battery SUBARU OUTBACK 2003 3.G User Guide

3
Instruments and controls3-29
–
CONTINUED –
Rear window defogger switch
CAUTION
Do not use sharp instruments or window cleaner containing
abrasives to clean the inner surface of the rear window. They may
damage the conductors printed on the window. To prevent the battery from being discharged, do not operate
the defogger continuously for any longer than necessary.
The rear window defogger operates only when the ignition switch is inthe “ON” position.
The rear window defogger switch is located on the climate control panel.
The defogger will automatically shut off after about 15 minutes. If the win-
dow clears before that time, push the switch to turn it off. It also turns off
when the ignition switch is turned to the “ACC” or “LOCK” position. If
defrosting or defogging is desired when you restart your vehicle, you
have to push the switch to turn it on again.
For vehicles with manual heating and air conditioning systems
HB5009BB
To turn on the defogger, push the switch. To turn it off, push the switch again.
The indicator light located on the switch lights up while the rear win-dow defogger is operating.

3-30
For vehicles with automatic climate control
HB3016BB
To turn on the defogger, push the switch. To turn it off, push the switch again.The indicator light “u ” lights up on the climate control display panel
while the rear window defogger is operating.
Windshield wiper deicer (if equipped)
CAUTION
To prevent the battery from being discharged, do not operate thewindshield wiper deicer continuously for any longer than neces-
sary.
HB2027BB

3-36
Outside mirror defogger (if equipped) CAUTION
To prevent the battery from being discharged, do not operate the
defogger continuously for any longer than necessary.
The outside mirror defogger operates only when the ignition switch isin the “ON” or “ACC” position.
HB4004CB
To turn on the outside mirror defogger, push the switch while the en- gine is running.The indicator light located on the switch will come on when the out-
side mirror defogger heater in operation.
To turn it off, push the switch again.
Tilt steering wheel
WARNING
Do not adjust the steering wheel tilt position while driving. This
may cause loss of vehicle control and result in personal injury.

4
Climate control4-19
–
CONTINUED –
NOTE The temperature setting remains even after the ignition switch is turned to the
“OFF”. However, if the battery cables are discon-
nected, the temperature will be set to 77 F (25 C) automatically.
Set desired temperature by turning the temperature control dial; turn
the dial clockwise to raise the temperature setting and turn it counter-clockwise to lower it.
The temperature can be set in increments of 1 F within a range of 65
– 85 F for US models and in increments of 0.5 C within a range of 18
– 32 C for Canadian models.
Even when quick cooling or warming is necessary, you do not have to
change the temperature setting. The Automatic Climate Control sys-
tem operates at maximum performance until the air in the passenger
compartment reaches to the specified temperature. Temperature sensors
This Automatic Climate Control system employs the several sensors.
These are very delicate parts. Therefore, if these sensors are dam-
aged, it is possible that the Automatic Climate Control system will not
properly control the air temperature in the passenger compartment.
To prevent possible damage to the sensors, please observe the fol-lowing: – Do not allow anything to impact the sensors.
– Be careful not to let water contact the sensors.
– Do not cover the sensors.
The sensors are found at the following locations: –Sun-load sensor (beside the windshield defroster grille)
– In-vehicle temperature sensor (beside the temperature control
dial.)– Ambient sensor (at the under side of the bumper)

5
Audio5-9
–
CONTINUED –
Press the
“SCAN” button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the “SCAN” button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildingsand hills. Selecting preset stations
Presetting a station with a “preset button ”
4 allows you to select that
station in a single operation. Up to six WB (if equipped), AM, FM1 and
FM2 stations each may be preset. How to preset stations
1. Press the “BAND” button 2 to select FM1, FM2, AM or WB (if
equipped) reception.
2. Press the “SCAN” button or tune the radio manually until the
desired station frequency is displayed.
3. Press one of the preset buttons for more than 2 seconds to store
the frequency. At this time, there will momentarily be no sound from
the radio. If the button is pressed for less than 2 seconds, the preced-
ing selection will remain in memory.
NOTE If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, all stationsstored in the preset buttons are cleared. If this occurs, it is neces-sary to reset the preset buttons.

5-20band has been scanned from the low end to the high end.
Press the
“SCAN” button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the “SCAN” button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildings and
hills. Selecting preset stations
Presetting a station with a preset button 6 allows you to select that
station in a single operation. Up to six AM, FM1, FM2 and WB stations
each may be preset. How to preset stations
1. Press the “FM/AM” selection button to select AM, FM1 or FM2 re-
ception.
OR
Press the “WB” button
5 to select the weather band.
2. Press the “SCAN” button 8 or tune the radio manually until the de-
sired station frequency is displayed.
3. Press one of the preset buttons 6 for at least 1.5 seconds to store
the frequency. The frequency of the station will flash once on the dis-
play at this time. If the button is pressed for less than 1.5 seconds, the
preceding selection will remain in memory. NOTE If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, all stationsstored in the preset buttons are cleared. If this occurs, it is neces-sary to reset the preset buttons.

