockwise to make the sound louder on the left of the ve-hicle. n Display illumination dimness cancellation (BRIGHT)
The brightness of the radio display dims when the light switch is in the “ p ” or “w ” positions. If this makes the display difficult to read,
press the POWER ON/OFF button for more than two seconds to returnthe display to original brightness.
Subsequently pressing the POWER ON/OFF button again for more
than two seconds or if you can safely do so, turning the light switch tothe OFF position and back to the “p ” or “w ” position makes the
radio display dim again. FM/AM selection button
Press the FM/AM selector button to choose either FM or AM broad-
casts. The display will show FM or AM accordingly.Use the tuning dial to select the station to which you wish to listen. Manual tuning
Turn the tuning dial ’s outer tuner to increase or decrease the reception
frequency in individual steps.
FM band: 0.2 MHz steps AM band: 10 kHz steps

5-54
Seek tuning (SEEK)
If the Tuning dial ’s outer tuner is turned for longer than half of a se-
cond, the radio will begin to automatically search for receivable fre-
quencies and will stop at the first one found. This function may not be
available, however, when radio signals are weak. In such a situation,
perform manual tuning to select the desired station. Scan tuning (SCAN)
Turn the tuning dial inner tuner to change the radio to the SCAN
mode. In this mode, the radio scans through the radio band until astation is found. The radio will stop at the station for five seconds
while displaying the frequency, after which scanning will continue until
the entire band has been scanned.
Turn the tuning dial ’s inner tuner again to cancel the SCAN mode and
to stop on any displayed frequency.
Scan tuning may not function properly if the station reception is weak-
ened by distance from the station or proximity to tall buildings andhills. Preset tuning
Press any one of the preset buttons to select the corresponding, pre-
viously-registered radio station. The LED at the top of that button will
turn on. n Manual preset
Use the tuning dial to select the radio station which you wish to
register. Choose the preset button to which you wish to assign that station
and press it continuously for a period of more than 2 seconds. When
the radio station has been successfully registered, the display will
flash the corresponding radio frequency on and off once. NOTE Each preset button can be used to store both an FM station
and an AM station. If the power supply is interrupted by disconnection of the bat-
tery, memory presets will be cleared and will be required to be re-input.

Audio5-55
–
CONTINUED –
Weather band button (WB)
Push the “WB” button when the radio is off to turn on the radio in the
weather band.
Press the “WB” button when the radio is on to select the weather
band.
Cassette player operation
HB5053DB
9 Cassette slot
Q Eject button
W TAPE (cassette player selection) button
E Repeat button R
Fast forward button
T Play button
Y Rewind button
U Program switching button
I Dolby B NR button
If a cassette is inserted into the cassette slot while the ignition switch is
in the ACC or the ON position, that tape will start to play automatically.
Press the TAPE button when you want to play a cassette that has pre-
viously been inserted.

5-58
If a disc is inserted during a radio broadcast, the disc will
interrupt the broadcast. After the last song finishes, the disc will automatically return
to track 1 (the first song on the disc) and will automatically playback. n When CD is in the player
When the “DISC” button is pressed, the player will start playback.
To select a song from its beginning
HBS044CA
nForward direction
Turn the “FFFB” dial clockwise and release it immediately to skip to
the beginning of the next track. Each time the knob is turned and
released, the indicated track number will increase. n Backward direction
Turn the “FFFB” dial counterclockwise and release it immediately to
skip to the beginning of the current track. If you continue to turn and
release the knob, the indicated a number will decrease.

Audio5-67
–
CONTINUED –
To remove all discs at one time
1. Press and hold the “Eject” button 4 until all “Disc” indicators begin
blinking (about 1.5 seconds), and the first disc will be ejected.
2. When the disc is removed, the next one will be ejected, and so on. To replace a playing disc with another
Simply press the desired one of “Disc select ” buttons
3 (numbered
from 1 to 6) or press the “DISC UP ” or “DISC DOWN ” button on the
radio unit to select the desired disc, and the disc will begin to play. Disc indicators
Lit: when the corresponding storage tray is occupied by a disc. Blinking: Disc player is either in loading, eject or changing mode.OFF: No disc is loaded or the ignition switch is in the “LOCK” position.
Function control
Refer to CD player control operating instructions described in the“ Type A and B audio sets ” or “Type C audio set ” section.

8-8
and otherwise similar to on-road driving conditions. Operating it under other than those conditions could subject the vehicle to excessive
stress which might result in damage not eligible for repair under war-
ranty. If you do take your SUBARU off road, you should review the
common sense precautions in the next section (applicable to the
OUTBACK) for general guidance. But please keep in mind that your
vehicle’s off-road capabilities are more limited than those of the OUT-
BACK.
Never attempt to drive through pools and puddles, or roads flooded
with water. Water entering the engine air intake or the exhaust pipe or
water splashing onto electrical parts may damage your vehicle andmay cause it to stall. OUTBACK
Because of the AWD feature and higher ground clearance, your
Subaru can be driven on ordinary roads or off-road. But please keep
in mind that an AWD Subaru is a passenger car and is neither a con-
ventional off-road vehicle nor an all-terrain vehicle. If you do take your
Subaru off-road, certain common sense precautions such as the fol-lowing should be taken: Make certain that you and all of your passengers are wearing seat
belts. Carry some emergency equipment, such as a towing rope or
chain, a shovel, wheel blocks, first aid kit and portable phone or citi-zens band radio. Drive carefully. Do not take unnecessary risks by driving in danger-
ous areas or over rough terrain. Slow down and employ extra caution at all times. When driving off-
road, you will not have the benefit of marked traffic lanes, banked
curves, traffic signs and the like. Do not drive across steep slopes. Instead, drive either straight up
or straight down the slopes. A vehicle can much more easily tip over
sideways than it can end over end. Avoid driving straight up or down
slopes that are too steep. Avoid sharp turning maneuvers, especially at higher speeds.
Do not grip the inside or spokes of the steering wheel. A bad

Specifications12-7
–
CONTINUED –
Fuse panel Circuit Fuse rating
615ASRS airbag
715AFront fog light
830AABS solenoid
915ARadio
Clock
1015ATrailer
1115AEngine ignition system
SRS airbag
1210AIllumination brightness control
1315AFuel pump
1410ARear window wiper and washer
1530AWindshield wiper and washer
1620ABrake light
1715AAir conditioner
1815ABackup light
Cruise control
ABS control
1920AMirror heater
Wiper deicer
2020AAccessory power socket
Seat heater

Specifications12-9
–
CONTINUED –
Fuse panel Circuit Fuse rating
830AABS (VDC) solenoid
915ARadio
Clock
1015ATrailer
1115AEngine ignition system
SRS airbag
1210AIllumination brightness control
1315AFuel pump
1410ARear window wiper and washer
1530AWindshield wiper and washer
1620ABrake light
1715AAir conditioner
1815ABackup light
Cruise control
ABS (VDC) control
1920AMirror heater
Wiper deicer
2020AMcIntosh audio amp (if equipped)
2120AAccessory power socket
Seat heater

Specifications12-15
–
CONTINUED –
Vehicle identification
HBD002BB
1 Emission control label
2 Vehicle identification number
3 Radio noise label (Canada model)
4 Vacuum hose connectionslabel 5
Tire inflation pressure label
6 Certification and bar cordlabel
7 Vehicle identification numberplate
8 Model number plate