battery SUBARU LEGACY 2005 4.G Owners Manual
[x] Cancel search | Manufacturer: SUBARU, Model Year: 2005, Model line: LEGACY, Model: SUBARU LEGACY 2005 4.GPages: 627, PDF Size: 6.42 MB
Page 30 of 627
27
–
CONTINUED –
Windshield wiper deicer (if
equipped) Windshield wiper deicer Operation for 15 min. / Continuous
operationOperation for15 min.3-56
Dome light Operation in interlock with remote keyless entry system OFF / Short / Normal / Long Normal 6-2
Battery drainage prevention
function Battery drainage prevention func-tion Operation / Non-operation Operation 2-9
Item Function Possible settings Default set-
tingPage
Page 41 of 627
1-10
Seat, seatbelt and SRS airbags
Seat heater (if equipped)
The seat heater operates when the ignition switch is
either in the “ACC” or “ON” position.
Each seat heater has four levels of adjustment. To use
the heater in the right hand seat, turn the “R” adjust-
ment knob forward until the “ ” mark reaches the
desired position. To activate the heater in the left hand
seat, turn the “L” adjustment knob forward until the
“ ” mark reaches the desired position. Each heater
warms the seat most quickly with the “ ” mark on
the adjustment knob in the furthest-forward position.
An indicator light on the adjustment knob for each seat
heater comes on when that seat heater is activated.
When the vehicle’s interior is warmed enough or be-
fore you leave the vehicle, be sure to turn the switch
off.
"
There is a possibility that people with delicate
skin may suffer slight burns even at low tem-
peratures if they use the seat heater for a long
period of time. When using the heater, always
be sure to warn the persons concerned. " Do not put anything on the seat which insu-
lates against heat, such as a blanket, cushion,
or similar items. This may cause the seat heater
to overheat.
NOTE " Use of the seat heater for a long period of time
while the engine is not running can cause battery
discharge." When cleaning the seat, do not use benzine,
paint thinner, or any similar materials.
UB1208BA
Page 64 of 627
1-33
Seat, seatbelt and SRS airbags
– CONTINUED –
!Seatbelt maintenance
To clean the seatbelts, use a mild soap and lukewarm
water. Never bleach or dye the belts because this
could seriously affect their strength.
Inspect the seatbelts and attachments including the
webbing and all hardware periodically for cracks, cuts,
gashes, tears, damage, loose bolts or worn areas. Re-
place the seatbelts even if only minor damage is
found.
" Keep the belts free of polishes, oils, chemi-
cals and particularly battery acid. " Never attempt to make modifications or
changes that will prevent the seatbelt from op-
erating properly.
Front seatbelt pretensioners
The driver’s and front passenger’s seatbelts have a
seatbelt pretensioner. The seatbelt pretensioners are
designed to be activated in the event of an accident in-
volving a moderate to severe frontal collision.
The pretensioner sensor also serves as a SRS frontal
airbag sensor. If the sensor detects a certain predeter-
mined amount of force during a frontal collision, the
front seatbelt is quickly drawn back in by the retractor
to take up the slack so that the belt more effectively re-
strains the front seat occupant.