6-2
Interior light
Dome light
HS6003BC
The dome light switch has three positions: ON: The light stays on continuously.
DOOR (middle position): The light comes on when any of the doors (or
the rear gate on the wagon) is opened. The light remains on for several
seconds and gradually goes out after all doors (and the rear gate on the
wagon) are closed.
The light also can be turned on by use of the keyless entry transmitter. See the “Keyless entry system ” in chapter 2 for detailed information.
OFF: The light stays off.
When leaving your vehicle, make sure the light goes out to avoid batterydischarge.

6
Interior equipment6-11
–
CONTINUED –
HB6011DA
The cigarette lighter operates only when the ignition switch is in the
“ON” and “ACC” positions.
To use the cigarette lighter, push in the knob and wait a few moments.
It will automatically spring up when ready for use. Using as an accessory power outlet
Electrical power (12V DC) from the battery is on tap at the socket when the ignition switch is either in the “ACC” or “ON” position.
If you use the socket as an accessory power outlet, take the following
precautions.
When the socket is not in use, always put the cap on the socket to
prevent any foreign object from entering it.
CAUTION
Use only in-car use electrical appliances which are designed
for 12V DC and which consume less than 120W. Overloading the
socket can cause a short circuit. Do not use double adapters ormore than one electrical appliance. If the plug on your electric appliance is either too loose or too
tight for the socket, this can result in a poor contact or cause the
plug to get stuck. Only use plugs that fit properly. Use of an electric appliance in the socket for a long period of
time while the engine is not running can cause battery discharge. Before driving your vehicle, make sure that the plug and the
cord on your electrical appliance will not interfere with your shift-

6-16trouble), just call OnStar. We will contact your vehicle manufacturer
’s
roadside service provider for the help you need to get you quickly
back on the road.
*** There will be no charge for Roadside Assistance as long as the basic lim-
ited warranty on your vehicle has not expired. Stolen vehicle location
OnStar doesn ’t just protect you, it protects your vehicle, too. If your
vehicle is ever stolen, just contact OnStar. We will put you in touch with the authorities and aid them in locating your vehicle. Ask your in-
surance carrier about possible premium discounts. AccidentAssist
AccidentAssist provides step-by-step guidance about what to do in
case of an accident. Working with leading insurance companies wehave developed a “best practices ” list to assist you through most ac-
cident situations. OnStar AccidentAssist can make the process of
completing a police report and/or insurance claim less stressful. Remote door unlock/vehicle alert
If you ’ve locked your keys in your vehicle, just call OnStar at
1-888-466-7827 (888-4ONSTAR) and an Advisor will send a signal to
attempt to unlock your door. If you ’re having trouble locating your ve-
hicle, OnStar can flash your lights and sound your horn for you. This
feature is disabled 48 hours after the vehicle is parked in order to
maintain battery charge. OnStar MED-NET****
OnStar MED-NET securely stores your personal medical information (e.g., physician ’s name, emergency contacts, medications, chronic
conditions) and in an emergency, can quickly send it to a medical fa-
cility. This important information can help assist with diagnosis and
treatment.
**** Requires activation and additional fee for Safe & Sound and Directions &
Connections subscribers. To enroll or for more OnStar Med-Net information,
call 1-800-320-3991.

6
Interior equipment6-19
–
CONTINUED –

subject to limitations caused by atmospheric conditions, such as se-
vere weather or topographical conditions, such as mountainous terrain; subject to cellular carrier equipment limitations.
Global positioning locating capabilities will not be available if satellite
signals are obstructed. OnStar will not function if the vehicle ’s battery is discharged or discon-
nected. It may also be inoperative if the vehicle is in an accident and the
OnStar or vehicle electrical system components are damaged.
OnStar is the communication link between you and existing governmen-
tal emergency and roadside service providers. OnStar will receive your
call and use reasonable effort to contact an appropriate provider. OnStar
cannot promise that the providers will respond in a timely manner or atall.
Accessory power outlet
In the luggage compartment (if equipped) CAUTION
Do not attempt to use a cigarette lighter in the accessory
power outlet. Do not place any foreign objects, especially metal ones such
as coins or aluminum foil, into the accessory power outlet. Thatcould cause a short circuit. Always put the cap on the accessorypower outlet when it is not in use. Use only electrical appliances which are designed for 12V DC
and which consume less than 120W. Overloading the accessorypower outlet can cause a short circuit. Do not use double adapt-ers or more than one electrical appliance. If the plug on your electric appliance is either too loose or too
tight for the accessory power outlet, this can result in a poor con-tact or cause the plug to get stuck. Only use plugs that fit proper-
ly.