seat adjustment SUBARU LEGACY 2005 4.G Owners Manual
[x] Cancel search | Manufacturer: SUBARU, Model Year: 2005, Model line: LEGACY, Model: SUBARU LEGACY 2005 4.GPages: 627, PDF Size: 6.42 MB
Page 32 of 627
1-1
1
Seat, seatbelt and SRS airbags
Front seats .................................................... 1-2 Manual seat ....................................................... 1-3
Power seat (if equipped) .................................. 1-5
Reclining the seatback ..................................... 1-6
Head restraint adjustment ................................ 1-8
Active head restraint ........................................ 1-8
Lumbar support (if equipped) .......................... 1-9
Seat heater (if equipped) .............................. 1-10
Rear seats ..................................................... 1-11 Folding down the rear seat – Station wagon .. 1-12
Head restraint adjustment ................................ 1-12
Armrest (if equipped) ................................... 1-14 Loading long objects (Sedan) .......................... 1-15
Seatbelts ....................................................... 1-16 Seatbelt safety tips ........................................... 1-16
Emergency Locking Retractor (ELR) .............. 1-18
Automatic/Emergency Locking Retractor (A/ELR) ............................................................ 1-18
Seatbelt warning light and chime .................... 1-19
Fastening the seatbelt ...................................... 1-21
Seatbelt maintenance ....................................... 1-33
Front seatbelt pretensioners ....................... 1-33 System monitors ............................................... 1-35
System servicing .............................................. 1-36
Precautions against vehicle modification ...... 1-37
Child restraint systems ................................ 1-38 Where to place a child restraint system ......... 1-40
Choosing a child restraint system .................. 1-41
Installing child restraint systems with A/ELR seatbelt ............................................................ 1-42 Installing a booster seat ................................... 1-47
Installation of child restraint systems by use
of lower and tether anchorages (LATCH) .... 1-49
Top tether anchorages ..................................... 1-55
*SRS airbag (Supplemental Restraint System airbag) ........................................... 1-59Vehicle with SRS airbags and lap/shoulder restraints for driver, front passenger, and
window-side rear passengers ....................... 1-59
Subaru advanced frontal airbag system ........ 1-65
SRS side airbag and SRS curtain airbag ........ 1-80
SRS airbag system monitors ........................... 1-89
SRS airbag system servicing .......................... 1-91
Precautions against vehicle modification ...... 1-92
Page 34 of 627
1-3
Seat, seatbelt and SRS airbags
– CONTINUED –
restrained or improperly restrained. Because
children are lighter and weaker than adults,
their risk of being injured from deployment is
greater. For that reason, we strongly recom-
mend that ALL children (including those in
child seats and those that have outgrown child
restraint devices) sit in the REAR seat properly
restrained at all times in a child restraint device
or in a seatbelt, whichever is appropriate for the
child’s age, height and weight.
Secure ALL types of child restraint devices (in-
cluding forward facing child seat) in the REAR
seats at all times.
NEVER INSTALL A REARWARD FACING CHILDSEAT IN THE FRONT SEAT. DOING SO RISKS
SERIOUS INJURY OR DEATH TO THE CHILD
BY PLACING THE CHILD’S HEAD TOO CLOSE
TO THE SRS AIRBAG.
According to accident statistics, children are
safer when properly restrained in the rear seat-
ing positions than in the front seating posi-
tions. For instructions and precautions con-
cerning child restraint systems, see the “Child
restraint systems” section in this chapter. !
Manual seat
! Fore and aft adjustment
Pull the lever upward and slide the seat to the desired
position. Then release the lever and move the seat
back and forth to make sure that it is securely locked
into place.
UB1500BA
Page 36 of 627
1-5
Seat, seatbelt and SRS airbags
– CONTINUED –
!Seat cushion height adjustment (driver’s seat)
The height of the seat can be adjusted by moving the
seat cushion adjustment lever up and down.
When the lever is pushed down, the seat is lowered.
When the lever is pulled up, the seat rises. !
Power seat (if equipped)
! Fore and aft adjustment
To adjust the seat forward or backward, move the con-
trol switch forward or backward.
