tow SUBARU OUTBACK 2001 3.G User Guide

Instruments and controls3-3
–
CONTINUED –
Ignition switch
WARNING
Never turn the ignition switch to “LOCK” while the vehicle is be-
ing driven or towed because that will lock the steering wheel, pre- venting steering control. And when the engine is turned off, it
takes a much greater effort than usual to steer.
The ig nition switc h has four p ositions: LOCK, ACC, ON and START.
HB4000CA
LOCK
The key c an only b e inserted or removed in this p os ition. The ig nition
switc h will loc k the steering wheel when you remove the key.
If turning the key is d iffic ult, turn the steering wheel slig htly to the rig ht
and left as you turn the key.

3-12NOTE This light also comes on when the fuel filler cap is not tightened until it clicks.
If you have rec ently refueled your vehic le, the c au
se of the CHECK
ENGINE warning lig ht/malfunc tion ind ic ator lamp c om ing on c ould b e a
loose or missing fuel filler c ap . Remove the c ap an d retig hten it until it
c lic ks. Make sure nothing is interfering with the s ealing of the c ap .
Tig htening the c ap will not make the CHECK ENGINE w arning lig ht
turn off immed iately. It may take several d riving t rip s. If the lig ht d oes
not g o out, take your vehic le to your authorized SU BARU d ealer
immed iately. If the light is blinking:
If the lig ht is b linking while d riving , an eng ine m isfire c ond ition has
b een d etec ted whic h may d amag e the emission c ontrol system.
To p revent serious d amag e to the emission c ontrol s ystem, you
should d o the following : Red uc e vehic le sp eed .
Avoid hard ac c eleration.
Avoid steep up hill g rad es.
Red uc e the amount of c arg o, if p ossib le.
Stop towing a trailer as soon as p ossib le.
The CHECK ENGINE warning lig ht may stop b linking an d c ome on
stead ily after several d riving trip s. You should ha ve your vehic le
c hec ked b y an authorized SUBARU d ealer immed iately.
Charge warning light
If this lig ht c omes on when the eng ine is running , it may ind ic ate that the
c harg ing system is not working p rop erly.
If the lig ht c omes on while d riving or d oes not g o out after the eng ine
starts, stop the eng ine at the first safe op p ortuni ty and c hec k the alterna-
tor b elt. If the b elt is loose, b roken or if the b e lt is in g ood c ond ition b ut
the lig ht remains on, c ontac t your nearest SUBARU d ealer immed iately.

3-16
Brake system warning light
WARNING
Driving with the brake system warning light on is dangerous.
This indicates your brake system may not be working properly. If the light remains on, have the brakes inspected by a SUBARU
dealer immediately. If at all in doubt about whether the brakes are operating prop-
erly, do not drive the vehicle. Have your vehicle towed to the
nearest SUBARU dealer for repair.
This lig ht has the following two func tions: Parking brake warning
The lig ht c omes on with the p arking b rake ap p lied w hile the ig nition
switc h is in the “ON ” p osition. It g oes out when the p arking b rake is
fully released . Brake fluid level warning
This lig ht c omes on when the b rake fluid level has d rop p ed to near
the “MIN ” level of the b rake fluid reservoir with the ig niti on switc h in
the “ON ” p osition and with the p arking b rake fully released .
If the b rake system warning lig ht should c ome on wh ile d riving (with
the p arking b rake fully released and with the ig nit ion switc h p osi-
tioned in “ON ”), it c ould b e an ind ic ation of leaking of b rake fl uid or
worn b rake p ad s. Have your vehic le c hec ked b y a SUB ARU d ealer
immed iately.
Door open warning lights
The sp ec ific d oor op en warning lig ht c omes on if an y d oor or the rear
g ate is not fully c losed .
Always make sure this lig ht is out b efore you start to d rive.
Low fuel warning light
The low fuel warning lig ht c omes on when the tank i s nearly emp ty ab out
2.6 U.S. g al. (10.0 liters, or 2.2 Imp . g al.). It o nly op erates when the ig ni-(U.S.)
(Canada)

Instruments and controls3-21
–
CONTINUED –
To flash the head lig hts, p ull the lever toward you
and then release it.
The hig h b eam will stay on for as long as you hold the lever. The
head lig ht flasher works even thoug h the lig hting sw itc h is in the “OFF ”
p osition.
When the head lig hts are on hig h b eam, the hig h b eam ind ic ator lig ht
“ a ” on the instrument p anel also c omes on.
Daytime running light system
WARNING
The tail lights, parking lights, and side marker lights are not turned on by the daytime running light system. The light switchmust always be turned to the “a ” position when it is dark out-
side.
The low b eam head lig hts will automatic ally c ome on at red uc ed b rig ht-
ness when the eng ine has started , und er the followi ng c ond itions:
The p arking b rake is fully released .
The lig ht switc h is in the “OFF ” or “p ” p osition.
Turn signal lever
HB2015BB
Right turn Left turn
To ac tivate the rig ht turn sig nal, p ush the turn si g nal lever up . To ac tivate
the left turn sig nal, p ush the turn sig nal lever d o wn. When the turn is fin-

