flasher SUBARU LEGACY 2005 4.G User Guide

8-14
Driving tips
ing, abrupt acceleration, high-speed driving, and
sharp turning when driving on snowy or icy roads.
Always maintain ample distance between your vehicle
and the vehicle ahead of you to avoid the need for sud-
den braking.
To supplement the foot brake, use the engine brake
effectively to control the vehicle speed. (Shift into a
lower gear when necessary.)
Avoid shifting down abruptly. Such behavior can
cause the wheels to lock, possibly leading to loss of
vehicle control.
An anti-lock brake system (ABS) enhances your vehi-
cle’s braking performance on snowy and icy roads.
Refer to the “ABS (Anti-lock Brake System)” and “Ve-
hicle Dynamics Control system (if equipped)” section
in chapter 7 for information on braking on slippery sur- faces. !
Wiper operation when snowing
Before driving in cold weather, make sure the wiper
blades are not frozen to the windshield or rear window.
If the wiper blades are frozen to the windshield or rear
window, use the defroster with the airflow control but-
ton/dial in the “ ” position and the temperature
control dial set for maximum warmth until the wiper
blades are completely thawed out. If your vehicle is
equipped with a wiper deicer, it is helpful to thaw the windshield wiper blades. To thaw out the rear wiper
blade, use the rear window defogger.
When driving in snow, if frozen snow starts to stick on
the surface of the windshield despite wiper operation,
use the defroster with the airflow control button/dial in
“ ” and the temperature control dial set for maxi-
mum warmth. After the windshield gets warmed
enough to melt the frozen snow on it, wash it away us-
ing the windshield washer.
Snow stuck on the wiper arm prevents the wiper from
working effectively. If snow is stuck on the wiper arm,
pull off the road to a safe place, then remove it. If you
stop the vehicle at road side, use the hazard warning
flasher to alert other drivers.
We recommend use of non-freezing type wiper blades
(winter blades) during the seasons you could have
snow and sub-zero temperatures. Blades of this type
give superior wiping performance in snowy conditions.
Be sure to use blades that are suitable for your vehi- cle. !
Corrosion protection
Refer to the “Corrosion protection” section (chapter
10).

9-2
In case of emergency
In case of emergencyIf you park your vehicle in an emer-
gency
The hazard warning flasher should be used in day or
night to warn other drivers when you have to park your
vehicle under emergency conditions.
Avoid stopping on the road. It is best to safely pull off
the road if a problem occurs.
The hazard warning flasher can be activated regard-
less of the ignition switch position.
Turn on the hazard warning by pushing the hazard
warning flasher switch. Turn it off by pushing the
switch again.
NOTE
When the hazard warning flasher is on, the turn
signals do not work.
UB9500BA

9-5
In case of emergency
– CONTINUED –
Flat tires
If you have a flat tire while driving, never brake sud-
denly; keep driving straight ahead while gradually re-
ducing speed. Then slowly pull off the road to a safe
place. !Changing a flat tire
"Do not jack up the vehicle on an incline or a
loose road surface. The jack can come out of
the jacking point or sink into the ground and
this can result in a severe accident." Use only the jack provided with your vehicle.
The jack supplied with the vehicle is designed
only for changing a tire. Never get under the ve-
hicle while supporting the vehicle with this jack. " Always turn the engine off before raising the
flat tire off the ground using the jack. Never
swing or push the vehicle supported with the
jack. The jack can come out of the jacking point
due to a jolt and this can result in a severe acci-
dent. 1. Park on a hard, level surface, whenever possible,
then stop the engine.
2. Set the parking brake securely and shift a manual
transmission vehicle in reverse or an automatic trans-
mission vehicle in the “P” (Park) position.
3. Turn on the hazard warning flasher and have ev-
eryone get out of the vehicle.
4. Put wheel blocks at the front and rear of the tire di-
agonally opposite the flat tire.
HS9003BA

12-9
Specifications
– CONTINUED –
Fuse panelFuse ratingCircuit
130"ABS unit
" Vehicle dynamics con- trol unit
225"Main fan
325"Sub fan (Except 3.0-li- ter models)
425"Main fan (3.0-liter mod- els)
520
615"Headlight (right side)
715"Headlight (left side)
820"Backup light
915"Horn
1025"Rear window defogger
1115"Fuel pump
1215"Automatic transmis- sion control unit
137.5"Engine control unit
1415"Turn and hazard warn-
ing flasher
1520"Parking switch
167.5"Alternator
Fuse panelFuse ratingCircuit

14-5
Index
Fog light ...................................................... 11-76
Seatbelt pretensioners .................................. 1-33
Seats .............................................................. 1-2
Fuel ..................................................................... 7-2
Economy hints ................................................ 8-2
Filler lid and cap ............................................. 7-4
Gauge ........................................................... 3-11
Requirements ................................................. 7-2
Fuses ............................................................... 11-68
Fuses and circuits ............................................. 12-6 G
GAWR (Gross Axle Weight Rating) ................... 8-20
Glove box ............................................................ 6-7
GVWR (Gross Vehicle Weight Rating) .............. 8-20 H
Hazard warning flasher ....................................... 3-7
Head restraint adjustment (Front) ........................ 1-8
Headlight Flasher .......................................................... 3-46
Indicator light ................................................ 3-35
Headlights .............................................. 3-45, 11-74
Heater operation .................................................. 4-7
High beam indicator light ................................... 3-35
High mount stop light ....................................... 11-86
Horn ................................................................... 3-64 Hose and connections ..................................... 11-19 I
Ignition switch ...................................................... 3-3
Light ................................................................ 3-6
Illuminated entry ................................................ 2-15
Illumination brightness control ........................... 3-47
Immobilizer system .............................................. 2-4 Indicator light ................................................ 3-33
Indicator light Cruise control ............................................... 3-35
Cruise control set .......................................... 3-35
Front fog ....................................................... 3-35
Headlight ...................................................... 3-35
High beam .................................................... 3-35
Selector lever position .................................. 3-34
Turn signal .................................................... 3-34
Information display ............................................ 3-37
Inside mirror ...................................................... 3-59
Interior light .......................................................... 6-2
Internal trunk lid release handle ........................ 2-37 J
Jack ................................................................... 9-33
Jack handle ....................................................... 9-34
Jump starting ..................................................... 9-17