buttons SUBARU OUTBACK 2005 4.G Owners Manual

2-16
Keys and doors
sired, you may turn the audible signal off.
To turn the audible signal off, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound twice and the turn
signal lights will flash twice to inform you that the audi-
ble signal has been turned off.
To turn the audible signal on, unlock the doors by
pushing “ ” button and then simultaneously de-
press “ ” and “ ” buttons for more than two sec-
onds. An electronic chirp will sound once and the turn
signal lights will flash once to inform you that the audi-
ble signal has been turned on.
You may have the above settings done by your SUB-
ARU dealer. !
Replacing the battery
Do not let dust, oil or water get on or in the
transmitter when replacing the battery.
When the transmitter battery begins to get weak,
transmitter range will begin to decrease and the LED
will not illuminate. Replace the battery as soon as pos- sible.
To replace the battery:
1. Open the transmitter case using a flat-head screw-
driver.
UB2208BA

4-11
Climate control
– CONTINUED –
!Control panel
A) AUTO button
B) Temperature control dial (driver’s side)
C) Defroster button
D) Temperature control dial (passenger’s side)
E) Rear window defogger button (Refer to the “Rear win- dow defogger button” in chapter 3.)
F) Air conditioner button
G) Air flow mode selection button
H) Fan speed control button
I) Air inlet selection button
J) OFF button !
AUTO button
AUTO mode operation:
When the “AUTO” button is pressed, the indicator light
“AUTO” on the display comes on. In this state, fan
speed, air flow distribution, air-inlet control, and air
conditioner compressor operation are automatically
controlled.
Manual mode operation:
If you operate any of the buttons on the control panel
other than the “OFF” button and temperature control
dial during automatic mode operation, the indicator
light “AUTO” on the control panel will go out. You can
then manually control the system as desired using the
AB
JIHGF E CD
UB4202BBUB4204BA

5-1
5
Audio
Antenna system ............................................ 5-2 Printed antenna ................................................. 5-2
FM reception ..................................................... 5-2
Installation of accessories ........................... 5-3
Audio set ........................................................ 5-3 Type A audio set ............................................... 5-3
Type B audio set ............................................... 5-4
Type C audio set ............................................... 5-4
Type A audio set (if equipped) ..................... 5-5 Radio operation ................................................ 5-6
Compact disc player operation ....................... 5-11
Type B audio set (if equipped) ..................... 5-18 Radio operation ................................................ 5-19
Built-in CD changer operation ......................... 5-24
Type C audio set (if equipped) ..................... 5-37 Radio operation ................................................ 5-38
Built-in CD changer operation ......................... 5-43
Audio control buttons (if equipped) ............ 5-56
Precautions to observe when handling a compact disc .......................................... 5-58
MP3 audio ...................................................... 5-60 What is MP3? .................................................... 5-60
Creating MP3 files ............................................. 5-60
Saving MP3 files on a disc ............................... 5-60
Supported file systems .................................... 5-61
Compression format ......................................... 5-61
Numbers of folders and files ........................... 5-61
Copyright issues ............................................... 5-61

5-11
Audio
– CONTINUED –
the button, the radio will scan down the frequency
band (from high frequencies to low frequencies).
Automatic tuning may not function properly if the sta-
tion reception is weakened by distance from the sta-
tion or proximity to tall buildings and hills. !Selecting preset stations
Presetting a station with a “preset button” allows you
to select that station in a single operation. Up to six,
AM, FM1 and FM2 stations each may be preset. ! How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2,
or AM reception. 2. Press the “ ” or “ ” side of the button or tune
the radio manually until the desired station frequency
is displayed.
3. Press one of the preset buttons for more than 1.5
seconds to store the frequency. If the button is
pressed for less than 1.5 seconds, the preceding se-
lection will remain in memory.
NOTE "
If the connection between the radio and battery
is broken for any reason such as vehicle mainte-
nance or radio removal, all stations stored in the
preset buttons are cleared. If this occurs, it is nec-
essary to reset the preset buttons. " If a mobile telephone is placed near the radio, it
may cause the radio to emit noise when it receives
calls. This noise does not indicate a radio fault. ! Compact disc player operation
! To playback a compact disc
" When CD is not in the player
Hold a disc with a finger in the center hole while grip-
ping the edge of the disc, then insert it in to the slot
(with the label side up) and the player will automatical-
ly pull the disc into position.
123 456
UB5210AA