NOTE
During backward-forward adjustment of the seat,
you cannot adjust the seat cushion angle or seat
height.
UB1502BA
UB1541BA
Page 38 of 627
1-7
Seat, seatbelt and SRS airbags
– CONTINUED –
!Seat cushion angle adjustment (Driver’s seat
only)
To adjust the seat cushion angle, pull up or push down
the front end of the control switch. !
Seat height adjustment (Driver’s seat only)
To adjust the seat height, pull up or push down the
rear end of the control switch.
UB1540BAUB1519BA
Page 39 of 627
1-8
Seat, seatbelt and SRS airbags
!
Head restraint adjustment
To raise the head restraint, pull it up. To lower it, push
the head restraint down while pressing the release
button on the top of the seatback.
The head restraint should be adjusted so that the cen-
ter of the head restraint is closest to the top of the oc-
cupant’s ears.
Never drive the vehicle with the head restraints
removed because they are designed to reduce
the risk of serious neck injury in the event that
the vehicle is struck from the rear.
! Active head restraint
The front seats of your vehicle are equipped with ac-
tive head restraints. They automatically tilt forward
slightly in the event the vehicle is struck from the rear,
decreasing the amount of rearward head movement
and thus reducing the risk of whiplash. For maximum
effectiveness the head restraint should be adjusted so
that the center of the head restraint is closest to the top
of the occupant’s ears.
UB1521BA
HS1105BA
Page 41 of 627
1-10
Seat, seatbelt and SRS airbags
Seat heater (if equipped)
The seat heater operates when the ignition switch is
either in the “ACC” or “ON” position.
Each seat heater has four levels of adjustment. To use
the heater in the right hand seat, turn the “R” adjust-
ment knob forward until the “ ” mark reaches the
desired position. To activate the heater in the left hand
seat, turn the “L” adjustment knob forward until the
“ ” mark reaches the desired position. Each heater
warms the seat most quickly with the “ ” mark on
the adjustment knob in the furthest-forward position.
An indicator light on the adjustment knob for each seat
heater comes on when that seat heater is activated.
When the vehicle’s interior is warmed enough or be-
fore you leave the vehicle, be sure to turn the switch
off.
"
There is a possibility that people with delicate
skin may suffer slight burns even at low tem-
peratures if they use the seat heater for a long
period of time. When using the heater, always
be sure to warn the persons concerned. " Do not put anything on the seat which insu-
lates against heat, such as a blanket, cushion,
or similar items. This may cause the seat heater
to overheat.
NOTE " Use of the seat heater for a long period of time
while the engine is not running can cause battery
discharge." When cleaning the seat, do not use benzine,
paint thinner, or any similar materials.
UB1208BA
Page 43 of 627
1-12
Seat, seatbelt and SRS airbags
!
Folding down the rear seat – Station wagon
"After returning the rear seat to its original po-
sition, be certain to place all of the seatbelts
and the tab attached to the seat cushion above
the seat cushion. And make certain that the
shoulder belts are fully visible. " Never allow passengers to ride on the folded
rear seatback or in the cargo area. Doing so
may result in serious injury or death. " Secure skis and other lengthy items properly
to prevent them from being thrown around in-
side the vehicle and causing serious injury dur-
ing a sudden stop, a sudden steering maneuver
or a rapid acceleration. Unlock the seatback by pushing the release button
and then fold the seatback down.
To return the seatback to its original position, raise the
seatback until it locks into place and make sure that it
is securely locked. !
Head restraint adjustment
Never drive the vehicle with the head restraints
removed because they are designed to reduce
the risk of serious neck injury in the event that
UB1534CA
Page 99 of 627
1-68
Seat, seatbelt and SRS airbags
Do not attach accessories to the windshield, or
fit an extra-wide mirror over the rear view mir-
ror. If the SRS airbag deploys, those objects
could become projectiles that could seriously
injure vehicle occupants.
! Driver’s SRS frontal airbag
The driver’s SRS frontal airbag uses a dual stage in-
flator. The inflator operates in different ways depend-
ing on the severity of impact, backward-forward ad-
justment of the driver’s seat position and whether or not he/she is wearing the seatbelt.
