radio SUBARU OUTBACK 2003 3.G Owner's Manual

5-30
Choose the preset button 5 to which you wish to assign that sta-
tion and press it continuously for a period of more than 2 seconds.
When the radio station has been successfully registered, the display
will flash the corresponding radio frequency on and off once. NOTE Each preset button can be used to store both an FM station
and an AM station. If the power supply is interrupted by disconnection of the bat-
tery, memory presets will be cleared and will be required to be re-input. Weather band button (WB)
Push the “WB” button
2 when the radio is off to turn on the radio in
the weather band.
Press the “WB” button
2 when the radio is on to select the weather
band.

5
Audio5-31
–
CONTINUED –
Built-in CD changer operation
HB5063CB
9 DISC IN indicator light
Q Disc slot
W Eject button
E LOAD button R
Repeat button
T FF· FB dial
Y Disc button
U Disc select button
NOTE Single CDs (i.e., 8-cm/3-inch CDs) are not supported, and if in-
serted, they will be immediately ejected. Make sure to always insert a disc with the label side up. If a disc
is inserted with the label side down, it might be ejected or the playermight shut off. If a disc is inserted during a radio broadcast, the disc will inter-
rupt the broadcast. After the last song finishes, the disc will automatically return to
track 1 (the first song on the disc) and will automatically play back.

5-38
To remove all discs at one time
1. Press and hold the “Eject” button 4 until all “Disc” indicators begin
blinking (about 1.5 seconds), and the first disc will be ejected.
2. When the disc is removed, the next one will be ejected, and so on. To replace a playing disc with another
Simply press the desired one of “Disc select ” buttons
3 (numbered
from 1 to 6) or press the “DISC UP ” or “DISC DOWN ” button on the
radio unit to select the desired disc, and the disc will begin to play. Disc indicators
Lit: when the corresponding storage tray is occupied by a disc. Blinking: Disc player is either in loading, eject or changing mode.OFF: No disc is loaded or the ignition switch is in the “LOCK” position.
Function control
Refer to CD player control operating instructions described in the“ Type A and B audio sets ” or “Type C audio set ” section.

6-14Your call will be given the highest priority, and you will hear a chime
followed by the words
“Connecting to OnStar Emergency. ” The Advi-
sor will attempt to locate your vehicle, find out what kind of assistance
you require, and contact a nearby emergency services provider who
can dispatch ambulance, fire, police or other emergency services.
Please use this button only for true emergencies. If you press this but-
ton by mistake, please stay on the line and tell the advisor that there
is no emergency. OnStar communication button (White DOT)
Press this button at the end of a call. You ’ll hear the words “OnStar
Request Ended. ” Also, press this button to answer a call from the
OnStar Center, or cancel a call if one of the other buttons is acciden-
tally pressed. This button is also used to access OnStar Personal
Calling and Virtual Advisor services, if those services have been acti-vated. System status light
Solid green – Indicates the OnStar system in the vehicle is pow-
ered ON and ready to make or receive calls. Blinking green – The light blinks green to indicate a call is being
connected or in progress. If you notice this light blinking while you are
not on a call, press the OnStar Communication (white dot) button. Red – This signals that your OnStar system may not be functioning
properly. Press the OnStar button to attempt to contact an OnStar ad-
visor. If the connection is made, the advisor will assist you in making
sure your OnStar system is operating properly. If you cannot contact
the OnStar Center, please take your vehicle to the nearest Subarudealership for diagnosis and service. Volume control
You can control the volume of the OnStar System using the volume
control knob on the radio.
OnStar subscription plans* The OnStar safe & sound plan
Choose this plan for excellent protection, 24/7, 365 days a year. It in-

8-8and otherwise similar to on-road driving conditions. Operating it under other than those conditions could subject the vehicle to excessive
stress which might result in damage not eligible for repair under war-
ranty. If you do take your SUBARU off road, you should review the
common sense precautions in the next section (applicable to the
OUTBACK) for general guidance. But please keep in mind that your
vehicle’
s off-road capabilities are more limited than those of the OUT-
BACK.
Never attempt to drive through pools and puddles, or roads flooded
with water. Water entering the engine air intake or the exhaust pipe or
water splashing onto electrical parts may damage your vehicle andmay cause it to stall. OUTBACK
Because of the AWD feature and higher ground clearance, your
Subaru can be driven on ordinary roads or off-road. But please keep
in mind that an AWD Subaru is a passenger car and is neither a con-
ventional off-road vehicle nor an all-terrain vehicle. If you do take your
Subaru off-road, certain common sense precautions such as the fol-lowing should be taken: Make certain that you and all of your passengers are wearing seat
belts. Carry some emergency equipment, such as a towing rope or
chain, a shovel, wheel blocks, first aid kit and portable phone or citi-zens band radio. Drive carefully. Do not take unnecessary risks by driving in danger-
ous areas or over rough terrain. Slow down and employ extra caution at all times. When driving off-
road, you will not have the benefit of marked traffic lanes, banked
curves, traffic signs and the like. Do not drive across steep slopes. Instead, drive either straight up
or straight down the slopes. A vehicle can much more easily tip over
sideways than it can end over end. Avoid driving straight up or down
slopes that are too steep. Avoid sharp turning maneuvers, especially at higher speeds.
Do not grip the inside or spokes of the steering wheel. A bad

12
Specifications12-7
–
CONTINUED –
Fuse panel Circuit
Fuse rating
420ACigarette lighter
Remote controlled rear view mirrors
510ATail light
Parking light
615ASRS airbag
715AFront fog light
830AABS solenoid
915ARadio
Clock
1015ATrailer
1115AEngine ignition system
SRS airbag
1210AIllumination brightness control
1315AFuel pump
1410ARear window wiper and washer
1530AWindshield wiper and washer
1620ABrake light
1715AAir conditioner
1815ABackup light
Cruise control
ABS control

12
Specifications12-9
–
CONTINUED –
Fuse panel Circuit
Fuse rating
420ACigarette lighter
Remote controlled rear view mirrors
510ATail light
Parking light
615ASRS airbag
715AFront fog light
830AABS (VDC) solenoid
915ARadio
Clock
1015ATrailer
1115AEngine ignition system
SRS airbag
1210AIllumination brightness control
1315AFuel pump
1410ARear window wiper and washer
1530AWindshield wiper and washer
1620ABrake light
1715AAir conditioner
1815ABackup light
Cruise control
ABS (VDC) control
1920AMirror heater
Wiper deicer

12
Specifications12-15
–
CONTINUED –
Vehicle identification
HBD002BB
1 Emission control label
2 Vehicle identification number
3 Radio noise label (Canada model)
4 Vacuum hose connectionslabel 5
Tire inflation pressure label
6 Certification and bar cordlabel
7 Vehicle identification numberplate
8 Model number plate