When a seatbelt pretensioner is activated, an operat-
HS1067BA
Page 126 of 627
2-1
2
Keys and doors
Keys ............................................................... 2-2 Key number ....................................................... 2-3
Immobilizer (if equipped) ............................. 2-4 Security ID plate ................................................ 2-5
Security indicator light ..................................... 2-5
Key replacement ............................................... 2-6
Door locks ..................................................... 2-6 Locking and unlocking from the outside ........ 2-6
Locking and unlocking from the inside .......... 2-8
Battery drainage prevention function ............. 2-9
Power door locking switches ...................... 2-10 Key lock-in prevention function ...................... 2-11
Remote keyless entry system (if equipped) .............................................. 2-12Locking the doors ............................................. 2-13
Unlocking the doors ......................................... 2-14
Unlocking the trunk lid/rear gate ..................... 2-14
Illuminated entry ............................................... 2-15
Vehicle finder function ..................................... 2-15
Sounding a panic alarm ................................... 2-15
Selecting audible signal operation .................. 2-15
Replacing the battery ....................................... 2-16
Replacing lost transmitters .............................. 2-17
Alarm system ................................................ 2-23 System alarm operation ................................... 2-23
Activating and deactivating the alarm system ............................................................. 2-23
If you have accidentally triggered the alarm
system ............................................................. 2-24
Arming the system ............................................ 2-24
Disarming the system ....................................... 2-26 Valet mode ......................................................... 2-27
Passive arming ................................................. 2-27
Tripped sensor identification .......................... 2-29
Shock sensors (dealer option) ........................ 2-29
Child safety locks ......................................... 2-30
Windows ........................................................ 2-31 Power windows ................................................. 2-31
Trunk lid (Sedan) ........................................... 2-35 To open and close the trunk lid from outside ............................................................ 2-35
To open the trunk lid from inside .................... 2-36
To lock and unlock the trunk lid release lever ................................................................. 2-36
Internal trunk lid release handle ...................... 2-37
Rear gate (Station wagon) ............................ 2-39
Moonroof (if equipped) ................................. 2-41 Tilting/sliding moonroof (Sedan) .................... 2-42
Moonroof (Station wagon) ............................... 2-44
Page 134 of 627
2-9
Keys and doors
– CONTINUED –
To unlock the door from the inside, rotate the lock le- ver forward.
The red mark on the lock lever appears when the door
is unlocked.
Pull the inside door handle to open an unlocked door.
Always make sure that all doors and the rear gate
(Station wagon) are closed and locked before starting to drive. !Battery drainage prevention function
When a door or the rear gate is not completely closed
and the dome light, ignition switch light, and door open
warning light remain illuminated as a result, the lights are automatically turned off by the battery drainage
prevention function after 10 minutes of illumination to
prevent the battery from going dead. The operational/
non-operational setting of this function can be
changed by a SUBARU dealer. Contact the nearest
SUBARU dealer if you would like to change the set-
ting.
NOTE "
When leaving the vehicle, please make sure that
all doors and the rear gate are completely closed. " The battery drainage prevention function does
not operate while the key is in the ignition switch.
UB2505BA
Page 137 of 627
2-12
Keys and doors
Remote keyless entry system (if
equipped)
"
Do not expose the transmitter to severe
shocks, such as those experienced as a result
of dropping or throwing. " Do not take the transmitter apart except when
replacing the battery. " Do not get the transmitter wet. If it gets wet,
wipe it dry with a cloth immediately.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Oper-
ation is subject to the following two conditions: (1)
This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equipment.
Two transmitters are provided for your vehicle.
The keyless entry system has the following functions. "
Locking and unlocking the doors (and rear gate on
the Station wagon) without a key " Locking and unlocking the doors (and trunk lid on
the Sedan) without key" Unlocking the rear gate on the Station wagon with-
out key " Unlocking the trunk lid on the Sedan without key
" Sounding a panic alarm
" Arming and disarming the security system (if your
vehicle is equipped with an optional security system).
See the next section “Alarm system” for detailed infor-mation.
The operable distance of the keyless entry system is
approximately 30 feet (10 meters). However, this dis-
tance will vary depending on environmental condi- tions. The system’s operable distance will be shorter
in areas near a facility or electronic equipment emitting
strong radio waves such as a power plant, broadcast
station, TV tower, or remote controller of home elec-
tronic appliances.
The keyless entry system does not operate when the
key is inserted in the ignition switch.
Page 141 of 627
2-16
Keys and doors
sired, you may turn the audible signal off.
To turn the audible signal off, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound twice and the turn
signal lights will flash twice to inform you that the audi-
ble signal has been turned off.
To turn the audible signal on, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound once and the turn
signal lights will flash once to inform you that the audi-
ble signal has been turned on.