Instruments and controls3-27
–
CONTINUED –

Wiper intermittent time control (if equipped)
HB2023BA
When the wip er switc h is in the “” p osition, turn the d ial to ad just
the op erating interval of the wip er. Mist (for a single wipe)
For a sing le wip e of the wip ers, p ull the lever tow ard you. The wip ers
op erate until you release the lever. Washer
HB2020BA
To wash the wind shield , p ush the washer b utton at t he end of the wip -
er c ontrol lever. The washer fluid sp rays until you release the washer
b utton. The wip ers op erate while you p ush the b utto n.

Instruments and controls3-31
–
CONTINUED –
The wind shield wip er d eic er op erates only when the
ig nition switc h is in
the “ON ” p osition.
Before turning on the wind shield wip er d eic er, remo ve any snow from the
wind shield . To turn on the wind shield wip er d eic er, p ush the switc h. The
ind ic ator lig ht loc ated on the switc h lig hts up whi le the wind shield wip er
d eic er is op erating .
The wind shield wip er d eic er will automatic ally shut off after ab out 15 min-
utes. If the wip er b lad es have b een d eic ed c omp lete ly b efore that time,
p ush the switc h to turn it off. It also turns off w hen the ig nition switc h is
turned to the “ACC ” or “LOCK ” p osition. If d eic ing is not c omp lete when
you restart your vehic le, you have to p ush the swit c h to turn the d eic er
on ag ain. Mirrors
Always c hec k that the insid e and outsid e mirrors ar e p rop erly ad justed
b efore you start d riving . Inside mirror
HB4003BB
The insid e mirror has a d ay and nig ht p osition. Pul l the tab at the b ottom
of the mirror toward you for the nig ht p osition. Pu sh it away for the d ay
p osition. The nig ht p osition red uc es g lare from hea d lig hts.

4-2
Ventilator
Center and side ventilators
HB5001BB
Adjustable side defroster grille (for driver ’s side only)
HB5003BB
HB5002BB
Normal position
Side defroster grilleFin
Windshield defrost assist position
The d river ’s sid e d efroster g rille is ad justab le. The normal p osition as
shown in the d iag ram d irec ts warm air to the sid e g lass. When more
rap id d efrosting of the wind shield is d esired , the air flow c an b e
d irec ted temp orarily toward the wind shield to assis t the wind shield
d efroster. If this is d one, the d river ’s sid e g rille should always b e
returned to its normal p osition so that the warm ai r flow c an then b e
used to d efrost the d river ’s sid e wind ow.

Climate control4-7
–
CONTINUED –
4. Set the fan sp eed c ontrol d ial to the hig hest sp e
ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Heating and defrosting
HB5012AA
To d irec t warm air toward the floor and the wind shi eld :
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.

4-8
Heating
HB5013AA
To d irec t warm air toward the floor:
1. Set the air inlet selec tion b utton to the “OFF ” p osition
2 Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Bi-level heating
HB5014AA
This setting allows you to d irec t air of d ifferent temp eratures from the

4-14NOTE
You can check the outside air temperature even when the Au-
tomatic Climate Control is off. (The ignition switch should be in the “ON” position.)
In the following cases, the display can indicate a higher tem-
perature than the actual outside air temperature: – In direct sunlight
– When the vehicle is parked for a long period of time with the
engine kept running.– During stop and go driving
n
— Defroster switch
To d efrost or d ehumid ify the wind shield and sid e wi nd ow, p ush the
d efroster switc h “
”. When the “” switc h is p ushed , re-
g ard less whether the air c ond itioner is op erating o r not, outsid e air is
d rawn into the p asseng er c omp artment, the air c ond i tioner c omp res-
sor turns on, air flow is d irec ted toward s the wind shield and sid e win-
d ows, and the ind ic ator lig ht “
” on the c ontrol p anel c omes on.
After eliminating the fog g ing from the wind shield , set the air c ond ition-
er b ac k in the AUTO mod e b y p ushing the “AUTO ” switc h or turn off
b y p ushing the “OFF ” switc h or “
” switc h.
n
— Fan speed control switch
HB5021BB
The fan sp eed c ontrol switc h has the 5 p ositions: A UTO p osition and
4 d ifferent fan sp eed p ositions.