5-24
Audio
to high frequencies). If you hold down the “ ” side of
the button, the radio will scan down the frequency
band (from high frequencies to low frequencies).
Automatic tuning may not function properly if the sta-
tion reception is weakened by distance from the sta-
tion or proximity to tall buildings and hills. !
Selecting preset stations
Presetting a station with a preset button allows you to
select that station in a single operation. Up to six AM,
FM1 and FM2 stations each may be preset. ! How to preset stations
1. Press the “FM” or “AM” selection button to select AM, FM1 or FM2 reception.
2. Press the “ ” or “ ” side of the button or tune
the radio manually until the desired station frequency is displayed.
3. Press one of the preset buttons for
at least 1.5 sec-
onds to store the frequency. The frequency of the sta-
tion will flash once on the display at this time. If the but-
ton is pressed for less than 1.5 seconds, the preceding
selection will remain in memory.
NOTE " If the connection between the radio and battery
is broken for any reason such as vehicle mainte-
nance or radio removal, all stations stored in the
preset buttons are cleared. If this occurs, it is nec-
essary to reset the preset buttons." If a mobile telephone is placed near the radio, it
may cause the radio to emit noise when it receives
calls. This noise does not indicate a radio fault. ! Built-in CD changer operation
NOTE "Make sure to always insert a disc with the label
side up. If a disc is inserted with the label side
down, it might be ejected or the player might shut
123 456
UB5210AA

5-28
Audio
"
When there are CDs loaded:
Press a desired one of the “Disc select” buttons the
disc number indicator of which steadily lights up. The
player will then start playback of the selected CD, be-
ginning with the first track.
If you have inserted a disc that the player cannot read,
the player will show the elapsed time but will not pro-
duce any sound. !
To select a song from its beginning
" Forward direction
Briefly press the “ ” side of the TUNE/TRACK but-
ton to skip to the beginning of the next track. Each time
this side of the button is pressed, the indicated track
number will increase.
123 456
UB5210AA
TUNE
TRACK
UB5211BA

5-43
Audio
– CONTINUED –
the button, the radio will scan down the frequency
band (from high frequencies to low frequencies).
Automatic tuning may not function properly if the sta-
tion reception is weakened by distance from the sta-
tion or proximity to tall buildings and hills. !Selecting preset stations
Presetting a station with a “preset button” allows you
to select that station in a single operation. Up to six
AM, FM1 and FM2 stations each may be preset. ! How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2
or AM reception. 2. Press the “ ” or “ ” side of the button or tune
the radio manually until the desired station frequency
is displayed.
3. Press one of the preset buttons for more than 1.5
seconds to store the frequency. If the button is
pressed for less than 1.5 seconds, the preceding se-
lection will remain in memory.
NOTE "
If the connection between the radio and battery
is broken for any reason such as vehicle mainte-
nance or radio removal, all stations stored in the
preset buttons are cleared. If this occurs, it is nec-
essary to reset the preset buttons. " If a mobile telephone is placed near the radio, it
may cause the radio to emit noise when it receives
calls. This noise does not indicate a radio fault. ! Built-in CD changer operation
NOTE "Make sure to always insert a disc with the label
side up. If a disc is inserted with the label side
down, it might be ejected or the player might shutoff." If a disc is inserted during a radio broadcast, the
disc will interrupt the broadcast.
123 456
UB5210AA

5-47
Audio
– CONTINUED –
"When there are CDs loaded:
Press a desired one of the “Disc select” buttons the
disc number indicator of which steadily lights up. The
player will then start playback of the selected CD, be-
ginning with the first track.
If a disc that the player cannot read has been loaded,
the player will eject that disc and proceed to the nextdisc. !
To select a song from its beginning
" Forward direction
Briefly press the “ ” side of the TUNE/TRACK but-
ton to skip to the beginning of the next track/file (track).
Each time the button is pressed, the indicated track/
file (track) number will increase.
NOTE
In an MP3 folder, skipping past the last track/file (track) will take you back to the first track/file
(track) in the folder.
123 456
UB5210AA
TUNE
TRACK
UB5211BA

5-54
Audio
!
Folder selection
Press the “ ” side of the SEEK/SCAN button briefly
to select the next folder. Press the “ ” side of the
button briefly to go back to the previous folder. The
folder title will be shown each time you press one of the buttons.
NOTE " Selecting folders in this way is possible only
within a single disc. " Only MP3 folders are recognized when an at-
tempt to select the next or previous folder is made.
If no appropriate folder exists on the disc, press-
ing the “ ” or “ ” side of the SEEK/SCAN but- ton has no effect. !
How to unload CDs from the player
" Ejecting a CD from the player
Of the discs loaded, you can select and remove only
one disc.
0
1. Use the disc select button to select the disc to be
ejected.
SEEK
SCAN
UB5212DA123 456
UB5210AA

5-56
Audio
"
If you press the “ ” button while the player is
in all disc ejection mode, the mode will be can-
celled following ejection of the disc that is current-
ly being ejected. " If you press the “CD” button while the player is
in all disc ejection mode, the player will draw in the
discs that have been ejected and play them.Audio control buttons (if equipped)
These buttons are located on the spokes of the steer-
ing wheel. They allow the driver to control audio func-
tions without taking his/her hands off the steering
wheel. ! MODE button
This button is used to select the desired audio mode.
Each time it is pressed, the mode changes to the next
one in the following sequence:
UB5559BA
FM* AM* CD