airbag SUBARU OUTBACK 2004 4.G User Guide

1-4
Seat, seatbelt and SRS airbags
T
Power seat (if equipped)
To adjust the seat forward or backward, move the con-
trol switch forward or backward. „
Seat cushion angle and height adjust-
ment (Power seat only)
UB1060BA
UB1078BA

1-5
Seat, seatbelt and SRS airbags
– CONTINUED –
To adjust the angle and height of the seat cushion,
move the control switch in the corresponding direction. „
Reclining the seatback
To prevent the passenger from sliding under
the seatbelt in the event of a collision, always
put the seatback in the upright position while
the vehicle is in motion. Also, do not place ob-
jects such as cushions between the passenger
and the seatback. If you do so, the risk of slid-
ing under the lap belt and of the lap belt sliding
up over the abdomen will increase, and both
can result in serious internal injury or death.
UB1062BA
HS1037BA

1-6
Seat, seatbelt and SRS airbags
T
Manual type
Pull the reclining lever up and adjust the seatback to
the desired position. Then release the lever and make
sure the seat is securely locked into place.
The seatback placed in a reclined position can spring
back upward with force when released. When operat-
ing the reclining lever to return the seatback, hold it
lightly so that it may be raised back gradually. T
Power seat (if equipped)
To adjust the angle of the seatback, move the control switch.
NOTE
While adjusting the seatback, you can not at the
same time adjust the seat position or the seat
cushion angle and height.
UB1072BAUB1084BA

1-7
Seat, seatbelt and SRS airbags
– CONTINUED –
„Head restraint adjustment
To raise the head restraint, pull it up. To lower it, push
the head restraint down while pressing the release
button on the top of the seatback.
The head restraint should be adjusted so that the cen-
ter of the head restraint is closest to the top of the oc-
cupant’s ears.
Never drive the vehicle with the head restraints
removed because they are designed to reduce
the risk of serious neck injury in the event that
the vehicle is struck from the rear.
NOTE
If the seatback is reclined rearward to the same
level as the rear seat cushion with the head re-
straint removed, a wide flat bed is made available.
y Never drive your car with the seats converted
in a flat bed position. If you do so, occupants
will have a greater chance of being injured even
during simple deceleration, acceleration and
cornering since no firm restraint will be avail-
able for them. y Before you lie on the flat bed to take a rest,
read the description “Parking your vehicle” in
Chapter 7 carefully and follow the instructions.
UB1016BA

1-8
Seat, seatbelt and SRS airbags
1. Slide the front seat forward as far as possible.
2. Pull off the head restraint while pressing the re-
lease button.
3. Recline the seatback rearward up to the lowest po-
sition. Remember to reinstall the head restraint when-
ever the seatback is raised back.
„
Lumbar support (if equipped)
Pull the lever forward or backward.
Pulling the lever forward will increase the amount of
support for your lower back.
UBS011AA
UB1059BA

1-9
Seat, seatbelt and SRS airbags
– CONTINUED –
Seat heater (if equipped)
1) Heating element
The seat heater operates when the ignition switch is
either in the “ACC” or “ON” position. 1) Indicator light
To turn on the seat heater, push the “LO” or “HI” posi-
tion on the switch, as desired, depending on the tem-
perature. Selecting the “HI” position will cause the seat
to heat up quicker.
LO: Normal heating
HI: Rapid heating
The indicator located on the switch comes on when
the seat heater is in operation. When the vehicle’s in-
terior is warmed enough or before you leave the vehi-
cle, be sure to turn the switch off.
1
UB1073BB
1 LO
HI
UB1093BB

1-10
Seat, seatbelt and SRS airbags
y
There is a possibility that people with delicate
skin may suffer slight burns even at low tem-
peratures if he/she uses the seat heater for a
long period of time. When using the heater, al-
ways be sure to warn the persons concerned. y Do not put anything on the seat which insu-
lates against heat, such as a blanket, cushion,
or similar items. This may cause the seat heater
to overheat.
NOTE y Use of the seat heater for a long period of time
while the engine is not running can cause battery
discharge. y When cleaning the seat, do not use benzine,
paint thinner, or any similar materials.
Rear seats
Seatbelts provide maximum restraint when the
occupant sits well back and upright in the seat.
Do not put cushions or any other materials be-
tween occupants and seatbacks or seat cush-
ions. If you do so, the risk of sliding under the
lap belt and of the lap belt sliding up over the
abdomen will increase, and both can result in
serious internal injury or death.
UB0302

1-11
Seat, seatbelt and SRS airbags
– CONTINUED –
Never stack luggage or other cargo higher than
the top of the seatback because it could tumble
forward and injure passengers in the event of a
sudden stop or accident. „
Armrest (if equipped)
Sedan
HS8005BA
UB1068BA

1-12
Seat, seatbelt and SRS airbags
Station wagon
To lower the armrest, pull on the top edge of the arm- rest.
To avoid the possibility of serious injury, pas-
sengers must never be allowed to sit on the
center armrest while the vehicle is in motion. T
Loading long objects (Sedan)
Folding down the armrest and opening the seatback
panel affords a loading space for long objects.
To open the seatback panel, pull the panel down while
pressing the release tab down.y Secure long objects properly to prevent them
from shooting forward and causing serious in-
jury during a sudden stop or sharp cornering.
Tie long objects down with a rope or something
equivalent.y Avoid loading objects longer than 6.6 ft (2 m)
UB1100BA
UB1052BA

1-13
Seat, seatbelt and SRS airbags
– CONTINUED –
and heavier than 55 lbs (25 kg). Such objects
can interfere with the driver’s proper operation
of the car, possibly causing an accident and se-
rious injury. „
Headrest adjustment – Rear center
seating position on Station wagon
To raise the headrest, pull it up. To lower it, push the
headrest down while pressing the release button on
the top of the seatback.
When the rear center seating position is occupied,
place the headrest in its highest position. When the
rear center seating position is not occupied, lower the
headrest to improve rearward visibility.
UB1053BA
UB1099BA