You may have the above settings done by your SUB-
ARU dealer. !
Replacing the battery
Do not let dust, oil or water get on or in the
transmitter when replacing the battery.
When the transmitter battery begins to get weak,
transmitter range will begin to decrease and the LED
will not illuminate. Replace the battery as soon as pos- sible.
To replace the battery:
1. Open the transmitter case using a flat-head screw-
driver.
UB2208BA
Page 142 of 627
2-17
Keys and doors
– CONTINUED –
2. Remove the old battery from the holder. A) Negative (–) side facing up
3. Replace with a new battery (Type CR2025 or
equivalent) making sure to install the new battery with
the negative (–) side facing up.
4. Refit the removed half of the transmitter case. After the battery is replaced, the transmitter must
be synchronized with the keyless entry system’s
control unit. Press either the “ ” or “ ” but- ton six times to synchronize the unit.
! Replacing lost transmitters
If you lose a transmitter or want to purchase additional
UB2209BA
A
UB2210BB
Page 151 of 627
2-26
Keys and doors
"
The alarm system is triggered when the ignition
switch is turned to the “ON” position during sur-
veillance. However, this does not occur if the vehi-
cle is equipped with an immobilizer and the key
used for turning the ignition switch has been reg-
istered. " If your vehicle is not equipped with an immobi-
lizer, the engine does not start even when the igni- tion switch is turned to the “START” position once
the alarm system has been triggered. ! Disarming the system
Briefly press the “ ” button (for less than two sec-
onds) on the remote transmitter. The driver’s door will
unlock, an electronic chirp will sound twice, the turn
signal lights will flash twice and the indicator light will
go off.
To unlock all other doors and the rear gate (Station
wagon), briefly press the “ ” button a second time.
NOTE
If the interval between the first and second press-
es of the “ ” button (for unlocking of all of the
doors and the rear gate) is extremely short, the
system may not respond.
Or the system can be disarmed by the following method, too. "
Insert the key in the door lock of the driver’s
door and turn it to the unlock position." Cycle the ignition switch from the “LOCK” to the
“ON” position three times within 5 seconds (only
vehicle without immobilizer). ! Emergency disarming
If you cannot disarm the system using the transmitter
(i.e. the transmitter is lost, broken or the transmitter
battery is too weak), you can disarm the system with-
out using the transmitter.
Vehicle with immobilizer
The system can be disarmed if you turn the ignition
switch from the “LOCK” to the “ON” position with a reg-
istered key.
Vehicle without immobilizer
1. Unlock the door with the key and then open the
door.
2. Insert the key into the ignition switch and cycle it
from the “LOCK” to the “ON” position three times with-
in 5 seconds .
All models
Insert the key in the door lock of the driver’s door and
turn it to the unlock position.
Page 165 of 627
2-40
Keys and doors
To close the rear gate, lower it slowly and push down
firmly until the latch engages.
The rear gate can be lowered easily if you pull it down
holding the recessed grip.
"
To prevent dangerous exhaust gas from en-
tering the vehicle, always keep the rear gate
closed while driving. " Do not attempt to shut the rear gate while
holding the recessed grip. Also avoid closing
the rear gate by pulling on the recessed grip
from inside the cargo space. There is a danger
of your hand being caught and injured.
" Do not jam a plastic bag in or place cello-
phane tape on the rear gate stays or scratch the
stays while loading or unloading cargo. That
could cause leakage of gas from the stays,
which may result in their inability to hold the
rear gate open. " Be careful not to hit your head or face on the
rear gate when opening or closing the rear gate
and when loading or unloading cargo.
NOTE
Should the rear gate be unable to be unlocked due
to discharged battery, a fault in the door locking/
unlocking system or other causes, you can unlock
it by manually operating the rear gate lock releaselever.
For the procedure, refer to “Rear gate – if the rear
gate cannot be unlocked” in chapter 9.
UB2500BA