key battery SUBARU OUTBACK 2001 3.G Owners Manual

Keys and doors2-7
–
CONTINUED –
Keyless entry system (if equipped)
CAUTION
Do not expose the transmitter to severe shocks, such as those
experienced as a result of dropping or throwing. Do not take the transmitter apart except when replacing the
battery. Do not get the transmitter wet. If it gets wet, wipe it dry with a
cloth immediately. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the followingtwo conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received,including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to
operate the equipment.
Two transmitters are p rovid ed for your vehic le.
The keyless entry system has the following func tion s.
Loc king and unloc king the d oors (and rear g ate on t he station wag on)
without a key Sound ing a p anic alarm
Arming and d isarming the sec urity system (if your v ehic le is eq uip p ed
with an op tional sec urity system). See the next sec tion “Sec urity system
(if eq uip p ed ) ” for d etailed information.
The op erab le d istanc e of the keyless entry system i s ap p roximately 30
feet (10 meters). However, this d istanc e will vary d ep end ing on environ-
mental c ond itions. Rang e may b e red uc ed near sourc e s of RF interfer-
enc e suc h as p ower p lants and rad io/television b roa d c asting towers.
The keyless entry system d oes not op erate when the key is inserted in
the ig nition switc h.

Keys and doors2-9
–
CONTINUED –
b utton. Unless a b utton on the remote is p ressed , t
he alarm will b e
d eac tivated after ap p roximately 30 sec ond s. Selecting audible signal operation
Using the horn, the system will g ive you an aud ib le sig nal when the
d oors loc k and unloc k. If d esired , you may turn the aud ib le sig nal off.
To turn the aud ib le sig nal off, simultaneously d ep r ess “LOCK/ARM ”
and “UNLOCK/DISARM ” b uttons for more than two sec ond s. The horn
will sound two times to inform you that the aud ib le sig nal has b een
turned off.
To turn the aud ib le sig nal on, simultaneously d ep re ss “LOCK/ARM ”
and “UNLOCK/DISARM ” b uttons for more than two sec ond s. The horn
will sound one time to inform you that the aud ib le sig nal has b een
turned on. Replacing the battery
CAUTION
Do not let dust, oil or water get on or in the transmitter when
replacing the battery.
When the transmitter b attery b eg ins to g et weak, tr ansmitter rang e will
b eg in to d ec rease and the LED will not illuminate. Rep lac e the b attery
as soon as p ossib le.
HB1002BB
HB1001BA
Positive (+) side facing up
To rep lac e the b attery:
1. Remove the two sc rews on the b ac k of the transmit ter c ase b y

2-10using a p hillip s sc rewd river.
2. Sep arate the c ase.
3. Remove the old b attery from the hold er.
4. Rep lac e with a new b attery (Typ e CR2032 or eq uiva
lent) making
sure to install the new b attery with the p ositive ( + ) sid e fac ing up .
5. Install the b ac k half of the transmitter c ase.
6. Reinstall the two sc rews on the b ac k of the trans mitter c ase.
After the battery is replaced, the transmitter must be synchro-nized with the keyless entry system ’s control unit. Press either
the “LOCK/ARM” or “UNLOCK/DISARM” button six times to syn-
chronize the unit. Replacing lost transmitters
If you lose a transmitter or want to p urc hase ad d it ional transmitters
(up to four c an b e p rog rammed ), you should re-p rog r am all of your
transmitters for sec urity reasons. It is rec ommend e d that you have
your d ealer p rog ram all of your transmitters into y our system.
n Programming the transmitters
The keyless entry system is eq uip p ed with a sp ec ial c od e learning
feature that allows you to p rog ram new transmitter c od es into the sys-
tem or to d elete old ones. The system c an learn up to four uniq ue
transmitter c od es. The four transmitter c od es may b e the same or d if-
ferent.
To enter the programming mode:
HB1005BC
HB1000CB
1 Press to dis-
arm the security system (if so equipped).
2
3

11-4
Always use the proper tools and make certain that they are
well maintained. Never get under the vehicle supported only by a jack. Always
use a safety stands to support the vehicle. Never keep the engine running in a poorly ventilated area,
such as a garage or other closed areas. Do not smoke or allow open flames around the fuel or battery.
This will cause a fire. Because the fuel system is under pressure, replacement of the
fuel filter should be performed only by your SUBARU dealer. Wear adequate eye protection to guard against getting oil or
fluids in your eyes. If something does get in your eyes, thorough-
ly wash it out with clean water. Do not tamper with the wiring of the SRS airbag system or
seatbelt pretensioner system, or attempt to take its connectorsapart, as that may activate the system or it can render it inopera-tive. The wiring and connectors of these systems are yellow for
easy identification. NEVER use a circuit tester for these wiring. If your SRS airbag or seatbelt pretensioner needs service, con-
sult your nearest SUBARU dealer. Before checking or servicing in the engine compart- ment
Always stop the engine and set the parking brake firmly to pre-
vent the vehicle from moving. Always let the engine cool down. Engine parts become very
hot when the engine is running and remain hot for some time af-ter the engine is stopped. Do not spill engine oil, engine coolant, brake fluid or any other
fluid on hot engine components. This may cause a fire. Always remove the key from the ignition switch. When the
ignition switch is in the “ON” position, the cooling fan may oper-
ate suddenly even when the engine is stopped.