hood release SUBARU LEGACY 2004 4.G Owners Manual

12
Illustrated index „Exterior
123 4 5 6
7
89
10
11
12
13
UBF003BB
1) Hood lock release (page 11-5)
2) Headlight switch (page 3-19)
3) Bulb replacement (page 11-65)
4) Wiper switch (page 3-26)
5) Moonroof (page 2-32)
6) Roof rail (page 8-20)
7) Door locks (page 2-3)
8) Tire pressure (page 11-44)
9) Flat tires (page 9-5)
10) Tire chains (page 8-15)
11) Fog light switch (page 3-24)
12) Tie-down hooks (page 9-21)
13) Towing hook (page 9-21)

18
„
Instrument panel
12 3 4 5 67
8
9
10
11
12
13
14
15
16
17
UBF021BB
1) Door locks (page 2-3)
2) Outside mirror (page 3-33)
3) Light control lever (page 3-19)
4) Combination meter (page 3-7)
5) Wiper control lever (page 3-24)
6) Hazard warning flasher switch
(page 3-6)
7) Climate c o ntr ol (p age 4 -1 )
8) Gear shift lever (MT) (page 7- 12)/Selector lever (AT) (page 7-
15)
9) Au dio (pa ge 5-1 )
10) Cruise control (page 7-42)
11) Horn (page 3-36)
12) SRS airbag (page 1-57)
13) Tilt steering (page 3-35)
14) Fuse box (page 11-59)
15) Hood lock release (page 11-5)
16) Power door locking switch (page
2-5)
17) Power window (page 2-23)

9-19
In case of emergency
– CONTINUED –
5. Start the engine of the vehicle with the booster bat-
tery and run it at moderate speed. Then start the en-
gine of the vehicle that has the discharged battery.
6. When finished, carefully disconnect the cables in
exactly the reverse order.Engine overheating
Never attempt to remove the radiator cap until
the engine has been shut off and has fully
cooled down. When the engine is hot, the cool-
ant is under pressure. Removing the cap while
the engine is still hot could release a spray of
boiling hot coolant, which could burn you very
seriously.
If the engine overheats, safely pull off the road and
stop the vehicle in a safe place. „ If steam is coming from the engine
compartment
Turn the engine off and get everyone away from the
vehicle until it cools down. „ If no steam is coming from the engine
compartment
1. Keep the engine running at idling speed.
2. Open the hood to ventilate the engine compart- ment.

11 - 5
2Maintenance and service
– CONTINUED –
even when the engine is stopped.
„ When you do checking or servicing in
the engine compartment while the en-
gine is running
A running engine can be dangerous. Keep your
fingers, hands, clothing, hair and tools away
from the cooling fan, belts and any other mov-
ing engine parts. Removing rings, watches and
ties is advisable.
Engine hood
To open the hood:
1. If the wiper blades are lifted off the windshield, re-
turn them to their original positions.
2. Pull the hood release knob under the instrument
panel.
UBB001BA

11 - 6
2Maintenance and service
3. Release the secondary hood release located under
the front grille by moving the lever toward the left.
4. Lift up the hood, release the hood prop from its re-
tainer and put the end of the hood prop into the slot in
the hood.
To close the hood:
1. Lift the hood slightly and remove the hood prop
from the slot in the hood and return the prop to its re-
tainer.
2. Lower the hood until it approaches about 6 in (15
cm) from the closed position and let it drop.
3. After closing the hood, be sure the hood is securely
locked.
If this does not close the hood, release it from a slightly
higher position. Do not push the hood forcibly to close
UBB002BAUBB003BA