warning SUBARU OUTBACK 2017 6.G Quick Reference Guide

2
Remote keyless entry system
Remote
transmitter key
(if equipped) Access key
(if equipped)
Lock/Unlock doors
PANIC
basic ope
Ration
* Grip the driver’s door handle to unlock the
driver’s door. Grip the front passenger’s door
handle to unlock all doors.
All doors and the rear gate will be locked/unlocked by the following procedures carrying the
access key on your person. (The driver should always carry the access key.)
For detailed operating and safety information, please refer to
your o
wner’s Manual.
Keyless access function (if equipped)
Side door (front door handles only):
1
All doors and the rear gate will be locked.
2
The driver’s door will be unlocked.
(To unlock all doors and the rear gate,
briefly press the button a second time
within 5 seconds.)
3
Press and hold to open the rear gate.
4
The horn will sound and the hazard warning
flashes will flash.
Opening rear gate:
Press Press
Lock Open
23
4
1
1
2
3
4
Lock
Unlock*
Door lock sensor
Grip
To u c h
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

7
1
Windshield wiper
To operate the wiper, rotate knob to;
: Mist (for a single wipe) : Off : Intermittent : Low speed : High speed
2
Wiper intermittent time control
3
Windshield washer
4
Rear window wiper and washer
To operate the wiper, rotate knob to;
: Continuous
: Intermittent
: Off
: Washer
Rotate knob to
. The washer fluid sprays and the
wiper operates.
Wiper and washer switchB
To turn on the hazard warning flasher, press the button.
Use the hazard warning flasher when you have to park
in emergency conditions.
Hazard warning flasher switchC
Turn the dial to adjust the illumination brightness of the
instrument panel.
When the control dial is turned fully upward to
position, the illumination brightness becomes the
maximum and the automatic dimming function does not
work at all.
Illumination brightness control dialD
*The design may be slightly different from the
illustration depending on the models.
1
2
3
4

13
1
ECO gauge
2
Basic screen
3
Cruise control information
4
Select lever/gear position indicator
5
Warning screen
6
Odometer/double trip meter
Control switch: By operating ▲ or ▼ of the control
switch, the screens and selection items
can be switched. When the
/SET
switch is pulled toward you, the item
can be selected and set.
km/h
km
Multi information displayD
If the BSD/RCTA OFF switch is pressed, the BSD/RCTA
OFF indicator is displayed on the multi information
display of the combination meter, and the BSD/RCTA is
deactivated.
The BSD/RCTA consists of rear radar with Blind
Spot Detection, Lane Change Assist and Rear
Cross Traffic Alert.
The system notifies the driver when vehicles in
the blind area are approaching from behind in the
neighboring lanes.
B S D / R C TA
BSD/RCTA OFF switch (if equipped)E
Control
switch
1
2
3
4
6
5

15
When there is the risk of a rear-end collision with an obstacle in front, the EyeSight
system helps to minimize or prevent a collision by warning the driver. If the driver still
does not take evasive action to avoid a collision, the brakes can be automatically applied
just before the collision in order to reduce impact damage, or if possible, prevent the
collision. If the driver takes evasive action to avoid a collision, Pre-Collision Brake Assist
will operate in order to help the driver to prevent the collision.
Pre-Collision Braking System
Lane Departure Warning OFF switch (Models with EyeSight system)H
Press and hold this switch for approximately
2 seconds or longer to turn off the Lane Departure
Warning and Lane Sway Warning functions.
Pre-Collision Braking System OFF switch (Models with EyeSight system)I
Press and hold this switch for approximately 2
seconds or longer to turn off the Pre-Collision
Braking System and Pre-Collision Throttle
Management.
When vehicle speed is approximately 50 km/h (30 MPH) or more, this function warns
the driver if the system detects that the vehicle is likely to depart the traffic lane.
Lane Departure Warning

17
Some warning/indicator lights illuminate for a few seconds in order to check themselves
when the ignition switch is turned ON.
Main W aR ninG an D inDicato R LiGH ts
Warning lights
Refer to your Owner’s Manual for countermeasures when each warning light comes on.
If necessary, consult your authorized SUBARU dealer.
Seatbelt warning
Remind the driver to fasten
seatbelt.
Front passenger’s seatbelt warning
Remind the front passenger to
fasten seatbelt. Location: next to
overhead console.
Oil pressure warning
The engine oil pressure is too
low.
Engine low oil level warning
The engine oil level decreases to
the lower limit.
All-wheel drive warning (CVT models)
Tires of different diameter fitted/
air pressure excessively low.
SRS airbag system warning
SRS airbag system and/
or seatbelt pretensioners
malfunction.
Power steering warning
The electric power steering
system malfunction.
AT OIL TEMP warning (CVT models)
Transmission fluid temperature
is too hot./Transmission control
system malfunction.
Brake system warning
Electronic parking brake system malfunction/Brake fluid level/EBD System
malfunction (Anti-lock brake system warning light illuminates simultaneously).
Malfunction indicator (Check Engine)
Engine/Emission control system
malfunction.
Charge warning
Charging system malfunction.
Low fuel warning
Fuel tank is nearly empty. Refill
fuel immediately.
High beam assist warning
The high beam assist function
malfunction.

18
Automatic headlight beam leveler warning
Automatic headlight beam leveler malfunction.
Access key warning
The access key is not inside the vehicle. For other situations, refer to your
Owner’s Manual.
ABS warning
Anti-lock Brake System malfunction/EBD System malfunction.
(Brake System warning light illuminates simultaneously).
Windshield washer fluid warning
The fluid level in the windshield washer fluid tank decreases to the lower limit.
BSD/RCTA warning
Blind Spot Detection/Rear Cross Traffic Alert (BSD/RCTA) malfunction.
Vehicle Dynamics Control warning/Vehicle Dynamics Control operation indicator
Warning : Vehicle Dynamics Control system malfunction.
Indicator : Flashes during activation of the skid suppression function and the
traction control function.
Icy road surface warning screen
When the outside temperature becomes 3°C (37°F) or less, the icy road surface
warning screen interrupts to inform the driver that the road surface may be
frozen.
RAB warning
Reverse Automatic Braking System malfunctions.
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

19
indicator lights
The following indicators show the current status of your car. Refer to your Owner’s Manual
for more information.
Turn signal
indicatorHeadlight
indicatorHigh beam
indicator
Front fog light
indicatorSecurity
indicatorDoor open
indicator
BSD/RCTA OFF
indicatorCruise control
indicatorCruise control
set indicator
Electronic parking brake
indicatorSteering responsive fog lights
OFF indicator
Vehicle Dynamics Control OFF
indicatorFront passenger’s frontal
airbag ON/OFF indicator
Hill Holder indicatorHill descent control indicator
X mode indicatorHigh beam assist indicator
RAB OFF indicatorSonar audible alarm OFF
indicator
Lane Departure Warning OFF
indicatorPre-Collision Braking System
OFF indicator