The backward-forward adjustment of the driver’s seat
position is monitored by the driver’s seat position sen-
sor under the driver’s seat.
Whether or not the driver is wearing the seatbelt is
monitored by the seatbelt buckle switch.
Observe the following precautions. Failure to do so
may cause the seatbelt buckle switch and/or the seat
position sensor to malfunction, preventing the Subaru
advanced frontal airbag system from functioning cor-
rectly or causing the system to fail."
Do not place articles/metal objects or install any ac-
cessory other than a genuine SUBARU accessory un-
der the driver’s seat. Do not allow the rear seat occu-
pant to kick the driver’s seat or push up its bottom sur-
face with his/her feet. " Do not place a magnet near the seatbelt buckle or
under the driver’s seat.
If the seatbelt buckle switch and/or the driver’s seat
position sensor have failed, the SRS airbag system
warning light will illuminate. Although the driver’s SRS
frontal airbag can deploy regardless of the backward-
forward adjustment of the driver’s seat position even
when the warning light is on, have the system inspect-
ed by your SUBARU dealer immediately if the SRS
airbag system warning light comes on.
UB1586BA
Page 106 of 627
1-75
Seat, seatbelt and SRS airbags
– CONTINUED –
!Operation
A) Driver’s side
B) Passenger’s side
The SRS airbag can function only when the ignition switch is in the “ON” position.
The Subaru advanced frontal airbag system is de-
signed to determine activation or deactivation condi-
tion of the front passenger’s SRS frontal airbag de-
pending on the total load on the front passenger’s seat
monitored by the front passenger’s occupant detection
system weight sensor. For this reason, only the driv-
er’s SRS frontal airbag may deploy in the event of a
collision, but this does not mean failure of the system.
If the front sub sensors inside both front fenders and
the impact sensors in the airbag control module detect
a predetermined amount of force during a frontal colli-
sion, the control module sends signals to the airbag
module(s) (only driver’s module or both driver’s and
front passenger’s modules) instructing the module(s)
to inflate the SRS frontal airbag(s). The driver’s and
front passenger’s SRS frontal airbags use dual stage
inflators. The two inflators of each airbag are triggered
either sequentially or simultaneously, depending on
the severity of impact, backward-forward adjustment
of the driver’s seat position and fastening/unfastening
of the seatbelt in the case of the driver’s SRS frontal
airbag and depending on the severity of impact and
the total load on the seat in the case of the front pas-
senger’s SRS frontal airbag. After the deployment, the
SRS airbag immediately start to deflate so that the
driver’s vision is not obstructed. The time required
A
B
UB1575BB
Page 365 of 627
7-10
Starting and operating
Preparing to drive
You should perform the following checks and adjust-
ments every day before you start driving.
1. Check that all windows, mirrors, and lights are
clean and unobstructed.
2. Check the appearance and condition of the tires.
Also check tires for proper inflation.
3. Look under the vehicle for any sign of leaks.
4. Check that the hood, trunk and rear gate are fullyclosed.
5. Check the adjustment of the seat.
6. Check the adjustment of the inside and outside mir-rors.
7. Fasten your seatbelt. Check that your passengers
have fastened their seatbelts.
8. Check the operation of the warning and indicator
lights when the ignition switch is turned to the “ON” po- sition.
9. Check the gauges, indicator and warning lights af-
ter starting the engine.
NOTE
Engine oil, engine coolant, brake fluid, washer flu-
id and other fluid levels should be checked daily,
weekly or at fuel stops.
Starting the engine
Do not operate the starter motor continuously
for more than ten seconds. If the engine fails to
start after operating the starter for five to ten
seconds, wait for ten seconds or more before
trying again.
! Manual transmission vehicle
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Press the clutch pedal to the floor and shift the shift
lever into neutral.
Hold the clutch pedal to the floor while starting the en-
gine. The starter motor will only operate when the
clutch pedal is pressed fully to the floor.
4. Turn the ignition switch to the “ON” position and
check the operation of the warning and indicator lights.
Refer to the “Warning and indicator lights” section
(chapter 3).
5. Turn the ignition switch to the “START” position
without depressing the accelerator pedal. Release
the key immediately after the engine has started.